- 您現在的位置：買賣IC網 > PDF目錄362657 > ELANSC400-33AC (ADVANCED MICRO DEVICES INC) Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers PDF資料下載
參數資料
| 型號： | ELANSC400-33AC |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| 中文描述： | 32-BIT, FLASH, 33 MHz, MICROCONTROLLER, PBGA292 |
| 封裝： | PLASTIC, BGA-292 |
| 文件頁數： | 43/132頁 |
| 文件大?。?/td> | 2400K |
| 代理商： | ELANSC400-33AC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁
élanSC400 and élanSC410 Microcontrollers Data Sheet
43
SD11 [D27]
SD12 [D28]
SD13 [D29]
SD14 [D30]
SD15 [D31]
K1
L1
L2
N1
L3
B [B]
B [B]
B [B]
B [B]
B [B]
C–E
4
C–E
4
C–E
4
C–E
4
C–E
4
70
70
70
70
70
V
CC
V
CC
V
CC
V
CC
V
CC
TS-PD
TS-PD
TS-PD
TS-PD
TS-PD
B-PPUD
B-PPUD
B-PPUD
B-PPUD
B-PPUD
I-PD
I-PD
I-PD
I-PD
I-PD
5
S
S
S
S
S
5
5
5
5
Notes:
1. Pin states for AEN, IOCHRDY, IOCS16, PDACK0
, PDRQ0, TC, and PIRQ1–PIRQ0 are listed in Table 9 on page 49.
Pin states for BALE, MCS16, SBHE, PDACK1, PDRQ1 and PIRQ7–PIRQ2 are listed in Table 14 on page 53.
2. The ISA control signals have three programmable options for Suspend mode:
–Driven High (inactive).
–Three-stated with no pullup or pulldown. This is useful when the ISA device is at 5 V and left powered in Suspend. The
board design should not drive 3.3-V signals into a 5-V device during Suspend because this can waste power. The system
designer should provide large pullup resistors to 5 V for each of these signals on the board if this configuration is
programmed.
– Three-stated with pulldown resistors when suspended with the intent of powering off the ISA device
(Power-Down Group C).
Be careful when handling IOR and IOW because they are shared with the PC Card sockets and may need to be buffered if
certain combinations of system components are powered up and off.
Summary:
These pins have built-in pulldown resistors that are invoked by:
–Suspend mode and the ISA interface is programmed to be powered off in Suspend mode (Power-Down Group C).
3. The SA bus, SA25–SA0, and the RSTDRV signal are three-stated with pulldowns in Suspend mode. This accommodates
having the ISA bus, PC Card sockets, VL bus, and ROM interfaces left powered on or powered off in Suspend mode.
Summary:
These pins have built-in pulldown resistors that are invoked by:
–Suspend mode.
4. C, D, and E output drives are programmable.
5. The combination of SD15–SD0 and D31–D16 on the same pins requires the signals to be pulled up in SD bus mode (for PC
compatibility) and pulled down in D bus mode (for consistency with D15–D0). Regardless of the mode the bus is in, the pins
are in the input state (i.e., they are still bidirectional and are not driven as outputs) and pulled down in Suspend mode.
These signals are pulled up or down automatically depending on whether the SD buffer is enabled or not (CFG3), and whether
the system is in Suspend mode or not.
Summary:
These pins have built-in pulldown and pullup resistors that are invoked by:
–Reset invokes the pulldown resistors.
–Suspend mode invokes the pulldown resistors.
–Operating (Hyper/High/Low/Temp Low-Speed modes): the pins will have pullups if the SD buffer control signals are
enabled, and have pulldowns otherwise.
Table 6.
Pin State Table—System Interface
1
(Continued)
Signal Name
[Alternate
Function]
Pin
#
Type
Output
Drive
Max
Load
(pF)
Supply
Reset
State
Normal
Operation
Suspend
State
Power
Down
Group
Note
5 V
相關PDF資料 |
PDF描述 |
|---|---|
| ELANSC400-33AI | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC400-66AC | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC400-66AI | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC410-100AC | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
| ELANSC410-100AI | Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ELANSC400-33AC-REVA3 | 制造商:Advanced Micro Devices 功能描述:MCU 16-Bit/32-Bit Elan CISC ROMLess 3.3V 292-Pin BGA |
| ELANSC400-33AI | 制造商:Advanced Micro Devices 功能描述:MCU 32-bit Elan RISC ROMLess 3.3V 292-Pin BGA |
| ELANSC400-33AIAD | 制造商:Advanced Micro Devices 功能描述: |
| ELANSC400-66AC | 制造商:Advanced Micro Devices 功能描述: |
| ELANSC400-66AI | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Single-Chip, Low-Power, PC/AT-Compatible Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。