- 您現在的位置：買賣IC網 > Datasheet目錄41 > LT3500HMSE#TRPBF (Linear Technology)IC REG DL BUCK/LINEAR 16-MSOP Datasheet資料下載
參數資料
| 型號： | LT3500HMSE#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 18/28頁 |
| 文件大?。?/td> | 322K |
| 描述： | IC REG DL BUCK/LINEAR 16-MSOP |
| 標準包裝： | 2,500 |
| 拓撲： | 降壓（降壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 500kHz ~ 2.4MHz |
| 電壓/電流 - 輸出 1： | 0.8 V ~ 38.9 V，2A |
| 電壓/電流 - 輸出 2： | 可調式，13mA |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 無 |
| 電源電壓： | 3 V ~ 36 V |
| 工作溫度： | -40°C ~ 150°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TFSOP（0.118"，3.00mm 寬）裸露焊盤 |
| 供應商設備封裝： | 16-MSOP，裸露焊盤 |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT3500
18
3500fc
The boost circuit can also run directly from a DC voltage
that is higher than the input voltage by more than 2.5V, as
in Figure 5d. The diode is used to prevent damage to the
LT3500 in case V
X
is held low while V
IN
is present. The
circuit eliminates a capacitor, but ef ciency may be lower
and dissipation in the LT3500 may be higher. Also, if V
X
is
absent, the LT3500 will still attempt to regulate the output,
but will do so with very low ef ciency and high dissipation
because the switch will not be able to saturate, dropping
1.5V to 2V in conduction.
The minimum input voltage of an LT3500 application is
limited by the minimum operating voltage (<2.8V) and by
the maximum duty cycle as outlined above. For proper
start-up, the minimum input voltage is also limited by
the boost circuit. If the input voltage is ramped slowly, or
the LT3500 is turned on with its SS pin when the output
is already in regulation, then the boost capacitor may not
be fully charged. Because the boost capacitor is charged
with the energy stored in the inductor, the circuit will rely
on some minimum load current to get the boost circuit
running properly. This minimum load will depend on
input and output voltages and on the arrangement of the
boost circuit.
The Typical Performance Characteristics section shows
plots of the minimum load current to start and to run as a
function of input voltage for 3.3V and 5V outputs. In many
cases the discharged output capacitor will present a load
to the switcher which will allow it to start. The plots show
the worst-case situation where V
IN
is ramping very slowly.
Use a Schottky diode for the lowest start-up voltage.
Frequency Compensation
The LT3500 uses current mode control to regulate the
output. This simpli es loop compensation. In particular, the
LT3500 does not require the ESR of the output capacitor
for stability so you are free to use ceramic capacitors to
achieve low output ripple and small circuit size. Frequency
compensation is provided by the components tied to the
V
C
pin. Generally a capacitor and a resistor in series to
ground determine loop gain. In addition, there is a lower
value capacitor in parallel. This capacitor is not part of
the loop compensation but is used to lter noise at the
switching frequency.
Loop compensation determines the stability and transient
performance. Designing the compensation network is a bit
complicated and the best values depend on the application
and in particular the type of output capacitor. A practical
approach is to start with one of the circuits in this data
sheet that is similar to your application and tune the com-
pensation network to optimize the performance. Stability
should then be checked across all operating conditions,
including load current, input voltage and temperature.
The LT1375 data sheet contains a more thorough discus-
sion of loop compensation and describes how to test the
stability using a transient load.
Figure 6 shows an equivalent circuit for the LT3500 control
loop. The error amp is a transconductance ampli er with
nite output impedance. The power section, consisting
of the modulator, power switch, and inductor, is modeled
as a transconductance ampli er generating an output
APPLICATIONS INFORMATION
Figure 6. Model for Loop Response
SW
LT3500
FB
V
C
0.8V
C
F
C
PL
V
OUT1
C1
C1
3500 F06
C
C
R
C
R1
ESR
TANTALUM
OR
POLYMER
CERAMIC
R2
4M
ERROR AMP
g
m
= 250糾hos
CURRENT MODE
POWER STAGE
g
m
= 3mho
相關PDF資料 |
PDF描述 |
|---|---|
| LT3507HUHF#TRPBF | IC REG QD BUCK/LINEAR 38-QFN |
| LT3570IFE#TRPBF | IC REG BUCK/BST/LINEAR 20TSSOP |
| LT3645HMSE#TRPBF | IC REG DL BUCK/LINEAR 12-MSOP |
| LT3694IFE-1#TRPBF | IC REG TRPL BUCK/LINEAR 20TSSOP |
| LT4220IGN#TR | IC CTLR HOTSWAP DUAL 16-SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3500IDD#PBF | 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓撲:降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3500IDD#TRPBF | 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓撲:降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3500IDD-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
| LT3500IDD-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller |
| LT3500IMSE#PBF | 功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓撲:降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
發布緊急采購，3分鐘左右您將得到回復。