- 您現在的位置：買賣IC網 > Datasheet目錄42 > LTC4223CDHD-2#PBF (Linear Technology)IC CNTRLR HOT SWAP DUAL 16-DFN Datasheet資料下載
參數資料
| 型號： | LTC4223CDHD-2#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/24頁 |
| 文件大?。?/td> | 290K |
| 描述： | IC CNTRLR HOT SWAP DUAL 16-DFN |
| 標準包裝： | 73 |
| 類型： | 熱交換控制器 |
| 應用： | ATCA，MicroTCA? |
| 內部開關： | 無 |
| 電源電壓： | 2.7 V ~ 6 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 16-DFN（5x4） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
LTC4223-1/LTC4223-2
11
422312f
APPLICATIONS INFORMATION
Several conditions must be met before the external and
internal switches are allowed to turn on. First V
CC
and
the input supplies (12V
IN
, AUXIN) must exceed their
undervoltage lockout thresholds. Next TIMER must be
<0.2V and
?/DIV>
E
?/DIV>
N must be pulled low.
Once these conditions are met, a debounce timing cycle is
initiated when AUXON or 12ON pin is toggled from low to
high. These two control pins turn on/off the 3.3V auxiliary
and 12V supplies. At the end of the debounce cycle, the
ON pins and fault status are checked. If both ON pins are
high and fault is cleared, the 3.3V auxiliary supply starts
up rst followed by the 12V supply. Note that the turn-on
delay for the AUXON and 12ON pins is 15約 and 30約.
Figure 2 shows the two supplies turning on in sequence
after
?/DIV>
E
?/DIV>
N goes low.
By default, the internal pass transistor turns on rst if
both ON pins are high and start-up conditions met. The
output is current limited at 240mA by its internal ACL
ampli er as the load current charging the output capaci-
tor increases. This causes the TIMER to ramp up with a
10糀 pull-up. Normally the AUXOUT voltage exceeds its
power-good threshold before TIMER time-out and then
?/DIV>
A
?/DIV>
U
?/DIV>
X
?/DIV>
P
?/DIV>
G
?/DIV>
O
?/DIV>
O
?/DIV>
D pulls low.
Once AUXOUT signals power is good and the TIMER pin
returns to <0.2V, the external MOSFET is then allowed to
turn on by charging up the GATE with a 10糀 current source
(Figure 2). The voltage at the GATE pin rises with a slope
equal to 10糀/C
G
and the supply inrush current owing
into the load capacitor C
L1
(see Figure 14) is limited to:
I
C
C
礎
INRUSH
L
G
=
1
10
"
The 12V output follows the GATE voltage when the MOSFET
turns on. If the voltage across the current sense resistor
R
S
becomes too high, the inrush current is limited by the
internal current limit circuitry. Once the output, 12V
OUT
exceeds its power-good threshold,
?/DIV>
1
?/DIV>
2
?/DIV>
P
?/DIV>
G
?/DIV>
O
?/DIV>
O
?/DIV>
D also pulls
low.
If only the 12ON pin is high at the end of debounce cycle,
the external MOSFET turns on rst. After that, if AUXON
pulls high, the internal switch turns on only after the 12V
output signals power is good and TIMER <0.2V.
Figure 2. Normal Power-Up Sequence
Table 1. 12V and Auxiliary Supply Turn-Off Conditions
CONDITION
RESULT
CLEARED BY
AUX
12V
AUXON Goes
Low
Turns Off
No Effect AUXON High
12ON Goes Low
No Effect
Turns Off 12ON High
?/DIV>
E
?/DIV>
N Goes High
Turns Off
Turns Off
?/DIV>
E
?/DIV>
N Low
UVLO on V
CC
Turns Off
Turns Off V
CC
> UVLO
UVLO on AUXIN
Turns Off
No Effect AUXIN > UVLO
UVLO on 12V
IN
No Effect
Turns Off 12V
IN
> UVLO
AUX Overcurrent
Fault
Turns Off
Turns Off AUXON and 12ON Low,
?/DIV>
E
?/DIV>
N High-to-Low, UVLO
on V
CC
12V Overcurrent
Fault
No Effect
Turns Off 12ON Low,
?/DIV>
E
?/DIV>
N High-to-
Low, UVLO on V
CC
Thermal
Shutdown
Turns Off
Turns Off AUXON and 12ON Low,
?/DIV>
E
?/DIV>
N High-to-Low, UVLO
on V
CC
, Temperature <
120癈
20ms/DIV
12PGOOD
5V/DIV
EN
5V/DIV
AUXOUT
5V/DIV
TIMER
2V/DIV
12V
OUT
5V/DIV
AUXPGOOD
5V/DIV
422312 F02
相關PDF資料 |
PDF描述 |
|---|---|
| LTC4224IDDB-2#TRPBF | IC CNTRLR HOT SWAP DUAL 10-DFN |
| LTC4225IGN-1#PBF | IC CONTROLLER HOT SWAP 24-SSOP |
| LTC4230CGN#TRPBF | IC CONTRLLR HOT SWAP TRPL 20SSOP |
| LTC4232CDHC#TRPBF | IC CTLR HOT SWAP 5A 16-DFN |
| LTC4240IGN#TRPBF | IC CTRLR HOTSWAP CPCI I2C 28SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4223CDHD-2TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
| LTC4223CGN-1#PBF | 功能描述:IC CNTRLR HOT SWAP DUAL 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4223CGN-1#TRPBF | 功能描述:IC CNTRLR HOT SWAP DUAL 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統，AdvancedTCA ? 系統，高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LTC4223CGN-1PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
| LTC4223CGN-1TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Supply Hot Swap Controller for Advanced Mezzanine Card |
發布緊急采購，3分鐘左右您將得到回復。