- 您現在的位置：買賣IC網 > PDF目錄370450 > HCPL-0710 40 ns Propagation Delay,CMOS Optocoupler(40 ns 傳播延遲，CMOS耦合器) PDF資料下載
參數資料
| 型號： | HCPL-0710 |
| 英文描述： | 40 ns Propagation Delay,CMOS Optocoupler(40 ns 傳播延遲，CMOS耦合器) |
| 中文描述： | 40納秒的傳播延遲，光耦的CMOS（40納秒的傳播延遲，耦合器的CMOS） |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 304K |
| 代理商： | HCPL-0710 |
12
Implementing DeviceNet
and SDS with the
HCPL-x710
With transmission rates up to 1
Mbit/s, both DeviceNet and SDS
are based upon the same
broadcast-oriented, communica-
tions protocol — the Controller
Area Network (CAN). Three types
of isolated nodes are
recommended for use on these
networks: Isolated Node Powered
Figure 18. Typical DeviceNet Node.
by the Network (Figure 19),
Isolated Node with Transceiver
Powered by the Network (Figure
20), and Isolated Node Providing
Power to the Network
(Figure 21).
Isolated Node Powered by the
Network
This type of node is very flexible
and as can be seen in Figure 19,
is regarded as “isolated” because
not all of its components have the
Figure 19. Isolated Node Powered by the Network.
same ground reference. Yet, all
components are still powered by
the network. This node contains
two regulators: one is isolated and
powers the CAN controller, node-
specific application and isolated
(node) side of the two optocoup-
lers while the other is non-
isolated. The non-isolated
regulator supplies the transceiver
and the non-isolated (network)
half of the two optocouplers.
NODE/APP SPECIFIC
uP/CAN
HCPL
x710
HCPL
x710
TRANSCEIVER
LOCAL
NODE
SUPPLY
5 V REG.
NETWORK
POWER
SUPPLY
V+ (SIGNAL)
V– (SIGNAL)
V+ (POWER)
V– (POWER)
GALVANIC
ISOLATION
BOUNDARY
AC LINE
DRAIN/SHIELD
SIGNAL
POWER
NODE/APP SPECIFIC
uP/CAN
HCPL
x710
HCPL
x710
TRANSCEIVER
REG.
V+ (SIGNAL)
V– (SIGNAL)
V+ (POWER)
V– (POWER)
GALVANIC
ISOLATION
BOUNDARY
DRAIN/SHIELD
SIGNAL
POWER
ISOLATED
SWITCHING
POWER
SUPPLY
NETWORK
POWER
SUPPLY
相關PDF資料 |
PDF描述 |
|---|---|
| HCPL-0720 | 40 ns Propagation Delay,CMOS Optocoupler(40 ns 傳播延遲，CMOS光耦合器) |
| HCPL-0721 | 40 ns Propagation Delay,CMOS Optocoupler(40 ns 傳播延遲，CMOS光耦合器) |
| HCPL-0731 | Dual Channel Low Input Current, High Gain Optocouplers(雙通道，低輸入電流，高增益光耦器) |
| HCPL-2730 | Dual Channel Low Input Current, High Gain Optocouplers(雙通道，低輸入電流，高增益光耦器) |
| HCPL-2731 | Dual Channel Low Input Current, High Gain Optocouplers(雙通道，低輸入電流，高增益光耦器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HCPL-0710#060 | 功能描述:高速光耦合器 1Ch 150mA 600mW RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| HCPL-0710#500 | 功能描述:高速光耦合器 1Ch 150mA 600mW RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| HCPL0710#560 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:FET-OUTPUT OPTOCOUPLER |
| HCPL-0710#560 | 功能描述:高速光耦合器 1Ch 150mA 600mW RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
| HCPL-0710-000E | 功能描述:高速光耦合器 1Ch 150mA 600mW RoHS:否 制造商:Avago Technologies 電流傳遞比: 最大波特率: 最大正向二極管電壓:1.75 V 最大反向二極管電壓:5 V 最大功率耗散:40 mW 最大工作溫度:+125 C 最小工作溫度:- 40 C 封裝 / 箱體:SOIC-5 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。