參數資料
型號： EP4SE530F43C3NES
廠商： Altera
文件頁數： 26/82頁
文件大小： 0K
描述： IC STRATIX IV E 530K 1760-FBGA
標準包裝： 3
系列： STRATIX® IV E
LAB/CLB數： 21248
邏輯元件/單元數： 531200
RAM 位總計： 28033024
輸入/輸出數： 1120
電源電壓： 0.87 V ~ 0.93 V
安裝類型： 表面貼裝
工作溫度： 0°C ~ 85°C
封裝/外殼： 1760-BBGA，F(xiàn)CBGA
供應商設備封裝： 1760-FCBGA
Chapter 1: DC and Switching Characteristics for Stratix IV Devices
1–24
Switching Characteristics
March 2014
Altera Corporation
Stratix IV Device Handbook
Volume 4: Device Datasheet and Addendum
Digital reset pulse
width
—
Minimum is two parallel clock cycles
—
Notes to Table 1–23:
(1) The
–2× speed grade is the fastest speed grade offered in the following Stratix IV GX devices: EP4SGX70DF29, EP4SGX110DF29,
EP4SGX110FF35, EP4SGX230DF29, EP4SGX110FF35, EP4SGX180DF29, EP4SGX230FF35, EP4SGX290FF35, EP4SGX180FF35,
EP4SGX290FH29, EP4SGX360FF35, and EPSGX360FH29.
(2) Stratix IV GX devices in military speed grade only support selected transceiver configuration up to 3125 Mbps. For more information, contact
Altera sales representative.
(3) To calculate the REFCLK rms phase jitter requirement at reference clock frequencies other than 100 MHz, use the following formula: REFCLK
rms phase jitter at f (MHz) = REFCLK rms phase jitter at 100 MHz * 100/f.
(4) Differential LVPECL signal levels must comply to the minimum and maximum peak-to-peak differential input voltage specified in this table.
(5) The minimum reconfig_clk frequency is 2.5 MHz if the transceiver channel is configured in Transmitter only mode. The minimum
reconfig_clk
frequency is 37.5 MHz if the transceiver channel is configured in Receiver only or Receiver and Transmitter mode. For more
information, refer to the Dynamic Reconfiguration in Stratix IV Devices chapter.
(6) The device cannot tolerate prolonged operation at this absolute maximum.
(7) You must use the 1.1-V RX VICM setting if the input serial data standard is LVDS.
(8) The rate matcher supports only up to
± 300 parts per million (ppm).
(9) Time taken to rx_pll_locked goes high from rx_analogreset de-assertion. Refer to Figure 1–2 on page 1–33.
(10) Time for which the CDR must be kept in lock-to-reference (LTR) mode after rx_pll_locked goes high and before rx_locktodata is asserted
in manual mode. Refer to Figure 1–2 on page 1–33.
(11) Time taken to recover valid data after the rx_locktodata signal is asserted in manual mode. Refer to Figure 1–2 on page 1–33.
(12) Time taken to recover valid data after the rx_freqlocked signal goes high in automatic mode. Refer to Figure 1–3 on page 1–33.
(13) A GPLL may be required to meet the PMA-FPGA fabric interface timing above certain data rates. For more information, refer to the “Left/Right
PLL Requirements in Basic (PMA Direct) Mode” section in the Transceiver Clocking in Stratix IV Devices chapter.
(14) The Quartus II software automatically selects the appropriate slew rate depending on the configured data rate or functional mode.
(15) For applications that require low transmit lane-to-lane skew, use Basic (PMA Direct) xN to achieve PMA-Only bonding across all channels in the
link. You can bond all channels on one side of the device by configuring them in Basic (PMA Direct) xN mode. For more information about
clocking requirements in this mode, refer to the “Basic (PMA Direct) Mode Clocking” section in the Transceiver Clocking in Stratix IV Devices
chapter.
(16) The Quartus II software automatically selects the appropriate /L divider depending on the configured data.
(17) The maximum transceiver-FPGA fabric interface speed of 265.625 MHz is allowed only in Basic low-latency PCS mode with a 32-bit interface
width. For more information, refer to the “Basic Double-Width Mode Configurations” section in the Transceiver Architecture in Stratix IV Devices
chapter.
(18) Figure 1–1 shows the AC gain curves for each of the 16 available equalization settings.
(19) If your design uses more than one dynamic reconfiguration controller (altgx_reconfig) instances to control the transceiver (altgx) channels
physically located on the same side of the device AND if you use different reconfig_clk sources for these altgx_reconfig instances, the
delta time between any two of these reconfig_clk sources becoming stable must not exceed the maximum specification listed.
(20) The differential eye opening specification at the receiver input pins assumes that Receiver Equalization is disabled. If you enable Receiver
Equalization, the receiver circuitry can tolerate a lower minimum eye opening, depending on the equalization level. Use H-Spice simulation to
derive the minimum eye opening requirement with Receiver Equalization enabled.
(21) The rise and fall time transition is specified from 20% to 80%.
(22) Stratix IV GX devices in -4 speed grade support Basic mode and deterministic latency mode transceiver configurations up to 6375 Mbps. These
configurations are shown in the figures 1-90, 1-92, 1-94, 1-96, and 1-101 in the Transceiver Architecture in Stratix IV Devices chapter.
(23) To support data rates lower than 600-Mbps specification through oversampling, use the CDR in LTR mode only.
Table 1–23. Transceiver Specifications for Stratix IV GX Devices (Part 9 of 9)
Symbol/
Description
Conditions
–2 Commercial
Speed Grade
–3 Commercial/
Industrial and
–2× Commercial
Speed Grade (1)
–3 Military (2)
and –4
Commercial/Industrial
Speed Grade
Unit
Min
Typ
Max
Min
Typ
Max
Min
Typ
Max
相關PDF資料
PDF描述
XC2V6000-5FF1152I IC FPGA VIRTEX-II 1152FCBGA
EP4SE530F43C3ES IC STRATIX IV E 530K 1760-FBGA
EP2SGX90EF1152C5ES IC STRATIX II GX 90K 1152-FBGA
IDT71256SA20PZGI IC SRAM 256KBIT 20NS 28TSOP
IDT71256SA12PZGI IC SRAM 256KBIT 12NS 28TSOP
相關代理商/技術參數
參數描述
EP4SE530F43C4 功能描述:FPGA - 現場可編程門陣列 FPGA - Stratix IV E 21248 LABs 976 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
EP4SE530F43C4ES 制造商:Altera Corporation 功能描述:IC FPGA 1120 I/O 1760FBGA
EP4SE530F43C4N 功能描述:FPGA - 現場可編程門陣列 FPGA - Stratix IV E 21248 LABs 976 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
EP4SE530F43C4NES 制造商:Altera Corporation 功能描述:IC FPGA 1120 I/O 1760FBGA 制造商:Altera Corporation 功能描述:IC STRATIX IV E FPGA 1760FBGA
EP4SE530F43I3 功能描述:FPGA - 現場可編程門陣列 FPGA - Stratix IV E 21248 LABs 976 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*