- 您現在的位置：買賣IC網 > PDF目錄385497 > LPC2210FBD144 (NXP Semiconductors N.V.) 16-32-bit ARM microcontrollers; flashless, with 10-bit ADC and external memory interface PDF資料下載
參數資料
| 型號： | LPC2210FBD144 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 數學處理器 |
| 英文描述： | 16-32-bit ARM microcontrollers; flashless, with 10-bit ADC and external memory interface |
| 中文描述： | 16/32位的ARM微控制器；閃存less，10位ADC和外部存儲器接口 |
| 封裝： | LPC2210FBD144/01<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486-1.html<1<Always Pb-free,;LPC2220FBD144<SOT486-1 (LQFP144)|<<http://www.nxp.com/packages/SOT486-1. |
| 文件頁數： | 28/50頁 |
| 文件大?。?/td> | 259K |
| 代理商： | LPC2210FBD144 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
LPC2210_2220_6
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 06 — 11 December 2008
28 of 50
NXP Semiconductors
LPC2210/2220
16/32-bit ARM microcontrollers
controlled PWM outputs require only one match register each, since the repetition rate is
the same for all PWM outputs. Multiple single edge controlled PWM outputs will all have a
rising edge at the beginning of each PWM cycle, when an MR0 match occurs.
Three match registers can be used to provide a PWM output with both edges controlled.
Again, the MR0 match register controls the PWM cycle rate. The other match registers
control the two PWM edge positions. Additional double edge controlled PWM outputs
require only two match registers each, since the repetition rate is the same for all PWM
outputs.
With double edge controlled PWM outputs, specific match registers control the rising and
falling edge of the output. This allows both positive going PWM pulses (when the rising
edge occurs prior to the falling edge), and negative going PWM pulses (when the falling
edge occurs prior to the rising edge).
6.19.1
Features
Seven match registers allow up to six single edge controlled or three double edge
controlled PWM outputs, or a mix of both types.
The match registers also allow:
–
Continuous operation with optional interrupt generation on match.
–
Stop timer on match with optional interrupt generation.
–
Reset timer on match with optional interrupt generation.
Supports single edge controlled and/or double edge controlled PWM outputs. Single
edge controlled PWM outputs all go HIGH at the beginning of each cycle unless the
output is a constant LOW. Double edge controlled PWM outputs can have either edge
occur at any position within a cycle. This allows for both positive going and negative
going pulses.
Pulse period and width can be any number of timer counts. This allows complete
flexibility in the trade-off between resolution and repetition rate. All PWM outputs will
occur at the same repetition rate.
Double edge controlled PWM outputs can be programmed to be either positive going
or negative going pulses.
Match register updates are synchronized with pulse outputs to prevent generation of
erroneous pulses. Software must ‘release’ new match values before they can become
effective.
May be used as a standard timer if the PWM mode is not enabled.
A 32-bit timer/counter with a programmable 32-bit prescaler.
6.20 System control
6.20.1
Crystal oscillator
The oscillator supports crystals in the range of 1 MHz to 25 MHz and up to 25 MHz with
the external oscillator. The oscillator output frequency is called f
osc
and the ARM
processor clock frequency is referred to as CCLK for purposes of rate equations, etc. f
osc
and CCLK are the same value unless the PLL is running and connected. Refer to
Section
6.20.2 “PLL”
for additional information.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2220FET144 | 16-32-bit ARM microcontrollers; flashless, with 10-bit ADC and external memory interface |
| LPC2212FBD144 | Single-chip 16-32-bit ARM microcontrollers; 128-256 kB ISP-IAP flash with 10-bit ADC and external memory interface |
| LPC2214FBD144 | Single-chip 16-32-bit ARM microcontrollers; 128-256 kB ISP-IAP flash with 10-bit ADC and external memory interface |
| LPC2290FBD144 | 16-32-bit ARM microcontroller with CAN, 10-bit ADC and external memory interface |
| LPC2292FBD144 | 16-32-bit ARM microcontrollers; 256 kB ISP-IAP flash with CAN, 10-bit ADC and external memory interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2210FBD144,551 | 功能描述:ARM微控制器 - MCU RLESS/16K RAM/10B ADC/EXT BUS RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2210FBD144/01 | 制造商:NXP Semiconductors 功能描述:Microcontroller,LPC2210FBD144/01 75 MHz |
| LPC2210FBD144/01,5 | 功能描述:ARM微控制器 - MCU ARM7 16KR/10BADC ROMLESS RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2210FBD144551 | 制造商:NXP Semiconductors 功能描述:IC 16/32BIT MCU ARM7 SMD LPC2210 |
| LPC2212 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 128/256 kB ISP/IAP Flash with 10-bit ADC and external memory interface |
發布緊急采購，3分鐘左右您將得到回復。