- 您現在的位置：買賣IC網 > PDF目錄383077 > ICE1PCS02G (INFINEON TECHNOLOGIES AG) Standalone Power Factor Correction (PFC) Controller in Continuous Conduction Mode (CCM) with Input Brown-Out Protection PDF資料下載
參數資料
| 型號： | ICE1PCS02G |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Standalone Power Factor Correction (PFC) Controller in Continuous Conduction Mode (CCM) with Input Brown-Out Protection |
| 中文描述： | 單機功率因數校正在連續導通模式（CCM）（PFC）控制器具有輸入欠壓保護 |
| 文件頁數： | 10/18頁 |
| 文件大小： | 404K |
| 代理商： | ICE1PCS02G |
CCM-PFC
ICE1PCS02/G
Functional Description
Version 1.1
10
28 Dec 2004
Assuming the voltage loop is working and output
voltage is kept constant, the off duty cycle D
OFF
for a
CCM PFC system is given as
V
V
OUT
From the above equation, D
OFF
is proportional to V
IN
.
The objective of the current loop is to regulate the
average inductor current such that it is proportional to
the off duty cycle D
, and thus to the input voltage
V
. Figure 10 shows the scheme to achieve the
objective.
Figure10
Average Current Control in CCM
The PWM is performed by the intersection of a ramp
signal with the averaged inductor current at pin 5
(ICOMP). The PWM cycle starts with the Gate turn off
for a duration of T
(250ns typ.) and the ramp is
kept discharged. The ramp is then allowed to rise after
T
expires. The off time of the boost transistor
ends at the intersection of the ramp signal and the
averaged current waveform. This results in the
proportional relationship between the average current
and the off duty cycle D
OFF
.
Figure 11 shows the timing diagrams of T
OFFMIN
and the
PWM waveforms.
Figure11
Ramp and PWM waveforms
3.6.4
The nonlinear gain block controls the amplitude of the
regulated inductor current. The input of this block is the
voltage at pin VCOMP. This block has been designed
to support the wide input voltage range (85-265VAC).
Nonlinear Gain Block
3.7
PWM Logic
The PWM logic block prioritizes the control input
signals and generates the final logic signal to turn on
the driver stage. The speed of the logic gates in this
block, together with the width of the reset pulse T
OFFMIN
,
are designed to meet a maximum duty cycle D
MAX
95% at the GATE output.
In case of high input currents which result in Peak
Current Limitation, the GATE will be turned off
immediately and maintained in off state for the current
PWM cycle. The signal Toffmin resets (highest priority,
overriding other input signals) both the current limit
latch and the PWM on latch as illustrated in Figure 12.
Figure12
PWM Logic
3.8
Voltage Loop
The voltage loop is the outer loop of the cascaded
control scheme which controls the PFC output bus
voltage V
. This loop is closed by the feedback
sensing voltage at VSENSE which is a resistive divider
tapping from V
. The pin VSENSE is the input of
OTA1 which has an accurate internal reference of 5V
(+/-2%). Figure 13 shows the important blocks of this
voltage loop.
3.8.1
The compensation of the voltage loop is installed at the
VCOMP pin (see Figure 13). This is the output of OTA1
and the compensation must be connected at this pin to
ground. The compensation is also responsible for the
soft start function which controls an increasing AC input
current during start-up.
Voltage Loop Compensation
D
OFF
--------------
=
t
ave(I
IN
) at ICOMP
ramp profile
GATE
drive
T
OFFMIN
250ns
V
CREF
(1)
V
RAMP
PWM
ramp
released
PWM cycle
(1)
V
CREF
is a function of V
ICOMP
t
G1
R
SL1
R
Peak Current
Limit
Current Loop
PWM on signal
Toffmin
250ns
Current
Limit Latch
PWM on
Latch
HIGH =
turn GATE on
Q
Q
相關PDF資料 |
PDF描述 |
|---|---|
| ICE2A165 | Off-Line SMPS Current Mode Controller with integrated 650V/800V CoolMOS⑩ |
| ICE2A180 | Off-Line SMPS Current Mode Controller with integrated 650V/800V CoolMOS⑩ |
| ICE2A265 | Off-Line SMPS Current Mode Controller with integrated 650V/800V CoolMOS⑩ |
| ICE2A280 | Off-Line SMPS Current Mode Controller with integrated 650V/800V CoolMOS⑩ |
| ICE2A365 | Off-Line SMPS Current Mode Controller with integrated 650V/800V CoolMOS⑩ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICE1PCS02GFUMA1 | 制造商:Infineon Technologies AG 功能描述:Power Factor Correction CONTRLR 0.1mA 70KHz 8-Pin DSO 制造商:Infineon Technologies AG 功能描述:AC/DC STANDALONE - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC PFC CONTROLLER CCM DSO8 |
| ICE1PCS02GZT | 制造商:Infineon Technologies AG 功能描述:Power Factor Correction CONTRLR 0.1mA 70KHz 8-Pin DSO T/R |
| ICE1PD265G | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Power Factor Controller + Cool- MOS: BoostSET IC for High Power Factor and low THD |
| ICE1QS01 | 功能描述:軟開關 PWM 控制器 QUASI-REISTANT PWM CONTROLLER RoHS:否 制造商:Fairchild Semiconductor 輸出端數量: 輸出電流: 開關頻率: 工作電源電壓:30 V 電源電流: 最大工作溫度:+ 105 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| ICE1QS01G | 功能描述:軟開關 PWM 控制器 PWM-QR CONTROL IC FOR SMPS RoHS:否 制造商:Fairchild Semiconductor 輸出端數量: 輸出電流: 開關頻率: 工作電源電壓:30 V 電源電流: 最大工作溫度:+ 105 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。