- 您現在的位置：買賣IC網 > PDF目錄377657 > LPC11C12FBD48 (NXP Semiconductors N.V.) Cortex-M0 with 16 kB flash, 8 kB SRAM, CAN and CANopen drivers on-chip PDF資料下載
參數資料
| 型號： | LPC11C12FBD48 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 32位微控制器 |
| 英文描述： | Cortex-M0 with 16 kB flash, 8 kB SRAM, CAN and CANopen drivers on-chip |
| 中文描述： | Cortex-M0,16KB閃存，8 KB靜態隨機存儲器，CAN和CANopen片上驅動 |
| 封裝： | LPC11C12FBD48/301<SOT313-2 (LQFP48)|<<http://www.nxp.com/packages/SOT313-2.html<1<Always Pb-free,; |
| 文件頁數： | 50/62頁 |
| 文件大?。?/td> | 487K |
| 代理商： | LPC11C12FBD48 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁
LPC11CX2_CX4
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 3 — 27 June 2011
50 of 62
NXP Semiconductors
LPC11Cx2/Cx4
32-bit ARM Cortex-M0 microcontroller
11. Application information
11.1 ADC usage notes
The following guidelines show how to increase the performance of the ADC in a noisy
environment beyond the ADC specifications listed in
Table 7
:
The ADC input trace must be short and as close as possible to the LPC11Cx2/Cx4
chip.
The ADC input traces must be shielded from fast switching digital signals and noisy
power supply lines.
Because the ADC and the digital core share the same power supply, the power supply
line must be adequately filtered.
To improve the ADC performance in a very noisy environment, put the device in Sleep
mode during the ADC conversion.
11.2 XTAL input
The input voltage to the on-chip oscillators is limited to 1.8 V. If the oscillator is driven by a
clock in slave mode, it is recommended that the input be coupled through a capacitor with
C
i
= 100 pF. To limit the input voltage to the specified range, choose an additional
capacitor to ground C
g
which attenuates the input voltage by a factor C
i
/(C
i
+ C
g
). In slave
mode, a minimum of 200 mv (RMS) is needed.
In slave mode the input clock signal should be coupled by means of a capacitor of 100 pF
(
Figure 23
), with an amplitude between 200 mv (RMS) and 1000 mv (RMS). This
corresponds to a square wave signal with a signal swing of between 280 mV and 1.4 V.
The XTALOUT pin in this configuration can be left unconnected.
External components and models used in oscillation mode are shown in
Figure 24
and in
Table 19
and
Table 20
. Since the feedback resistance is integrated on chip, only a crystal
and the capacitances C
X1
and C
X2
need to be connected externally in case of
fundamental mode oscillation (the fundamental frequency is represented by L, C
L
and
R
S
). Capacitance C
P
in
Figure 24
represents the parallel package capacitance and should
not be larger than 7 pF. Parameters F
OSC
, C
L
, R
S
and C
P
are supplied by the crystal
manufacturer (see
Table 19
).
Fig 23. Slave mode operation of the on-chip oscillator
LPC1xxx
XTALIN
Ci
100 pF
Cg
002aae788
相關PDF資料 |
PDF描述 |
|---|---|
| LPC11D14FBD100 | 32-bit ARM Cortex-M0 microcontroller; 32 kB flash and 8 kB SRAM; 4 x 40 segment LCD driver |
| LPC11U12FBD48 | 32-bit ARM Cortex-M0 microcontroller; up to 16 kB flash; 6 kB SRAM; USB device; USART; 2 SSPs |
| LPCXpresso | |
| LPD-1 | Phase Detectors 1000mV DC output , + 7dBmRF |
| LPDA-8003 | LPDA-8003 Log Periodic Dipole Antenna |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC11C12FBD48/301 | 功能描述:ARM微控制器 - MCU 32-bit Cortex M0 16KB 8K RAM CAN RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC11C12FBD48/301, | 功能描述:ARM微控制器 - MCU 32b 16K Flash 40I/O RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC11C12FBD48/301,15 | 制造商:NXP Semiconductors 功能描述:Bulk |
| LPC11C12FBD48-301 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; 16/32 kB flash, 8 kB SRAM; C_CAN |
| LPC11C14FB301 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; 16/32 kB flash, 8 kB SRAM C_CAN |
發布緊急采購，3分鐘左右您將得到回復。