- 您現在的位置：買賣IC網 > PDF目錄11620 > LTC4313CDD-2#PBF (Linear Technology)IC 2WIRE BUS BUFFER 8DFN PDF資料下載
參數資料
| 型號： | LTC4313CDD-2#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 3/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC 2WIRE BUS BUFFER 8DFN |
| 標準包裝： | 121 |
| 類型： | 2線總線緩沖器 |
| Tx/Rx類型： | I²C Logic |
| 電容 - 輸入： | 10pF |
| 電源電壓： | 2.9 V ~ 5.5 V |
| 電流 - 電源： | 8.1mA |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 8-DFN（3x3） |
| 包裝： | 管件 |
LTC4313-1/LTC4313-2/
LTC4313-3
11
4313123f
applicaTions inForMaTion
Live Insertion and Capacitance Buffering Application
Figure5illustratesanapplicationoftheLTC4313thattakes
advantage of the LTC4313’s Hot Swap, capacitance buffer-
ing and precharge features. If the I/O cards were plugged
directly into the backplane without LTC4313 buffers, all of
the backplane and card capacitances would directly add
together, making rise time requirements difficult to meet.
Placing an LTC4313 on the edge of each card isolates the
card capacitance from the backplane. For a given I/O card,
the LTC4313 drives the capacitance of everything on the
card and the devices on backplane must drive only the
small capacitance of the LTC4313 which is < 10pF.
In Figure 5 a staggered connector is used to connect the
LTC4313 to the backplane. VCC and GND are the longest
pins to ensure that the LTC4313 is powered and forcing
a 1V precharge voltage on the medium length SDA and
SCL pins before they contact the backplane. The 1V pre-
charge voltage is applied to the SDA and SCL pins through
200k resistors. Since cards are being plugged into a live
backplane whose SDA and SCL busses could be at any
voltage between 0 and VCC, precharging the LTC4313’s
SDA and SCL pins to 1V minimizes disturbances to the
backplane bus when cards are being plugged in. The low
(<10pF)inputcapacitanceoftheLTC4313alsocontributes
to minimizing bus disturbance as cards are being plugged
in. With ENABLE being the shortest pin and also pulled to
GND by a resistor, the staggered approach provides ad-
ditional time for transients associated with live insertion to
settle before the LTC4313 can be enabled. A 10k or lower
pull-downresistorfromENABLEtoGNDisrecommended.
If a connector is used where all pins are of equal length,
the benefit of the precharge circuit is lost. Also, the
ENABLE signal to the LTC4313 must be held low until all
the transients associated with card insertion into a live
system die out.
Level Translating to Voltages < 2.9V (LTC4313-3 Only)
The LTC4313-3 can be used for level translation to bus
voltages below 2.9V. Since the maximum buffer turn-on
and turn-off voltages are 0.36VCC, the minimum bus
supply voltage is determined by the following equation,
VDD,BUS(MIN) ≥
0.36 VCC
0.7
(4)
in order to meet the VIH = 0.7 VDD,BUS requirement and
not impact the high side noise margin. Users willing to live
with a lower logic high noise margin can level translate
down to 1.4V. An example of voltage level translation from
3.3V to 1.8V is illustrated in Figure 6, where a 3.3V input
voltage bus is translated to a 1.8V output voltage bus.
Tying VCC to 3.3V satisfies Equation 4. A similar voltage
translation can also be performed going from a 3.3V bus
supply on the output side to a 1.8V input if the VCC pin of
the LTC4313-3 is tied to the 3.3V output supply.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4312IDE#PBF | IC MULTIPLEXER 14-DFN |
| VI-J6R-IY-F3 | CONVERTER MOD DC/DC 7.5V 50W |
| D38999/26SD97PN | CONN PLUG 12POS STRAIGHT W/PINS |
| LTC4312CMS#PBF | IC MULTIPLEXER 16-MSOP |
| MS3106A36-52S | CONN PLUG 52POS STRAIGHT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4313CDD-3#PBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4313CDD-3#TRPBF | 功能描述:IC 2WIRE BUS BUFFER 8DFN RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4313CMS8-1#PBF | 功能描述:IC 2WIRE BUS BUFFER 8MSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4313CMS8-1#TRPBF | 功能描述:IC 2WIRE BUS BUFFER 8MSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
| LTC4313CMS8-2#PBF | 功能描述:IC 2WIRE BUS BUFFER 8MSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 信號緩沖器，中繼器，分配器 系列:- 標準包裝:160 系列:- 類型:轉發器 Tx/Rx類型:以太網 延遲時間:- 電容 - 輸入:- 電源電壓:2.37 V ~ 2.63 V 電流 - 電源:60mA 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:托盤 其它名稱:Q5134101 |
發布緊急采購，3分鐘左右您將得到回復。