參數資料
| 型號： | EP4CGX30CF23I7 |
| 廠商： | Altera |
| 文件頁數： | 13/42頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CYCLONE IV GX FPGA 30K 484FBG |
| 產品培訓模塊： | Cyclone IV FPGA Family Overview |
| 特色產品： | Cyclone? IV FPGAs |
| 標準包裝： | 60 |
| 系列： | CYCLONE® IV GX |
| LAB/CLB數： | 1840 |
| 邏輯元件/單元數： | 29440 |
| RAM 位總計： | 1105920 |
| 輸入/輸出數： | 290 |
| 電源電壓： | 1.16 V ~ 1.24 V |
| 安裝類型： | 表面貼裝 |
| 工作溫度： | -40°C ~ 100°C |
| 封裝/外殼： | 484-BGA |
| 供應商設備封裝： | 484-FBGA（23x23） |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
1–20
Chapter 1: Cyclone IV Device Datasheet
Switching Characteristics
December 2013
Altera Corporation
PLD-Transceiver Interface
Interface speed
(F324 and smaller
package)
—
25
—
125
25
—
125
25
—
125
MHz
Interface speed
(F484 and larger
package)
—
25
—
156.25
25
—
156.25
25
—
156.25
MHz
Digital reset pulse
width
—
Minimum is 2 parallel clock cycles
Notes to Table 1–21:
(1) This specification is valid for transmitter output jitter specification with a maximum total jitter value of 112 ps, typically for 3.125 Gbps SRIO and XAUI
protocols.
(2) The minimum reconfig_clk frequency is 2.5 MHz if the transceiver channel is configured in Transmitter Only mode. The minimum reconfig_clk frequency
is 37.5 MHz if the transceiver channel is configured in Receiver Only or Receiver and Transmitter mode.
(3) The device cannot tolerate prolonged operation at this absolute maximum.
(4) The rate matcher supports only up to ±300 parts per million (ppm).
(5) Supported for the N148, F169, and F324 device packages only.
(6) Supported for the F484, F672, and F896 device packages only. Pending device characterization.
(7) To support CDR ppm tolerance greater than ±300 ppm, implement ppm detector in user logic and configure CDR to Manual Lock Mode.
(8) Asynchronous spread-spectrum clocking is not supported.
(9) For the EP4CGX30 (F484 package only), EP4CGX50, and EP4CGX75 devices, the CDR ppl tolerance is ±200 ppm.
(10) Time taken until pll_locked goes high after pll_powerdown deasserts.
(11) Time that the CDR must be kept in lock-to-reference mode after rx_analogreset deasserts and before rx_locktodata is asserted in manual mode.
(12) Time taken to recover valid data after the rx_locktodata signal is asserted in manual mode (Figure 1–2), or after rx_freqlocked signal goes high in
automatic mode (Figure 1–3).
(13) Time taken to recover valid data after the rx_locktodata signal is asserted in manual mode.
(14) Time taken to recover valid data after the rx_freqlocked signal goes high in automatic mode.
(15) To support data rates lower than the minimum specification through oversampling, use the CDR in LTR mode only.
Table 1–21. Transceiver Specification for Cyclone IV GX Devices (Part 4 of 4)
Symbol/
Description
Conditions
C6
C7, I7
C8
Unit
Min
Typ
Max
Min
Typ
Max
Min
Typ
Max
相關PDF資料 |
PDF描述 |
|---|---|
| AMM22DTAN-S189 | CONN EDGECARD 44POS R/A .156 SLD |
| AMM22DTAH-S189 | CONN EDGECARD 44POS R/A .156 SLD |
| EP4CGX30CF23C6 | IC CYCLONE IV GX FPGA 30K 484FBG |
| A54SX16-1PQG208 | IC FPGA SX 24K GATES 208-PQFP |
| A54SX16-PQ208I | IC FPGA SX 24K GATES 208-PQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EP4CGX30CF23I7N | 功能描述:FPGA - 現場可編程門陣列 FPGA - Cyclone IV GX 1840 LABs 290 IOs RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| EP4CGX30F17C8 | 制造商:ALTERA 制造商全稱:Altera Corporation 功能描述:Cyclone IV Device Datasheet |
| EP4CGX30F23C8N | 制造商:ALTERA 制造商全稱:Altera Corporation 功能描述:Cyclone IV FPGA Device Faily Overview |
| EP4CGX30F23I7N | 制造商:ALTERA 制造商全稱:Altera Corporation 功能描述:Cyclone IV Device Datasheet |
| EP4CGX50 | 制造商:ALTERA 制造商全稱:Altera Corporation 功能描述:Cyclone IV FPGA Device Family Overview |
發布緊急采購，3分鐘左右您將得到回復。