- 您現在的位置：買賣IC網 > PDF目錄369814 > LPC3180 (NXP Semiconductors N.V.) 16/32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface PDF資料下載
參數資料
| 型號： | LPC3180 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 16/32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface |
| 中文描述： | 16/32位ARM微控制器，硬件的浮點協處理器的USB On - The - Go的，和SDRAM存儲器接口 |
| 文件頁數： | 17/36頁 |
| 文件大?。?/td> | 188K |
| 代理商： | LPC3180 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LPC3180_1
Koninklijke Philips Electronics N.V. 2006. All rights reserved.
Preliminary data sheet
Rev. 01 — 2 June 2006
17 of 36
Philips Semiconductors
LPC3180
16/32-bit ARM microcontroller with external memory interface
devices of 64/128/256/512/1024 Mbit in size, as well as DDR SDRAM devices of
64/128/256/512/1024 Mbit in size. The SDRAM controller uses four data ports to allow
simultaneous requests from multiple on-chip AHB bus masters.
6.7 NAND flash controllers
The LPC3180 includes two NAND flash controllers, one for multi-level NAND flash devices
and one for single-level NAND flash devices. The two NAND flash controllers use the
same pins to interface to external NAND flash devices, so only one interface is active at a
time.
6.7.1
Multi-Level Cell (MLC) NAND flash controller
The MLC NAND flash controller interfaces to either multi-level or single-level NAND flash
devices. An external NAND flash device is used to allow the bootloader to automatically
load a portion of the application code into internal SRAM for execution following reset.
The MLC NAND flash controller supports up to 2 Gbit devices with small (528 byte) or
large (2114 byte) pages. Programmable NAND timing parameters allow support for a
variety of NAND flash devices. A built-in Reed-Solomon encoder/decoder provides error
detection and correction capability. A 528 byte data buffer reduces the need for CPU
supervision during loading. The MLC NAND flash controller also provides DMA support.
6.7.2
Single-Level Cell (SLC) NAND flash controller
The SLC NAND flash controller interfaces to single-level NAND flash devices up to 2 Gbit
in size. DMA page transfers are supported, including a 20 byte DMA read and write FIFO.
Hardware support for ECC (Error Checking and Correction) is included for the main data
area. Software can correct a single bit error.
6.8 DMA controller
The DMA controller allows peripheral-to memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. Each DMA stream
provides unidirectional serial DMA transfers for a single source and destination. For
example, a bidirectional port requires one stream for transmit and one for receives. The
source and destination areas can each be either a memory region or a peripheral, and
can be accessed through the same AHB master or one area by each master.
The DMA controls eight DMA channels with hardware prioritization. The DMA controller
interfaces to the system via two AHB bus masters, each with a full 32-bit data bus width.
DMA operations may be set up for 8-bit, 16-bit, and 32-bit data widths, and can be either
big-endian or little-endian. Incrementing or non-incrementing addressing for source and
destination are supported, as well as programmable DMA burst size. Scatter or gather
DMA is supported through the use of linked lists. This means that the source and
destination areas do not have to occupy contiguous areas of memory.
6.9 Interrupt controller
The interrupt controller is comprised of three basic interrupt controller blocks, supporting a
total of 60 interrupt sources. Each interrupt source can be individually enabled/disabled
and configured for high or low level triggering, or rising or falling edge triggering. Each
interrupt may also be steered to either the FIQ or IRQ input of the ARM9. Raw interrupt
相關PDF資料 |
PDF描述 |
|---|---|
| LPC61W26X | Microcontroller |
| LPC61W49X | Microcontroller |
| LPC660AIMX | Voltage-Feedback Operational Amplifier |
| LPC660IMX | Voltage-Feedback Operational Amplifier |
| LPC661IMX | Voltage-Feedback Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC3180-DEV-KIT | 功能描述:開發板和工具包 - ARM LPC3180 Dev Kit RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| LPC3180FEL320 | 功能描述:IC ARM9 MCU 208MHZ 320-LFBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:LPC3100 產品培訓模塊:CAN Basics Part-1 CAN Basics Part-2 Electromagnetic Noise Reduction Techniques Part 1 M16C Product Overview Part 1 M16C Product Overview Part 2 標準包裝:1 系列:M16C™ M32C/80/87 核心處理器:M32C/80 芯體尺寸:16/32-位 速度:32MHz 連通性:EBI/EMI，I²C，IEBus，IrDA，SIO，UART/USART 外圍設備:DMA，POR，PWM，WDT 輸入/輸出數:121 程序存儲器容量:384KB（384K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:24K x 8 電壓 - 電源 (Vcc/Vdd):3 V ~ 5.5 V 數據轉換器:A/D 34x10b，D/A 2x8b 振蕩器型:內部 工作溫度:-20°C ~ 85°C 封裝/外殼:144-LQFP 包裝:托盤 產品目錄頁面:749 (CN2011-ZH PDF) 配用:R0K330879S001BE-ND - KIT DEV RSK M32C/87 |
| LPC3180FEL320,551 | 功能描述:ARM微控制器 - MCU ARM9 FLTNG PNT CO-PR FLTNG POINT CO-PROC RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC3180FEL320/01 | 制造商:NXP Semiconductors 功能描述:MCU 16-Bit/32-Bit LPC3100 ARM926EJ-S RISC ROMLess 1.2V/1.8V/3.3V 320-Pin LFBGA Tray |
| LPC3180FEL320/01,5 | 功能描述:ARM微控制器 - MCU ARM9 64KRAM VFP USB OTG BGA320 RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。