- 您現在的位置：買賣IC網 > PDF目錄369814 > LPC2888 (NXP Semiconductors N.V.) 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface PDF資料下載
參數資料
| 型號： | LPC2888 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| 中文描述： | 16/32位ARM微控制器; 8 KB的高速緩存，高達1 MB閃存，高速USB 2.0設備，SDRAM存儲器接口 |
| 文件頁數： | 21/34頁 |
| 文件大?。?/td> | 139K |
| 代理商： | LPC2888 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
LPC2880_LPC2888_1
Koninklijke Philips Electronics N.V. 2006. All rights reserved.
Preliminary data sheet
Rev. 01 — 22 June 2006
21 of 34
Philips Semiconductors
LPC2880; LPC2888
16/32-bit ARM microcontrollers with external memory interface
Power-down mode.
Measurement range 0 V to 3.3 V.
10-bit conversion time
≥
2.44
μ
s.
Single or continuous conversion mode.
6.16 Analog I/O
The analog I/O system includes an I
2
S input channel, an I
2
S output channel, a dual A/D
converter, and a dual D/A converter. Each channel includes a separate 4 sample FIFO.
Each of the two ADC inputs includes a Programmable Gain Amplifier (PGA). A separate
input, which can be routed to either ADC, also include an additional Low Noise Amplifier
(LNA).
Each DAC has associated pins for unbuffered and amplified outputs.
6.16.1
Features
I
2
S-bus input channel with a 4 sample FIFO for stereo Digital Analog Input (DAI).
I
2
S-bus output channel with a 4 sample FIFO for stereo Digital Analog Output (DAO).
Dual 16-bit A/D converters with individual inputs routed through programmable gain
amplifiers. Each ADC can alternatively take its input from a single pin that includes an
additional low noise amplifier. Input takes place through a 4 sample FIFO.
Dual 16-bit D/A converters. Each DAC includes both a direct output and an amplified
output. Output takes place through a 4 sample FIFO.
6.17 USB 2.0 high-speed device controller
The USB is a 4 wire bus that supports communication between a host and a number (127
max.) of peripherals. The host controller allocates the USB bandwidth to attached devices
through a token based protocol. The bus supports hot plugging, un-plugging and dynamic
configuration of the devices. All transactions are initiated by the host controller.
The host schedules transactions in 1 ms frames. Each frame contains an SoF marker and
transactions that transfer data to/from device endpoints. Each device can have a
maximum of 16 logical or 32 physical endpoints. There are 4 types of transfers defined for
the endpoints. Control transfers are used to configure the device. Interrupt transfers are
used for periodic data transfer. Bulk transfers are used when rate of transfer is not critical.
Isochronous transfers have guaranteed delivery time but no error correction.
The LPC2880/LPC2888 USB controller enables 480 Mbit/s or 12 Mbit/s data exchange
with a USB host controller. It includes a USB controller, a DMA engine, and a USB 2.0
ATX physical interface.
The USB controller consists of the protocol engine and buffer management blocks. It
includes an SRAM that is accessible to the DMA engine and to the processor via the
register interface.
The DMA engine is an AHB master, having direct access to all ARM memory space but
particularly to on-chip RAM. Each USB endpoint that requires its data to be transferred via
DMA is allocated to a logical DMA channel in the DMA engine.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2888FET180 | 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| LPC2917 | ARM9 microcontroller with CAN and LIN |
| LPC2919 | ARM9 microcontroller with CAN and LIN |
| LPC3180 | 16/32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface |
| LPC61W26X | Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2888FET180 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| LPC2888FET180,551 | 功能描述:ARM微控制器 - MCU ARM7 1MF/64KR/USBH RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2888FET180/01 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface |
| LPC2888FET180/01,5 | 功能描述:ARM微控制器 - MCU 16/32 bit micro RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2888FET180/D,55 | 制造商:NXP Semiconductors 功能描述:PHALPC2888FET180/D.551 32BIT ARM7 HS USB |
發布緊急采購，3分鐘左右您將得到回復。