- 您現在的位置：買賣IC網 > PDF目錄10992 > DS21Q50L-W+ (Maxim Integrated Products)TXRX E1 QUAD CLK/DATA 100LQFP PDF資料下載
參數資料
| 型號： | DS21Q50L-W+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 56/87頁 |
| 文件大小： | 0K |
| 描述： | TXRX E1 QUAD CLK/DATA 100LQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 90 |
| 功能： | 收發器 |
| 接口： | E1 |
| 電路數： | 4 |
| 電源電壓： | 3.14 V ~ 3.47 V |
| 電流 - 電源： | 230mA |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LQFP |
| 供應商設備封裝： | 100-LQFP（14x14） |
| 包裝： | 托盤 |
| 包括： | * |
| 其它名稱： | 90-21Q50+LW0 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁
DS21Q50
6 of 87
1. INTRODUCTION
The DS21Q50 is optimized for high-density termination of E1 lines. Two significant features are included
for this type of application: the interleave bus option (IBO) and a system clock synthesizer feature. The
IBO allows up to eight E1 data streams to be multiplexed onto a single high-speed PCM bus without
additional external logic. The system clock synthesizer feature allows any of the E1 lines to be selected as
the master source of clock for the system and for all the transmitters. This is also accomplished without
the need of external logic. Each of the four transceivers has a clock and data jitter attenuator that can be
assigned to either the transmit or receive path. In addition there is a single, undedicated clock jitter
attenuator that can be hardware configured as the user needs. Each transceiver also contains a PRBS
pattern generator and detector. Figure 18-1 shows a simplified typical application that terminates eight E1
lines (transmit and receive pairs) and combines the data into a single 16.384MHz PCM bus. The
16.384MHz system clock is derived and phased-locked to one of the eight E1 lines. On the receive side of
each port, an elastic store provides logical management of any slip conditions because of the
asynchronous relationship of the eight E1 lines. In this application, all eight transmitters are timed to the
selected E1 line.
The analog AMI/HDB3 waveform off of the E1 line is transformer coupled into the RRING and RTIP
pins of the DS21Q50. The device recovers clock and data from the analog signal and passes it through the
jitter attenuation mux to the receive framer where the digital serial stream is analyzed to locate the
framing/multiframe pattern. The DS21Q50 contains an active filter that reconstructs the analog received
signal for the nonlinear losses that occur in transmission. The device has a usable receive sensitivity of
0dB to -43dB, which allows the device to operate on cables over 2km in length. The receive framer
locates FAS frame and CRC and CAS multiframe boundaries as well as detects incoming alarms
including, carrier loss, loss of synchronization, AIS, and remote alarm. If needed, the receive elastic store
can be enabled in order to absorb the phase and frequency differences between the recovered E1 data
stream and an asynchronous backplane clock which is provided at the SYSCLK input. The clock applied
at the SYSCLK input can be either a 2.048MHz/4.096MHz/8.192MHz or 16.384MHz clock. The
transmit framer is independent from the receive in both the clock requirements and characteristics. The
transmit formatter provides the necessary frame/multiframe data overhead for E1 transmission.
相關PDF資料 |
PDF描述 |
|---|---|
| DS21Q50L+ | IC TXRX E1 QUAD 100-LQFP |
| DS3171N+ | TXRX SGL DS3/E3 400PBGA |
| DS2151QNB | IC TXRX T1 1-CH 5V LP IND 44PLCC |
| VI-B0Z-IY-F1 | CONVERTER MOD DC/DC 2V 20W |
| VI-B0Z-IX-F2 | CONVERTER MOD DC/DC 2V 30W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS21Q50L-W+ | 功能描述:網絡控制器與處理器 IC Quad E1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21Q50N | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| DS21Q55 | 功能描述:IC TXRX QUAD T1/E1/J1 SCT 256BGA RoHS:否 類別:集成電路 (IC) >> 接口 - 電信 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS 產品變化通告:Product Discontinuation 06/Feb/2012 標準包裝:750 系列:* |
| DS21Q552 | 功能描述:網絡控制器與處理器 IC 5V Quad T1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21Q552+ | 功能描述:網絡控制器與處理器 IC 5V Quad T1 Transceiver RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。