- 您現在的位置：買賣IC網 > PDF目錄2005 > LTC2268IUJ-14#TRPBF (Linear Technology)IC ADC 14BIT 125MSPS DUAL 40QFN PDF資料下載
參數資料
| 型號： | LTC2268IUJ-14#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 18/32頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 14BIT 125MSPS DUAL 40QFN |
| 標準包裝： | 2,000 |
| 位數： | 14 |
| 采樣率（每秒）： | 125M |
| 數據接口： | Serial LVDS |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 364mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 40-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 40-QFN（6x6） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 Differential; 2 Single-Ended |
| 配用： | DC1371A-ND - BOARD USB DATA ACQUISITION HS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
LTC2268-14/
LTC2267-14/LTC2266-14
25
22687614fa
Serial data transfer starts when CS is taken low. The data
on the SDI pin is latched at the first 16 rising edges of
SCK. Any SCK rising edges after the first 16 are ignored.
The data transfer ends when CS is taken high again.
The first bit of the 16-bit input word is the R/W bit. The
next seven bits are the address of the register (A6:A0).
The final eight bits are the register data (D7:D0).
If the R/W bit is low, the serial data (D7:D0) will be written
to the register set by the address bits (A6:A0). If the R/W
bit is high, data in the register set by the address bits (A6:
A0) will be read back on the SDO pin (see the Timing Dia-
grams section). During a read back command the register
is not updated and data on SDI is ignored.
applicaTions inForMaTion
The SDO pin is an open-drain output that pulls to ground
with a 200 impedance. If register data is read back
through SDO, an external 2k pull-up resistor is required. If
serial data is only written and read back is not needed, then
SDO can be left floating and no pull-up resistor is needed.
Table 4 shows a map of the mode control registers.
Software Reset
If serial programming is used, the mode control registers
should be programmed as soon as possible after the power
supplies turn on and are stable. The first serial command
mustbeasoftwareresetwhichwillresetallregisterdatabits
to logic 0. To perform a software reset, bit D7 in the reset
register is written with a logic 1. After the reset SPI write
commandiscomplete,bitD7isautomaticallysetbacktozero.
Table 4. Serial Programming Mode Register Map (PAR/SER = GND)
REGISTER A0: RESET REGISTER (ADDRESS 00h)
D7
D6
D5
D4
D3
D2
D1
D0
RESET
X
Bit 7
RESET
Software Reset Bit
0 = Not Used
1 = Software Reset. All Mode Control Registers Are Reset to 00h. The ADC is momentarily placed in SLEEP mode.
This Bit Is Automatically Set Back to Zero at the End of the SPI Write Command.
The Reset Register is Write Only.
Bits 6-0
Unused, Don’t Care Bits.
REGISTER A1: POWER-DOWN REGISTER (ADDRESS 01h)
D7
D6
D5
D4
D3
D2
D1
D0
DCSOFF
RAND
TWOSCOMP
SLEEP
NAP_2
X
NAP_1
Bit 7
DCSOFF
Clock Duty Cycle Stabilizer Bit
0 = Clock Duty Cycle Stabilizer On
1 = Clock Duty Cycle Stabilizer Off. This is Not Recommended.
Bit 6
RAND
Data Output Randomizer Mode Control Bit
0 = Data Output Randomizer Mode Off
1 = Data Output Randomizer Mode On
Bit 5
TWOSCOMP
Two’s Complement Mode Control Bit
0 = Offset Binary Data Format
1 = Two’s Complement Data Format
Bits 4,3,0
SLEEP:NAP_2:NAP_1
Sleep/Nap Mode Control Bits
000 = Normal Operation
0X1 = Channel 1 in Nap Mode
01X = Channel 2 in Nap Mode
1XX = Sleep Mode. Both Channels Are Disabled
Note: Any Combination of Channels Can Be Placed in Nap Mode.
Bits 2,1
Unused, Don’t Care Bits.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2280CUP#PBF | IC ADC DUAL 10BIT 105MSPS 64-QFN |
| LTC2281IUP#PBF | IC ADC 10BIT DUAL 64-QFN |
| LTC2282CUP#PBF | IC ADC DUAL 12BIT 105MSPS 64-QFN |
| LTC2284CUP#PBF | IC ADC DUAL 14BIT 105MSPS 64-QFN |
| LTC2285CUP#PBF | IC ADC DUAL 14BIT 125MSPS 64QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2269 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:16-Bit, 20Msps Low Noise ADC |
| LTC2269CUK#PBF | 制造商:Linear Technology 功能描述:ADC Single 20Msps 16-bit Parallel/Serial (SPI)/LVDS 48-Pin QFN EP 制造商:Linear Technology 功能描述:IC ADC 16BIT 20MSPS 48-QFN 制造商:Linear Technology 功能描述:ADC 16BIT 1.8V 20MSPS 48QF 制造商:Linear Technology 功能描述:ADC, 16BIT, 1.8V, 20MSPS, 48QFN 制造商:Linear Technology 功能描述:ADC, 16BIT, 20MSPS, PARALLEL, SERIAL, QFN-48; Resolution (Bits):16bit; Sampling Rate:20MSPS; Supply Voltage Type:Single; Supply Voltage Min:1.7V; Supply Voltage Max:1.9V; Supply Current:48.9mA; Digital IC Case Style:QFN; DNL:0.2LSB ;RoHS Compliant: Yes |
| LTC2269CUK#TRPBF | 制造商:Linear Technology 功能描述:ADC Single 20Msps 16-bit Parallel/Serial (SPI)/LVDS 48-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC ADC 16BIT 20MSPS 48-QFN |
| LTC2269IUK#PBF | 制造商:Linear Technology 功能描述:ADC Single 20Msps 16-bit Parallel/Serial (SPI)/LVDS 48-Pin QFN EP 制造商:Linear Technology 功能描述:IC ADC 16BIT 20MSPS 48-QFN 制造商:Linear Technology 功能描述:ADC 16BIT 1.8V 20MSPS 48QF 制造商:Linear Technology 功能描述:ADC, 16BIT, 1.8V, 20MSPS, 48QFN 制造商:Linear Technology 功能描述:ADC, 16BIT, 20MSPS, PARALLEL, SERIAL, QFN-48; Resolution (Bits):16bit; Sampling Rate:20MSPS; Supply Voltage Type:Single; Supply Voltage Min:1.7V; Supply Voltage Max:1.9V; Supply Current:48.9mA; Digital IC Case Style:QFN; DNL:0.2LSB ;RoHS Compliant: Yes |
| LTC2269IUK#TRPBF | 制造商:Linear Technology 功能描述:ADC Single 20Msps 16-bit Parallel/Serial (SPI)/LVDS 48-Pin QFN EP T/R 制造商:Linear Technology 功能描述:IC ADC 16BIT 20MSPS 48-QFN |
發布緊急采購，3分鐘左右您將得到回復。