- 您現在的位置：買賣IC網 > PDF目錄369814 > LPC2888 (NXP Semiconductors N.V.) 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface PDF資料下載
參數資料
| 型號： | LPC2888 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| 中文描述： | 16/32位ARM微控制器; 8 KB的高速緩存，高達1 MB閃存，高速USB 2.0設備，SDRAM存儲器接口 |
| 文件頁數： | 23/34頁 |
| 文件大小： | 139K |
| 代理商： | LPC2888 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
LPC2880_LPC2888_1
Koninklijke Philips Electronics N.V. 2006. All rights reserved.
Preliminary data sheet
Rev. 01 — 22 June 2006
23 of 34
Philips Semiconductors
LPC2880; LPC2888
16/32-bit ARM microcontrollers with external memory interface
Supports polling the busy flag from the LCD controller to avoid CPU polling.
Contains a 16 B FIFO for sending control and data information to the LCD controller.
Contains a serial interface which uses the same FIFO for serial transmissions.
Supports FIFO level flow control to the General Purpose DMA controller.
6.20 Clocking and power control
Clocking in the LPC2880/LPC2888 is controlled by a versatile Clock Generation Unit
(CGU), so that system and peripheral requirements may be met, while allowing
optimization of power consumption. Clocks to most functions may be turned off if not
needed, and may be enabled and disabled by selected events through the Event Router.
Clock sources include a high frequency (1 MHz to 20 MHz) crystal oscillator and a 32 kHz
RTC oscillator. Higher frequency clocks may be generated through the use of two
programmable PLLs.
Reset of individual functional blocks is also controlled by the CGU. Full chip reset can be
initiated by the external reset pin or by the watchdog timer.
6.20.1
Features
Power and performance control provided by versatile clock generation to individual
functional blocks.
Multiple clock sources including external crystal and programmable PLLs.
Watchdog timer to monitor software integrity.
Individual control of software reset to many functional blocks.
Lower speed peripherals are connected to an APB bus for lower power consumption.
6.20.2
Reset
The LPC2880/LPC2888 has two sources of reset: the RESET_N pin and the watchdog
reset. The RESET pin includes an on-chip pull-up. The RESET_N pin must remain
asserted at power-up for 1 ms after power supply voltages are stable. This includes
on-chip DC-to-DC converter voltages.
When a chip reset is removed, the processor begins executing at address 0, which is the
Reset vector. At that point, all of the processor and peripheral registers have been
initialized to predetermined values.
The on-chip watchdog timer can cause a chip reset if not updated within a user
programmable amount of time. A status register allows software to determine if a chip
reset was caused by the watchdog timer. The watchdog timer can also be configured to
generate an interrupt if desired.
Software reset of many individual functional blocks may be performed via registers within
the CGU.
6.20.3
Crystal oscillator
The main oscillator is the basis for the clocks most chip functions use by default. The
oscillator may be used with crystal frequencies from 1 MHz to 20 MHz.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2888FET180 | 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| LPC2917 | ARM9 microcontroller with CAN and LIN |
| LPC2919 | ARM9 microcontroller with CAN and LIN |
| LPC3180 | 16/32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface |
| LPC61W26X | Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2888FET180 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| LPC2888FET180,551 | 功能描述:ARM微控制器 - MCU ARM7 1MF/64KR/USBH RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2888FET180/01 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| LPC2888FET180/01,5 | 功能描述:ARM微控制器 - MCU 16/32 bit micro RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2888FET180/D,55 | 制造商:NXP Semiconductors 功能描述:PHALPC2888FET180/D.551 32BIT ARM7 HS USB |
發布緊急采購，3分鐘左右您將得到回復。