參數資料
型號: LM4550VHX/NOPB
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 消費家電
英文描述: SPECIALTY CONSUMER CIRCUIT, PQFP48
封裝: 7 X 7 X 1.40 MM, LQFP-48
文件頁數: 4/30頁
文件大?。?/td> 611K
代理商: LM4550VHX/NOPB
Pin Descriptions (Continued)
ANALOG I/O (Continued)
Name
Pin
I / O
Functional Description
HP_OUT_L
39
O
Left Stereo Channel Output
This line level output (1 Vrms nominal) is fed from the left channel of the Stereo Mix signal
from MIX2 via the Headphone Volume register, 04h. The HP_OUT_L amplitude can be muted
(along with HP_OUT_R) or adjusted from 0 dB to - 46.5 dB in 1.5 dB steps
HP_OUT_C
40
I
AC Ground Reference
In normal use, this input is the AC ground reference for HP_OUT_L and HP_OUT_R. It must
be capacitively coupled to analog ground with short traces to maximize performance. It is
NOT a DC ground.
For non-stereo applications it may also be used to provide common-mode feedback with
HP_OUT configured as one differential output rather than as outputs for two single-ended
stereo channels.
HP_OUT_R
41
O
Right Stereo Channel Output
This line level output (1 Vrms nominal) is fed from the right channel of the Stereo Mix signal
from MIX2 via the Headphone Volume register, 04h. The HP_OUT_R amplitude can be muted
(along with HP_OUT_L) or adjusted from 0 dB to - 46.5 dB in 1.5 dB steps
DIGITAL I/O AND CLOCKING
Name
Pin
I / O
Functional Description
XTL_IN
2
I
24.576 MHz crystal or external oscillator input
To complete the oscillator circuit use a fundamental mode crystal operating in parallel
resonance and connect a 1M
resistor across pins 2 and 3. Choose the load capacitors
(Figure 2, C1, C2) to suit the load capacitance required by the crystal (e.g. C1=C2=33pF
for a 20 pF crystal. Assumes that each ’Input + trace’ capacitance is 7 pF).
This pin may also be used as the input for an external oscillator (24.576 MHz nominal) at
standard logic levels (V
IH,VIL).
This pin is only used when the codec is in Primary mode. It may be left open (NC) for any
Secondary mode.
XTL_OUT
3
O
24.576 MHz crystal output
Used with XTAL_IN to configure a crystal oscillator.
When the codec is used with an external oscillator this pin should be left open (NC).
When the codec is configured in a Secondary mode this pin is not used and may be left open
(NC).
SDATA_OUT
5
I
Input to codec
This is the input for AC Link Output Frames from an AC ’97 Digital Audio Controller to the
LM4550 codec. These frames can contain both control data and DAC PCM audio data. This
input is sampled by the LM4550 on the falling edge of BIT_CLK.
BIT_CLK
6
I/O
AC Link clock
An OUTPUT when in Primary Codec mode. This pin provides a 12.288 MHz clock for the AC
Link. The clock is derived (internally divided by two) from the 24.576 MHz signal at the crystal
input (XTL_IN).
This pin is an INPUT when the codec is configured in any of the Secondary Codec modes
and would normally use the AC Link clock generated by a Primary Codec.
SDATA_IN
8
O
Output from codec
This is the output for AC Link Input Frames from the LM4550 codec to an AC ’97 Digital
Audio Controller. These frames can contain both codec status data and PCM audio data from
the ADCs. The LM4550 clocks data from this output on the rising edge of BIT_CLK.
LM4550
www.national.com
12
相關PDF資料
PDF描述
LM4560VJG SPECIALTY CONSUMER CIRCUIT, PQFP100
LM4651N/NOPB 170 W, 1 CHANNEL, AUDIO AMPLIFIER, PDIP28
LM4652TF/NOPB 170 W, 1 CHANNEL, AUDIO AMPLIFIER, PZFM15
LM4663MT/NOPB 2.1 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24
LM4663MTX/NOPB 2.1 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO24
相關代理商/技術參數
參數描述
LM4558 制造商:HTC 制造商全稱:HTC Korea TAEJIN Technology Co. 功能描述:DUAL OPERATIONAL AMPLIFIERS
LM4558_08 制造商:HTC 制造商全稱:HTC Korea TAEJIN Technology Co. 功能描述:DUAL OPERATIONAL AMPLIFIERS
LM4558D 制造商:HTC 制造商全稱:HTC Korea TAEJIN Technology Co. 功能描述:DUAL OPERATIONAL AMPLIFIERS
LM4558N 制造商:TGS 制造商全稱:Tiger Electronic Co.,Ltd 功能描述:DUAL OPERATIONER AMPLIFIER
LM4558S 制造商:TGS 制造商全稱:Tiger Electronic Co.,Ltd 功能描述:DUAL OPERATIONER AMPLIFIER