- 您現在的位置：買賣IC網 > PDF目錄358759 > LC72322N (Sanyo Electric Co.,Ltd.) Single-Chip Microcontroller with Built-in LCD Driver and PLL Circuits(用于電子調諧的單片微控制器（帶內置LCD驅動器和鎖相環電路 ）) PDF資料下載
參數資料
| 型號： | LC72322N |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | Single-Chip Microcontroller with Built-in LCD Driver and PLL Circuits(用于電子調諧的單片微控制器（帶內置LCD驅動器和鎖相環電路 ）) |
| 中文描述： | 單片微控制器，帶有內置LCD驅動器和PLL電路（用于電子調諧的單片微控制器（帶內置液晶顯示驅動器和鎖相環電路）） |
| 文件頁數： | 8/13頁 |
| 文件大?。?/td> | 202K |
| 代理商： | LC72322N |
Continued from preceding page.
Pin No.
Pin
Description
I/O
I/O circuit
PH0
PH1/BEEP
*
1
PH2/DAC1
*
2
PH3/DAC2
*
2
10
9
8
7
Output
Output-only port.
Since these ports are high-voltage handling n-channel
transistor open-drain outputs, they are effective for use
in band power supply switching. Note that PH1, PH2,
and PH3 have shared functions as the BEEP
*
1
, DAC1,
and DAC2 outputs, respectively.
*
2
This port goes to the
high-impedance state in backup mode and after a reset
(when the RES pin is set low).
No. 5945-8/13
LC72321N, 72322N, 72323N
PI0/S25
PI1/S26
PI2/S27
PI3/S28
39
38
37
36
Output
Output-only port.
These pins are CMOS outputs, but can be switched to
function as LCD driver outputs. The SS and RS
instructions are used to switch the port function. The
port function cannot be switched in single pin units.
The LCD driver function is selected and a display off
signal is output when RES is low and when power is
first applied. In backup mode the output is held at the
low level.
Note that when use as a general-purpose port is
specified as an option, the contents of IPORT are
output when LPC is 1, and the contents of the general-
purpose output port latch is are output when LPC is 0.
S1 to S24
63 to 40
Output
LCD driver segment outputs.
The fame frequency is 100 Hz.
The drive type is 1/2-duty 1/2-bias drive.
A display off signal is output when RES is low and when
power is first applied.
In backup mode the outputs are held at the low level.
An option is available that allows these pins to be used
as general-purpose outputs.
COM1
COM2
65
64
Output
LCD driver common outputs.
The drive type is 1/2-duty 1/2-bias drive.
These pins output the same signal as is output during
normal operation when RES is low and when power is
first applied.
In backup mode these outputs are held at the low level.
FM IN
74
Input
FM VCO (local oscillator) input.
Input must be supplied through a coupling capacitor.
The input frequency range is 10 to 130 MHz.
AM IN
75
AM VCO (local oscillator) input.
Input must be supplied through a coupling capacitor.
The pin frequency band can be selected with the PLL
instruction CW1 bit.
High (2 to 40 MHz)
→
SW
Low (0.5 to 10 MHz)
→
LW and MW
Continued on next page.
Notes:
*
1. Only supported by the LC72321N
*
2. Only supported by the LC72321N and LC72322N
相關PDF資料 |
PDF描述 |
|---|---|
| LC72322 | Single-Chip Microcontroller with PLL and LCD Driver |
| LC72323-XXXX | LED RED/AMBR DIFFUSED(WHITE)RND |
| LC72323 | Single-Chip Microcontroller with PLL and LCD Driver |
| LC72323R | Single-Chip Microcontroller with PLL and LCD Driver |
| LC7232N | CLAMP, CAPACITOR; Centres, fixing:57mm; Diameter, clip:40mm; Length / Height, external:14mm RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LC72322R | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip Microcontroller with PLL and LCD Driver |
| LC72323 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip Microcontroller with PLL and LCD Driver |
| LC72323N | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:LC72321N |
| LC72323R | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Single-Chip Microcontroller with PLL and LCD Driver |
| LC72323-XXX | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。