- 您現在的位置：買賣IC網 > PDF目錄362802 > EVAL-AD7713EB (Analog Devices, Inc.) CAP CERAMIC 1.0UF 10V 10% X7R 0805 SMD PDF資料下載
參數資料
| 型號： | EVAL-AD7713EB |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | CAP CERAMIC 1.0UF 10V 10% X7R 0805 SMD |
| 中文描述： | LC2MOS回路供電ADC的信號調理 |
| 文件頁數： | 10/28頁 |
| 文件大小： | 516K |
| 代理商： | EVAL-AD7713EB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
REV. C
–10–
AD7713
PGA Gain
G2
0
0
0
0
1
1
1
1
Gl
0
0
1
1
0
0
1
1
G0
0
1
0
1
0
1
0
1
Gain
1
2
4
8
16
32
64
128
(Default Condition After the Internal Power-On Reset)
Channel Selection
CH1 CH0 Channel
0
0
0
1
1
0
AIN1
AIN2
AIN3
(Default Condition After the Internal Power-On Reset)
Word Length
WL
Output Word Length
0
16-Bit
1
24-Bit
(Default Condition After Internal Power-On Reset)
RTD Excitation Currents
RO
0
Off
1
On
(Default Condition After Internal Power-On Reset)
Burn-Out Current
BO
0
Off
1
On
(Default Condition After Internal Power-On Reset)
Bipolar/Unipolar Selection (Both Inputs)
B/U
0 Bipolar
(Default Condition After Internal Power-On Reset)
1 Unipolar
Filter Selection (FS11–FS0)
The on-chip digital filter provides a Sinc
3
(or (Sinx/x)
3
) filter response. The 12 bits of data programmed into these bits determine
the filter cutoff frequency, the position of the first notch of the filter and the data rate for the part. In association with the gain selec-
tion, it also determines the output noise (and hence the effective resolution) of the device.
The first notch of the filter occurs at a frequency determined by the relationship: filter first notch frequency = (f
CLK IN
/512)/
code
where
code
is the decimal equivalent of the code in bits FS0 to FS11 and is in the range 19 to 2,000. With the nominal f
CLK IN
of
2 MHz, this results in a first notch frequency range from 1.952 Hz to 205.59 kHz. To ensure correct operation of the AD7713, the
value of the code loaded to these bits must be within this range. Failure to do this will result in unspecified operation of the device.
Changing the filter notch frequency, as well as the selected gain, impacts resolution. Tables I and II and Figure 2 show the effect of
the filter notch frequency and gain on the effective resolution of the AD7713. The output data rate (or effective conversion time) for
the device is equal to the frequency selected for the first notch of the filter. For example, if the first notch of the filter is selected at
10 Hz, then a new word is available at a 10 Hz rate or every 100 ms. If the first notch is at 200 Hz, a new word is available every 5 ms.
The settling time of the filter to a full-scale step input change is worst case 4
×
1/(output data rate). This settling time is to 100% of
the final value. For example, with the first filter notch at 100 Hz, the settling time of the filter to a full-scale step input change is
400 ms max. If the first notch is at 200 Hz, the settling time of the filter to a full-scale input step is 20 ms max. This settling time
can be reduced to 3
×
l/(output data rate) by synchronizing the step input change to a reset of the digital filter. In other words, if the
step input takes place with
SYNC
low, the settling time will be 3
×
l/(output data rate). If a change of channels takes place, the set-
tling time is 3
×
l/(output data rate) regardless of the
SYNC
input.
The –3 dB frequency is determined by the programmed first notch frequency according to the relationship: filter –3 dB frequency
= 0.262
×
first notch frequency.
相關PDF資料 |
PDF描述 |
|---|---|
| EVAL-AD7714-3EB | 3 V/5 V, CMOS, 500 uA Signal Conditioning ADC |
| EVAL-AD7714-5EB | 3 V/5 V, CMOS, 500 uA Signal Conditioning ADC |
| EVAL-AD7715-3EB | 3 V/5 V, 450 uA 16-Bit, Sigma-Delta ADC |
| EVAL-AD7715-5EB | 3 V/5 V, 450 uA 16-Bit, Sigma-Delta ADC |
| EVAL-AD7716EB | Evaluation Board For 22-Bit Data Acquisition System |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-AD7714-3EB | 制造商:Analog Devices 功能描述:EVALUATION BOARD - Bulk |
| EVAL-AD7714-3EBZ | 功能描述:BOARD EVAL FOR AD7714 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| EVAL-AD7714-5EB | 制造商:Analog Devices 功能描述:EVALUATION BOARD - Bulk |
| EVAL-AD7715-3EB | 制造商:AD 制造商全稱:Analog Devices 功能描述:3 V/5 V, 450 uA 16-Bit, Sigma-Delta ADC |
| EVAL-AD7715-3EBZ | 功能描述:BOARD EVALUATION FOR AD7715 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
發布緊急采購，3分鐘左右您將得到回復。