- 您現在的位置：買賣IC網 > PDF目錄362742 > EP7212-CB-A (CIRRUS LOGIC INC) HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) PDF資料下載
參數資料
| 型號： | EP7212-CB-A |
| 廠商： | CIRRUS LOGIC INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) |
| 中文描述： | 32-BIT, MROM, 74 MHz, RISC MICROCONTROLLER, PBGA256 |
| 封裝： | 17 X 17 MM, 1.53 MM HEIGHT, PLASTIC, BGA-256 |
| 文件頁數： | 44/136頁 |
| 文件大?。?/td> | 2289K |
| 代理商： | EP7212-CB-A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁當前第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
EP7212
44
DS474PP1
rupts are called SS2RX and SS2TX, respectively.
Register SS2DR is used to access the FIFOs.
There are five pins to support this SSI port: SSIRX-
DA, SSITXFR, SSICLK, SSITXDA, and SSIRX-
FR. The SSICLK, SSIRXDA, SSIRXFR, and
SSITXFR signals are inputs and the SSITXDA sig-
nal is an output in slave mode. In the master mode,
SSICLK, SSITXDA, SSITXFR, and SSIRXFR are
outputs, and SSIRXDA is an input. Master mode is
enabled by writing a one to the SS2MAEN bit
(SYSCON2[9]). When the master / slave SSI is not
required, it can be disabled to save power by writ-
ing a zero to the SS2TXEN and the SS2RXEN bits
(SYSCON2[4] [7]). When set, these two bits inde-
pendently enable the transmit and receive sides of
the interface.
The master / slave SSI is synchronous, full duplex,
and capable of supporting serial data transfers be-
tween two nodes. Although the interface is byte-
oriented, data is loaded in blocks of two bytes at a
time. Each data byte to be transferred is marked by
a frame sync pulse, lasting one clock period, and
located one clock prior to the first bit being trans-
ferred. Direction of the SSI2 ports, in slave and
master mode, is shown in
Figure 9
.
Data on the link is sent MSB first and coincides
with an appropriate frame sync pulse, of one clock
in duration, located one clock prior to the first data
bit sent (i.e., MSB). It is not possible to send data
LSB first.
When operating in master mode, the clock frequen-
cy is selected to be the same as the ADC interface’s
(master mode only SSI1) — that is, the frequencies
are selected by the same bits 16 and 17 of the
SYSCON1 register (i.e., the ADCKSEL bits).
Thus, the maximum frequency in master mode is
128 kbits/s. The interface will support continuous
transmission at this rate assuming that the OS can
respond to the interrupts within 1 msec to prevent
over/underruns.
NOTE:
To allow synchronization to the incoming
slave clock, the interface enable bits will not
take effect until one SSICLK cycle after they
are written and the value read back from
SYSCON2. The enable bits reflect the real
status of the enables internally. Hence, there
will be a delay before the new value pro-
grammed to the enable bits can be read
back.
The timing diagram for this interface can be found
in the
AC Characteristics
section of this document.
3.13.4.1
Read Back of Residual Data
All writes to the transmit FIFO must be in half-
words (i.e., in units of two bytes at a time). On the
receive side, it is possible that an odd number of
bytes will be received. Bytes are always loaded into
the receive FIFO in pairs. Consequently, in the case
of a single residual byte remaining at the end of a
transmission, it will be necessary for the software
Figure 9. SSI2 Port Directions in Slave and Master Mode
Slave 7212
SSIRXFR
SSITXFR
SSICLK
SSIRXDA
SSITXDA
Master 7212
SSIRXFR
SSITXFR
SSICLK
SSITXDA
SSIRXDA
相關PDF資料 |
PDF描述 |
|---|---|
| EP7212-CV-A | HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) |
| EP7309 | HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE |
| EP7309-CB-C | CONN MODULAR JACK 8-8 R/A UNSHLD |
| EP7309-CR-C | HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE |
| EP7309-CV-C | HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EP7212-CV-A | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI) |
| EP7212-CV-D | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| EP7230 | 功能描述:電氣外殼配件 E-PANEL FITS 72 X 30 RoHS:否 制造商:Hammond Manufacturing 產品:Rack Accessories 類型: 面板寬度: 面板高度: 外部寬度: 外部高度: 外部深度: 顏色:Black |
| EP7236 | 功能描述:電氣外殼配件 E-PANEL FITS 72 X 36 RoHS:否 制造商:Hammond Manufacturing 產品:Rack Accessories 類型: 面板寬度: 面板高度: 外部寬度: 外部高度: 外部深度: 顏色:Black |
| EP7309 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH PERFORMANCE LOW POWER SYSTEM ON CHIP ENHANCED DIGITAL AUDIO INTERFACE |
發布緊急采購，3分鐘左右您將得到回復。