- 您現在的位置：買賣IC網 > PDF目錄10689 > LTC2496CUHF#PBF (Linear Technology)IC ADC 16BIT DELTA SIG 38-QFN PDF資料下載
參數資料
| 型號： | LTC2496CUHF#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 17/32頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT DELTA SIG 38-QFN |
| 標準包裝： | 52 |
| 位數： | 16 |
| 采樣率（每秒）： | 6.9 |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 800µW |
| 電壓電源： | 單電源 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 38-QFN（5x7） |
| 包裝： | 管件 |
| 輸入數目和類型： | 16 個單端，雙極；8 個差分，雙極 |
| 產品目錄頁面： | 1348 (CN2011-ZH PDF) |
| 配用： | DC1011A-B-ND - BOARD DELTA SIGMA ADC LTC2496 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC2496
2496fb
applicaTions inForMaTion
When using the LTC2496’s internal oscillator, the input
capacitor array is switched at 123kHz. The effect of the
charge transfer depends on the circuitry driving the in-
put/reference pins. If the total external RC time constant
is less then 580ns the errors introduced by the sampling
process are negligible since complete settling occurs.
Typically,thereferenceinputsaredrivenfromalowimped-
ance source. In this case complete settling occurs even
with large external bypass capacitors. The inputs (CH0 to
CH15, COM), on the other hand, are typically driven from
larger source resistances. Source resistances up to 10k
mayinterfacedirectlytotheLTC2496andsettlecompletely;
however, the addition of external capacitors at the input
terminals in order to filter unwanted noise (anti-aliasing)
results in incomplete settling.
TheLTC2496offerstwomethodsofremovingtheseerrors.
The first is an automatic differential input current cancella-
tion (Easy Drive) and the second is the insertion of buffer
between the MUXOUT and ADCIN pins, thus isolating the
input switching from the source resistance.
Automatic Differential Input Current Cancellation
In applications where the sensor output impedance is
low (up to 10k with no external bypass capacitor or up
to 500
Ω with 0.001F bypass), complete settling of the
input occurs. In this case, no errors are introduced and
direct digitization is possible.
For many applications, the sensor output impedance
combined with external input bypass capacitors produces
RC time constants much greater than the 580ns required
for 1ppm accuracy. For example, a 10k bridge driving a
0.1F capacitor has a time constant an order of magnitude
greater than the required maximum.
The LTC2496 uses a proprietary switching algorithm
that forces the average differential input current to zero
independent of external settling errors. This allows direct
digitization of high impedance sensors without the need
of buffers.
The switching algorithm forces the average input current
on the positive input (IIN+) to be equal to the average input
current in the negative input (IIN–). Over the complete
conversion cycle, the average differential input current
(IIN+ – IIN–) is zero. While the differential input current is
zero, the common mode input current (IIN+ + IIN–)/2 is
proportional to the difference between the common mode
input voltage (VIN(CM)) and the common mode reference
voltage (VREF(CM)).
In applications where the input common mode voltage is
equal to the reference common mode voltage, as in the
case of a balanced bridge, both the differential and com-
mon mode input current are zero. The accuracy of the
converter is not compromised by settling errors.
In applications where the input common mode voltage is
constant but different from the reference common mode
voltage, the differential input current remains zero while
the common mode input current is proportional to the
difference between VIN(CM) and VREF(CM). For a reference
commonmodevoltageof2.5Vandaninputcommonmode
of 1.5V, the common mode input current is approximately
0.74A.Thiscommonmodeinputcurrentdoesnotdegrade
the accuracy if the source impedances tied to IN+ and
IN– are matched. Mismatches in source impedance lead
to a fixed offset error but do not effect the linearity or full
scale reading. A 1% mismatch in a 1k source resistance
leads to a 74V shift in offset voltage.
In applications where the common mode input voltage
varies as a function of the input signal level (single ended
type sensors), the common mode input current varies
proportionally with input voltage. For the case of balanced
inputimpedances,thecommonmodeinputcurrenteffects
are rejected by the large CMRR of the LTC2496, leading
to little degradation in accuracy. Mismatches in source
impedances lead to gain errors proportional to the dif-
ference between the common mode input and common
mode reference. 1% mismatches in 1k source resistances
lead to gain errors on the order of 15ppm. Based on the
stability of the internal sampling capacitors and the ac-
curacy of the internal oscillator, a one-time calibration will
remove this error.
In addition to the input sampling current, the input ESD
protection diodes have a temperature dependent leakage
current. This current, nominally 1nA (±10nA max) results
in a small offset shift. A 1k source resistance will create a
1V typical and a 10V maximum offset voltage.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1711CMS8 | IC COMP R-RINOUT SINGLE 8-MSOP |
| LTC2497CUHF#PBF | IC ADC 16BIT W/PGA 38-QFN |
| LTC1445CS#PBF | IC COMP W/REF LOWPWR QUAD 16SOIC |
| LTC1445CS | IC COMP W/REF LOWPWR QUAD 16SOIC |
| LTC2305IMS#PBF | IC ADC 12BIT I2C 12-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2496IUHF#PBF | 功能描述:IC ADC 16BIT DELTA SIG 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2496IUHF#TRPBF | 功能描述:IC ADC 16BIT DELTA SIG 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2497CUHF#PBF | 功能描述:IC ADC 16BIT W/PGA 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC2497CUHF#TRPBF | 功能描述:IC ADC 16BIT W/PGA 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC2497IUHF#PBF | 功能描述:IC ADC 16BIT W/PGA 38-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
發布緊急采購，3分鐘左右您將得到回復。