- 您現在的位置：買賣IC網 > PDF目錄379183 > DS2722-F-04 900MHz Low-IF 1.5Mbps FSK Transceiver Final Datasheet PDF資料下載
參數資料
| 型號： | DS2722-F-04 |
| 英文描述： | 900MHz Low-IF 1.5Mbps FSK Transceiver Final Datasheet |
| 中文描述： | 900MHz的低IF 1.5Mbps的FSK收發器最終數據表 |
| 文件頁數： | 17/28頁 |
| 文件大?。?/td> | 463K |
| 代理商： | DS2722-F-04 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ML2722
DS2722-F-05
FINAL DATASHEET
DECEMBER 2003
17
Prior to transmitting the PLL must tune to the intended RF center frequency of the transmission. This occurs in TXCAL
mode. The Transmit modulation is disabled and any input on the DIN (pin 30) is ignored. The transmit output buffer is
enabled during TXCAL mode. To prevent spurious emissions due to the PLL locking, any external antenna switch or PA
should be disabled during TXCAL mode. For optimum performance we recommend that the second harmonic level
reflected back into the output TRFO (pin 23), be less than –30dBm.
Phase Locked Loop (PLL) and Channel Selection
The PLL synthesizes channel frequencies to a 512kHz resolution, which is more finely spaced than the 1.536MHz
signal bandwidth. Non-overlapping channels are spaced by 2.048MHz where the IF filter and image reject mixer give a
typical adjacent channel rejection of 25dB. There are twelve non-overlapping channels in the 902 to 928MHz ISM band
(see Table 2).
CHANNEL
FREQUENCY IN MHz
1
903.680
2
905.728
3
907.776
4
909.824
5
911.872
6
913.920
7
915.968
8
918.016
9
920.064
10
922.112
11
924.160
12
926.208
Table 2. Non-Overlapping Channel Frequencies
The LO PLL is programmed via a 3-wire serial control bus. Program words are clocked in on the DATA line (pin 5) by
the CLK (pin 6), and loaded into the dividers or control circuits when EN (pin 4) is asserted. There is no check for errors
in the program words. Once loaded, register contents are preserved while VDD is present. The register status and
operation is independent of the mode of operation of the PLL.
The reference signal from an external crystal oscillator at either 6.144MHz or 12.288MHz is fed to a programmable
reference divider. The 1.024MHz reference divider output is fed to the LO phase frequency detector. The PLL prescaler
input comes from the VCO at 1.83GHz, so the 1.024MHz comparison frequency gives 512KHz frequency resolution at
902 to 928MHz.
STANDBY MODE
In STANDBY the ML2722 transceiver is powered down. The only active circuits are the control interfaces, which are
static CMOS to minimize power consumption. The serial control interface (and control registers) remain powered up
and will accept and retain programming data as long as the digital supply is present. The ML2722 serial control
registers should be loaded with control and configuration data before any active mode is selected. The filter alignment
registers are reset at power up.
TEST MODE
The RF to digital functionality of the ML2722 requires special test mode circuitry for IC production test and radio
debugging. A test register, available via the 3-wire serial interface, controls the test multiplexers.
相關PDF資料 |
PDF描述 |
|---|---|
| DS2722-F-05 | 900MHz Low-IF 1.5Mbps FSK Transceiver Final Datasheet |
| DS2740 | High-Precision Coulomb Counter |
| DS2740B | High-Precision Coulomb Counter |
| DS2740BU | High-Precision Coulomb Counter |
| DS2740U | High-Precision Coulomb Counter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2722-F-05 | 制造商:MICRO-LINEAR 制造商全稱:MICRO-LINEAR 功能描述:900MHz Low-IF 1.5Mbps FSK Transceiver Final Datasheet |
| DS2725EVKIT+ | 制造商:Maxim Integrated Products 功能描述:DS2725 EVAL KIT - Boxed Product (Development Kits) |
| DS2725K | 功能描述:電源管理IC開發工具 RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| DS2726 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:5-Cell to 10-Cell Li+ Protector with Cell Balancing |
| DS2726_09 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:5-Cell to 10-Cell Li+ Protector with Cell Balancing |
發布緊急采購，3分鐘左右您將得到回復。