1026
SAM9X35 [DATASHEET]
11055E–ATARM–10-Mar-2014
To create this list of buffers:
1.
Allocate a number (n) of buffers of between 1 and 2047 bytes of data to be transmitted in system memory. Up to
128 buffers per frame are allowed.
2.
Allocate an area 2n words for the transmit buffer descriptor entry in system memory and create N entries in this
list. Mark all entries in this list as owned by EMAC, i.e. bit 31 of word 1 set to 0.
3.
If fewer than 1024 buffers are defined, the last descriptor must be marked with the wrap bit — bit 30 in word 1 set
to 1.
4.
Write address of transmit buffer descriptor entry to EMAC register transmit_buffer queue pointer.
5.
The transmit circuits can then be enabled by writing to the network control register.
45.5.1.4 Address Matching
The EMAC register-pair hash address and the four specific address register-pairs must be written with the required
values. Each register-pair comprises a bottom register and top register, with the bottom register being written first. The
address matching is disabled for a particular register-pair after the bottom-register has been written and re-enabled when
pair may be written at any time, regardless of whether the receive circuits are enabled or disabled.
45.5.1.5 Interrupts
There are 14 interrupt conditions that are detected within the EMAC. These are ORed to make a single interrupt.
Depending on the overall system design, this may be passed through a further level of interrupt collection (interrupt
controller). On receipt of the interrupt signal, the CPU enters the interrupt handler (Refer to the Interrupt Controller). To
ascertain which interrupt has been generated, read the interrupt status register. Note that this register clears itself when
read. At reset, all interrupts are disabled. To enable an interrupt, write to interrupt enable register with the pertinent
interrupt bit set to 1. To disable an interrupt, write to interrupt disable register with the pertinent interrupt bit set to 1. To
check whether an interrupt is enabled or disabled, read interrupt mask register: if the bit is set to 1, the interrupt is
disabled.
45.5.1.6 Transmitting Frames
To set up a frame for transmission:
1.
Enable transmit in the network control register.
2.
Allocate an area of system memory for transmit data. This does not have to be contiguous, varying byte lengths
can be used as long as they conclude on byte borders.
3.
Set-up the transmit buffer list.
4.
Set the network control register to enable transmission and enable interrupts.
5.
Write data for transmission into these buffers.
6.
Write the address to transmit buffer descriptor queue pointer.
7.
Write control and length to word one of the transmit buffer descriptor entry.
8.
Write to the transmit start bit in the network control register.