- 您現在的位置：買賣IC網 > PDF目錄11595 > KSZ8851-16MLLI (Micrel Inc)IC MAC CTLR 1PORT W/BUS 48-TQFP PDF資料下載
參數資料
| 型號： | KSZ8851-16MLLI |
| 廠商： | Micrel Inc |
| 文件頁數： | 15/84頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MAC CTLR 1PORT W/BUS 48-TQFP |
| 標準包裝： | 250 |
| 控制器類型： | 以太網控制器，MAC/PHY |
| 接口： | 總線 |
| 電源電壓： | 1.8V，2.5V，3.3V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1081 (CN2011-ZH PDF) |
| 其它名稱： | 576-3505 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Micrel, Inc.
KSZ8851-16MLL/MLLI
March 11, 2014
22
Revision 2.2
On the transmit side, the KSZ8851-16MLL has intelligent and efficient ways to determine when to invoke flow control. The
flow control is based on availability of the system resources.
There are three programmable low watermark register FCLWR (0xB0), high watermark register FCHWR (0xB2) and
overrun watermark register FCOWR (0xB4) for flow control in RXQ FIFO. The KSZ8851-16MLL will send PAUSE frame
when the RXQ buffer hit the high watermark level (default 3.072KByte available) and stop PAUSE frame when the RXQ
buffer hit the low watermark level (default 5.12KByte available). The KSZ8851-16MLL will drop packet when the RXQ
buffer hit the overrun watermark level (default 256-Byte available).
The KSZ8851-16MLL issues a flow control frame (Xoff, or transmitter off), containing the maximum pause time defined in
IEEE standard 802.3x. Once the resource is freed up, the KSZ8851-16MLL sends out the another flow control frame
(Xon, or transmitter on) with zero pause time to turn off the flow control (turn on transmission to the port). A hysteresis
feature is provided to prevent the flow control mechanism from being constantly activated and deactivated.
Half-Duplex Backpressure
A half-duplex backpressure option (non-IEEE 802.3 standards) is also provided. The activation and deactivation
conditions are the same as in full-duplex mode. If backpressure is required, the KSZ8851-16MLL sends preambles to
defer the other stations' transmission (carrier sense deference).
To avoid jabber and excessive deference (as defined in the 802.3 standard), after a certain time, the KSZ8851-16MLL
discontinues the carrier sense backpressure and then raises it again quickly. This short silent time (no carrier sense)
prevents other stations from sending out packets thus keeping other stations in a carrier sense deferred state. The short
silent time is about 4us and repeat every 1.64ms in the backpressure jam patter for 10Base-T. If the port has packets to
send during a backpressure situation, the carrier sense type backpressure is interrupted and those packets are
transmitted instead. If there are no additional packets to send, carrier sense type backpressure is reactivated again until
chip resources free up. If a collision occurs, the binary exponential back-off algorithm is skipped and carrier sense is
generated immediately, thus reducing the chance of further collision and carrier sense is maintained to prevent packet
reception.
Address Filtering Function
The KSZ8851-16MLL supports 11 different address filtering schemes as shown in the following Table 3. The Ethernet
destination address (DA) field inside the packet is the first 6-byte field which uses to compare with either the host MAC
address registers (0x10 – 0x15) or the MAC address hash table registers (0xA0 – 0xA7) for address filtering operation.
The first bit (bit 40) of the destination address (DA) in the Ethernet packet decides whether this is a physical address if bit
40 is “0” or a multicast address if bit 40 is “1”.
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8851-16MLL | IC CTLR MAC/PHY NON-PCI 48-LQFP |
| KSZ8873RLL | IC ETHERNET SWITCH 3PORT 64-LQFP |
| KSZ8851-16MQLI | IC CTLR MAC/PHY NON-PCI 128-PQFP |
| KSZ8851-16MQL | IC CTLR MAC/PHY NON-PCI 128-PQFP |
| LTC4278CDKD#PBF | IC PD IEEE 802.3AT 25.5W 32-DFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8851-16MLLI TR | 功能描述:以太網 IC 10/100BT Ethernet MAC + PHY with Generic (8, 16-bit) Bus Interface (I-Temp, Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8851-16MLLJ | 功能描述:以太網 IC Single-Port Ethernet MAC Controller with 8/16-Bit Non-PCI Interface (125C support) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8851-16MLLJ_10 | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:Single-Port Ethernet MAC Controller with 8-Bit or 16-Bit Non-PCI Interface |
| KSZ8851-16MLLU | 功能描述:以太網 IC Single-Port Ethernet Controller (Automotive Grade) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8851-16MLLU TR | 功能描述:以太網 IC Single-Port Ethernet Controller (Automotive Grade) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。