- 您現在的位置：買賣IC網 > PDF目錄2001 > ISL51002CQZ-110 (Intersil)IC FRONT END 10BIT VID 128-MQFP PDF資料下載
參數資料
| 型號： | ISL51002CQZ-110 |
| 廠商： | Intersil |
| 文件頁數： | 18/33頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FRONT END 10BIT VID 128-MQFP |
| 標準包裝： | 66 |
| 位數： | 10 |
| 通道數： | 3 |
| 功率（瓦特）： | 1.2W |
| 電壓 - 電源，模擬： | 1.8V，3.3V |
| 電壓 - 電源，數字： | 1.8V，3.3V |
| 封裝/外殼： | 128-BFQFP |
| 供應商設備封裝： | 128-MQFP（14x20） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
25
FN6164.3
February 29, 2012
SOG
For component YPbPr signals, the sync signal is embedded
on the Y-Channel’s video, which is connected to the green
input, hence the name SOG (Sync on Green). The horizontal
sync information is encoded onto the video input by adding
the sync tip during the blanking interval. The sync tip level is
typically 0.3V below the video black level.
To minimize the loading on the green channel, the SOG input
for each of the green channels should be AC-coupled to the
ISL51002 through a series combination of a 10nF capacitor
and a 500
Ω resistor.
SOG Slicer (Figure 2)
The SOG input has programmable threshold, 40mV of
hysteresis, and an optional low pass filter than can be used
to remove high frequency video spikes (generated by
overzealous video peaking in a DVD player, for example)
that can cause false SOG triggers. The SOG threshold sets
the comparator threshold relative to the sync tip (the bottom
of the SOG pulse).
Inside the ISL51002, a 1A pull-down ensures that each sync
tip triggers the clamp circuit causing the tip to be clamped to a
600mV level. A comparator compares the SOG signal with an
internal 4-bit programmable threshold level reference ranging
from 0mV to 300mV above the sync clamp level. The SOG
threshold level, hysteresis, and low-pass filter is programmed
via registers 0x30and 0x31. If the Sync-On-Green function is
not needed, the SOGIN pin(s) may be left unconnected.
SYNC Processing
The ISL51002 can process sync signals from 3 different
sources: discrete HSYNC and VSYNC, composite sync on
the HSYNC input, or composite sync from a Sync-On-Green
(SOG) signal embedded on the Green video input. The
ISL51002 has SYNC activity detect functions to help the
firmware determine which sync source is available.
Macrovision
The ISL51002 automatically detects the presence of
Macrovision-encoded video. When Macrovision is detected,
it generates a mask signal that is ANDed with the incoming
SOG CSYNC signal to remove the Macrovision before the
HSYNC goes to the PLL. No additional programming is
required to support Macrovision.
The mask signal is also applied to the HSYNCOUT signal.
When Sync Mask Disable = 0, any Macrovision present on
the incoming sync will not be visible on HSYNCOUT. If the
application requires the Macrovision pulses to be visible on
HSYNCOUT, set the HSYNCOUT Mask Disable bit (register
0x7A-bit 4).
Headswitching from Analog Videotape Signals
Occasionally this AFE may be used to digitize signals
coming from analog videotape sources. The most common
example of this is a Digital VCR (which for best signal quality
would be connected to this AFE with a component YPbPr
connection). If the digital VCR is playing an older analog
VHS tape, the sync signals from the VCR may contain the
worst of the traditional analog tape artifacts: headswitching.
Headswitching is traditionally the enemy of PLLs with large
capture ranges, because a headswitch can cause the
HSYNC period to change by as much as ±90%. To the PLL,
this can look like a frequency change of -50% to +900%,
causing errors in the output frequency (and obviously the
phase) to change. Subsequent HSYNCs have the correct,
original period, but most analog PLLs will take dozens of
lines to settle back to the correct frequency and phase after
a headswitch disturbance. This causes the top of the image
to “tear” during normal playback. In “trick modes” (fast
forward and rewind), the HSYNC signal has multiple
headswitch-like discontinuities, and many PLLs never settle
to the correct value before the next headswitch, rendering
the image completely unintelligible.
FIGURE 1. VIDEO FLOW (INCLUDING ABLC)
R(GB)IN0
CLAMP
GENERATION
R(GB)GND0
R(GB)IN1
R(GB)GND1
VGA0
VGA1
VGA2
VIN+
VIN-
DC RESTORE
CLAMP DAC
VCLAMP
10-BIT ADC
OFFSET
DAC
FIXED
OFFSET
ABLC
OFFSET
CONTROL
REGISTERS
ABLC
FIXED
OFFSET
0X000
TO
ABLC
BLOCK
TO OUTPUT
FORMATTER
10
AUTOMATIC BLACK LEVEL
COMPENSATION (ABLC) LOOP
DC RESTORATION
INPUT
BANDWIDTH
PGA
BANDWIDTH
CONTROL
10
R(GB)IN2
R(GB)GND2
ISL51002
相關PDF資料 |
PDF描述 |
|---|---|
| ISL5314IN | IC SYNTHESIZER DIGITAL 48-MQFP |
| ISL55100AIRZ-T | IC COMP DRVR/WINDOW 18V 72-QFN |
| ISL55100BIRZ | IC COMP DRVR/WINDOW 18V 72-QFN |
| ISL5627INZ | IC DAC DUAL 8BIT 3.3V 48-LQFP |
| ISL5629/2INZ | IC DAC 8BIT CMOS DUAL 48LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL51002CQZ-150 | 制造商:Intersil Corporation 功能描述:AFE VID 3ADC 10-BIT 1.8V/3.3V 128MQFP EP - Trays 制造商:Intersil 功能描述:10 BIT VID AFE MEASURE&AUTO-ADJUST 制造商:Intersil Corporation 功能描述:10-Bit Video Analog Front End (AFE) with Measurement and Auto-Adjust Features |
| ISL51002CQZ-165 | 功能描述:IC FRONT END 10BIT VID 128-MQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模擬前端 (AFE) 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:- 通道數:2 功率（瓦特）:- 電壓 - 電源，模擬:3 V ~ 3.6 V 電壓 - 電源，數字:3 V ~ 3.6 V 封裝/外殼:32-VFQFN 裸露焊盤 供應商設備封裝:32-QFN（5x5） 包裝:帶卷 (TR) |
| ISL51002EVALZ | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:10-Bit Video Analog Front End (AFE) with Measurement and Auto-Adjust Features |
| ISL51002-EVALZ | 功能描述:EVAL BOARD FOR ISL51002 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板 |
| ISL5100A | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Quad 18V Pin Electronics Driver/Window Comparator |
發布緊急采購，3分鐘左右您將得到回復。