- 您現在的位置：買賣IC網 > PDF目錄30766 > LT1952MPGN#PBF (LINEAR TECHNOLOGY CORP) SWITCHING CONTROLLER, 560 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LT1952MPGN#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 560 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, LEAD FREE, PLASTIC, SSOP-16 |
| 文件頁數： | 5/28頁 |
| 文件大?。?/td> | 357K |
| 代理商： | LT1952MPGN#PBF |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT1952/LT1952-1
13
19521fe
Shutdown and Programming Undervoltage Lockout
The LT1952/LT1952-1 have an accurate 1.32V shutdown
threshold at the SD_VSEC pin. This threshold can be
used in conjunction with a resistor divider to define the
undervoltage lockout threshold (UVLO) of the system
input voltage (VS) to the power converter (Figure 3). A pin
current hysteresis (10A before part turn on, 0A after
part turn on) allows UVLO hysteresis to be programmed.
Calculation of the ON/OFF thresholds for the supply (SVIN)
to the power converter can be made as follows:
VS OFF Threshold = 1.32[1 + (R1/R2)]
VS ON Threshold = SVINOFF+(10AR1)
A simple open drain transistor can be added to the resistor
divider network at the SD_VSEC pin to control the turn off
of the LT1952/LT1952-1 (Figure 3).
The SD_VSEC pin must not be left open since there must
be an external source current >10A to lift the pin past its
1.32V threshold for part turn on.
APPLICATIONS INFORMATION
Micropower Start-Up: Selection of Start-Up Resistor
and Capacitor for VIN
The LT1952/LT1952-1 use turn-on voltage hysteresis at
the VIN pin and low start-up current to allow micro-power
start-up (Figure 4). The LT1952/LT1952-1 monitor VIN pin
voltage to allow part turn on at 14.25V (7.75V LT1952-1)
and part turn off at 8.75V (6.5V LT1952-1). Low start-up
OPERATION
Slope Compensation
The current mode architecture requires slope compensa-
tion to be added to the current sensing loop to prevent
subharmonic oscillations which can occur for duty cycles
above 50%. Unlike most current mode converters which
have a slope compensation ramp that is fixed internally,
placing a constraint on inductor value and operating
frequency, the LT1952/LT1952-1 have externally adjust-
able slope compensation. Slope compensation can be
programmed by inserting an external resistor (RSLOPE)
in series with the ISENSE pin. The LT1952/LT1952-1 have
a linear slope compensation ramp which sources current
out of the ISENSE pin of approximately 8A at 0% duty
cycle to 35A at 80% duty cycle.
Overcurrent Detection and Soft-Start (OC Pin)
An added feature to the LT1952/LT1952-1 is a precise
100mV sense threshold at the OC pin used to detect
overcurrent conditions in the converter and set a soft-start
latch. The OC pin is connected directly to the source of
the primary side MOSFET to monitor peak current in the
MOSFET (Figure 7). The 107mV threshold is constant
over the entire duty cycle range of the converter because
it is unaffected by the slope compensation added to the
ISENSE pin.
Synchronizing
A SYNC pin allows the LT1952/LT1952-1 oscillator to be
synchronized to an external clock. The SYNC pin can be
driven from a logic level output, requiring less than 0.8V
for a logic level low and greater than 2.2V for a logic level
high. Duty cycle should run between 10% and 90%. To
avoid loss of slope compensation during synchroniza-
tion, the free running oscillator frequency (fOSC) should
be programmed to 80% of the external clock frequency
(fSYNC).TheRSLOPEresistorchosenfornon-synchronized
operation should be increased by 1.25x (= fSYNC/fOSC).
Figure 3. Programming Undervoltage Lockout (UVLO)
1.32V
SYSTEM
INPUT (VS)
OPTIONAL
SHUTDOWN
TRANSISTOR
1952 F03
SD_VSEC
11A
LT1952/LT1952-1
R1
R2
+
–
OFF
ON
相關PDF資料 |
PDF描述 |
|---|---|
| LT1952MPGN-1#TRPBF | SWITCHING CONTROLLER, 560 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT1952MPGN#TRPBF | SWITCHING CONTROLLER, 560 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3412AIFE | 3 A SWITCHING REGULATOR, 4 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3412AEFE#TRPBF | 3 A SWITCHING REGULATOR, 4 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3412AEUF#TRPBF | 3 A SWITCHING REGULATOR, 4 kHz SWITCHING FREQ-MAX, PQCC16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1956 | 制造商:LINEAR 制造商全稱:LINEAR 功能描述:100V Synchronous Switching Regulator Controller |
| LT1956-5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage, 1.5A, 500kHz Step-Down Switching Regulators |
| LT1956EFE | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1956EFE#PBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT1956EFE#TR | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
發布緊急采購，3分鐘左右您將得到回復。