- 您現在的位置：買賣IC網 > PDF目錄1920 > EP9315-IB (Cirrus Logic Inc)IC ARM920T MCU 200MHZ 352-PBGA PDF資料下載
參數資料
| 型號： | EP9315-IB |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 10/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ARM920T MCU 200MHZ 352-PBGA |
| 標準包裝： | 40 |
| 系列： | EP9 |
| 核心處理器： | ARM9 |
| 芯體尺寸： | 16/32-位 |
| 速度： | 200MHz |
| 連通性： | EBI/EMI，EIDE，以太網，I²C，IrDA，鍵盤/觸摸屏，PCMCIA，SPI，UART/USART，USB |
| 外圍設備： | AC'97，DMA，I²S，LCD，LED，MaverickKey，POR，PWM，WDT |
| 輸入/輸出數： | 16 |
| 程序存儲器類型： | ROMless |
| RAM 容量： | 32K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.65 V ~ 3.6 V |
| 數據轉換器： | A/D 8x12b |
| 振蕩器型： | 外部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 352-BGA |
| 包裝： | 托盤 |
| 配用： | 598-1144-ND - KIT DEVELOPMENT EP9315 ARM9 |
| 其它名稱： | 598-1262 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁
ER638E2B
3
HDLC
Description
When the final byte of a received packet is read into the DMA controller's buffer, the software will be notified
by an HDLC RFC interrupt. However, the DMA controller may not have written the currently buffered part of
the packet to memory, so that the last one to fifteen bytes of a packet may not be accessible.
Workaround
To ensure that the DMA channel empties the buffer, do the following (in the HDLC interrupt handler, for
example):
1) Note the values in the MAXCNTx and REMAIN registers for the DMA channel. The difference is the num-
ber of bytes read from the UART/HDLC, which is the size of the HDLC packet. Call this number N. Note
that the BC field of the UART1HDLCRXInfoBuf register should also be N.
2) Temporarily disable the UART DMA RX interface by clearing the RXDMAE bit in the UART1DMACtrl reg-
ister.
3) Wait until the difference between the CURRENTx and BASEx registers in the DMA channel is equal to
N + 1.
At this point, the rest of the packet is guaranteed to have been written to memory. Using this method will
cause an extra byte to be read from the UART by the DMA channel and also written to memory. This last
byte should be ignored.
SDRAM Controller
Description 1
Using the SDRAM controller in auto-precharge mode will produce system instability at external bus speeds
greater than 50MHz.
Workaround
Do not turn on the auto-precharge feature of the SDRAM controller if the external bus speed will be greater
than 50 MHz.
Description 2
When the SDRAM controller is configured for PRECHARGE ALL command, the actual sequence is not
always issued to the SDRAM device(s).
Workaround
Do a read from each SDRAM bank so that a PRECHARGE command is issued to each bank of the SDRAM
device. This will satisfy the required SDRAM initialization sequence.
Due to the effectiveness and simplicity of the software workaround, no silicon fix is planned.
相關PDF資料 |
PDF描述 |
|---|---|
| EPC1064LI20 | IC CONFIG DEVICE 65KBIT 20-PLCC |
| EPC16UC88AA | IC CONFIG DEVICE 16MBIT 88-UBGA |
| EPCS16SI16N | IC CONFIG DEVICE 16MBIT 16-SOIC |
| EPF10K10AQI208-3 | IC FLEX 10KA FPGA 10K 208-PQFP |
| EPF10K200EBC600-1 | IC FLEX 10KE FPGA 200K 600-BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EP9315-IBZ | 功能描述:微處理器 - MPU IC Universal Platfrm ARM9 SOC Prcessor RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| EP9316 | 制造商:PCA 制造商全稱:PCA ELECTRONICS INC. 功能描述:14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines |
| EP9317 | 制造商:PCA 制造商全稱:PCA ELECTRONICS INC. 功能描述:14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines |
| EP9318 | 制造商:PCA 制造商全稱:PCA ELECTRONICS INC. 功能描述:14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines |
| EP9319 | 制造商:PCA 制造商全稱:PCA ELECTRONICS INC. 功能描述:14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines |
發布緊急采購，3分鐘左右您將得到回復。