- 您現在的位置：買賣IC網 > PDF目錄371810 > HGTP7N60C3DS9A TRANSISTOR | IGBT | N-CHAN | 600V V(BR)CES | 14A I(C) | TO-263AB PDF資料下載
參數資料
| 型號： | HGTP7N60C3DS9A |
| 英文描述： | TRANSISTOR | IGBT | N-CHAN | 600V V(BR)CES | 14A I(C) | TO-263AB |
| 中文描述： | 晶體管| IGBT的|正陳| 600V的五（巴西）國際消費電子展|第14A一（c）|至263AB |
| 文件頁數： | 7/9頁 |
| 文件大小： | 216K |
| 代理商： | HGTP7N60C3DS9A |
7
Handling Precautions for IGBTs
Insulated Gate Bipolar Transistors are susceptible to
gate-insulation damage by the electrostatic discharge of
energy through the devices. When handling these devices,
care should be exercised to assure that the static charge
built in the handler’s body capacitance is not discharged
through the device. With proper handling and application
procedures, however, IGBTs are currently being extensively
used in production by numerous equipment manufacturers in
military, industrial and consumer applications, with virtually
no damage problems due to electrostatic discharge. IGBTs
can be handled safely if the following basic precautions are
taken:
1. Prior to assembly into a circuit, all leads should be kept
shorted together either by the use of metal shorting
springs or by the insertion into conductive material such
as ECCOSORBD
LD26 or equivalent.
2. When devices are removed by hand from their carriers,
the hand being used should be grounded by any suitable
means - for example, with a metallic wristband.
3. Tips of soldering irons should be grounded.
4. Devices should never be inserted into or removed from
circuits with power on.
5.
Gate Voltage Rating
- Never exceed the gate-voltage
rating of V
GEM
. Exceeding the rated V
GE
can result in
permanent damage to the oxide layer in the gate region.
6.
Gate Termination
- The gates of these devices are
essentially capacitors. Circuits that leave the gate open-
circuited or floating should be avoided. These conditions
canresultinturn-onofthedeviceduetovoltagebuildupon
the input capacitor due to leakage currents or pickup.
7.
Gate Protection
- These devices do not have an internal
monolithic zener diode from gate to emitter. If gate
protection is required an external zener is recommended.
Operating Frequency Information
Operating frequency information for a typical device (Figure 13)
is presented as a guide for estimating device performance
for a specific application. Other typical frequency vs collector
current (I
CE
) plots are possible using the information shown
for a typical unit in Figures 4, 7, 8, 11 and 12. The operating
frequency plot (Figure 13) of a typical device shows f
MAX1
or
f
MAX2
whichever is smaller at each point. The information is
based on measurements of a typical device and is bounded
by the maximum rated junction temperature.
f
MAX1
is defined by f
MAX1
= 0.05/(t
d(OFF)I
+ t
d(ON)I
).
Deadtime (the denominator) has been arbitrarily held to 10%
of the on-state time for a 50% duty factor. Other definitions
are possible. t
d(OFF)I
and t
d(ON)I
are defined in Figure 21.
Device turn-off delay can establish an additional frequency
limiting condition for an application other than T
JM
. t
d(OFF)I
is important when controlling output ripple under a lightly
loaded condition.
f
MAX2
is defined by f
MAX2
= (P
D
- P
C
)/(E
OFF
+ E
ON
). The
allowable dissipation (P
D
) is defined by P
D
= (T
JM
- T
C
)/R
θ
JC
.
The sum of device switching and conduction losses must
not exceed P
D
. A 50% duty factor was used (Figure 13)
and the conduction losses (P
C
) are approximated by
P
C
= (V
CE
x I
CE
)/2.
E
ON
and E
OFF
are defined in the switching waveforms
shown in Figure 21. E
ON
is the integral of the instantaneous
power loss (I
CE
x V
CE
) during turn-on and E
OFF
is the
integral of the instantaneous power loss during turn-off. All
tail losses are included in the calculation for E
OFF
; i.e. the
collector current equals zero (I
CE
= 0).
HGTP7N60C3D, HGT1S7N60C3DS
ECCOSORBD is a trademark of Emerson and Cumming, Inc.
相關PDF資料 |
PDF描述 |
|---|---|
| HGT1S7N60C3DS | 14A, 600V, UFS Series N-Channel IGBTs(14A, 600V, UFS系列N溝道絕緣柵雙極型晶體管) |
| HH-597 | 180?Hybrid Space Qualified |
| HH128 | Flatpack Hybrid Junction 202000 MHz |
| HHBA-5121A | 66 MHz, 64-bit PCI-to-Fibre Channel Host Adapter(66 MHz, 64位 PCI至光通道主機適配器) |
| HHN300 | RECTIFIER DIODES STUD AND FLAT BASE TYPES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HGTR-000.5RR | 制造商:Hosa Technology 功能描述:6" Pro Guitar Patch Cable 20AWG Rean RA To Same |
| HGTR-001.5RR | 制造商:Hosa Technology 功能描述:18" Pro Guitar Patch Cable 20AWG Rean RA To Same 制造商:HOSA 功能描述:18 INCH PRO GUITAR PATCH CABLE20AWG REAN RA TO SAME |
| HGTR-001RR | 制造商:Hosa Technology 功能描述:12" Pro Guitar Patch Cable 20AWG Rean RA To Same |
| HGTR-005 | 制造商:Hosa Technology 功能描述:5FT Pro Guitar Cable 20AWG Rean Straight To Same 制造商:HOSA 功能描述:5FT PRO GUITAR CABLE 20AWG REAN STRAIGHT TO SAME |
| HGTR-005R | 制造商:Hosa Technology 功能描述:5Ft Pro Guitar Cable 20AWG Rean Straight To RA 制造商:HOSA 功能描述:5FT PRO GUITAR CABLE 20AWG REAN STRAIGHT TO RA |
發布緊急采購，3分鐘左右您將得到回復。