參數資料
型號： DS17487
廠商： Maxim Integrated Products, Inc.
英文描述： 3 Volt/5 Volt Real Time Clock(3V/5V實時時鐘)
文件頁數： 11/32頁
文件大小： 236K
代理商： DS17487
DS17485/DS17487
030598 11/32
REGISTER B
MSB
LSB
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
SET
PIE
AIE
UIE
SQWE
DM
24/12
DSE
SET –
When the SET bit is a zero, the update transfer
functions normally by advancing the counts once per
second. When the SET bit is written to a one, any
update transfer is inhibited and the program can initial-
ize the time and calendar bytes without an update
occurring in the midst of initializing. Read cycles can be
executed in a similar manner. SET is a read/write bit that
is not modified by internal functions of the
DS17485/DS17487.
PIE
–
The Periodic Interrupt Enable bit is a read/write bit
which allows the Periodic Interrupt Flag (PF) bit in Reg-
ister C to drive the IRQ pin low. When the PIE bit is set to
one, periodic interrupts are generated by driving the
IRQ pin low at a rate specified by the RS3–RS0 bits of
Register A. A zero in the PIE bit blocks the IRQ output
from being driven by a periodic interrupt, but the Peri-
odic Flag (PF) bit is still set at the periodic rate. PIE is not
modified by any internal DS17485/DS17487 functions.
AIE
–
The Alarm Interrupt Enable (AIE) bit is a read/
write bit which, when set to a one, permits the Alarm
Flag (AF) bit in register C to assert IRQ. An alarm inter-
rupt occurs for each second that the three time bytes
equal the three alarm bytes including a don’t care alarm
code of binary 11XXXXXX. When the AIE bit is set to
zero, the AF bit does not initiate the IRQ signal. The
internal functions of the DS17485/DS17487 do not
affect the AIE bit.
UIE
–
The Update Ended Interrupt Enable (UIE) bit is a
read/write that enables the Update End Flag (UF) bit in
Register C to assert IRQ. The SET bit going high clears
the UIE bit.
SQWE
–
When the Square Wave Enable (SQWE) bit is
set to a one and E32K=0, a square wave signal at the
frequency set by the rate-selection bits RS3 through
RS0 is driven out on the SQW pin. When the SQWE bit
is set to zero and E32K=0, the SQW pin is held low.
SQWE is a read/write bit. SQWE is set to a one when
V
CC
is powered up.
DM –
The Data Mode (DM) bit indicates whether time
and calendar information is in binary or BCD format.
The DM bit is set by the program to the appropriate for-
mat and can be read as required. This bit is not modified
by internal functions. A one in DM signifies binary data
while a zero in DM specifies Binary Coded Decimal
(BCD) data.
24/12 –
The 24/12 control bit establishes the format of
the hours byte. A one indicates the 24–hour mode and a
zero indicates the 12–hour mode. This bit is read/write.
DSE –
The Daylight Savings Enable (DSE) bit is a read/
write bit which enables two special updates when DSE
is set to one. On the first Sunday in April the time incre-
ments from 1:59:59 AM to 3:00:00 AM. On the last
Sunday in October when the time first reaches 1:59:59
AM it changes to 1:00:00 AM. These special updates do
not occur when the DSE bit is a zero. This bit is not
affected by internal functions.
REGISTER C
MSB
LSB
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
IRQF
PF
AF
UF
0
0
0
0
IRQF –
The Interrupt Request Flag (IRQF) bit is set to a
one when one or more of the following are true:
PF = PIE = 1
AF = AIE = 1
UF = UIE = 1
WF = WIE= 1
KF = KSE= 1
RF = RIE = 1
i.e., IRQF =
(
PF
PIE
)
+
(
AF
AIE
)
+
(
UF
UIE
)
+
(
WF
WIE
)
+
(
KF
KSE
)
+
(
RF
RIE
)
Any time the IRQF bit is a one, the IRQ pin is driven low.
Flag bits PF, AF, and UF are cleared after Register C is
read by the program.
PF
–
The Periodic Interrupt Flag (PF) is a read–only bit
which is set to a one when an edge is detected on the
selected tap of the divider chain. The RS3 through RS0
bits establish the periodic rate. PF is set to a one inde-
pendent of the state of the PIE bit. When both PF and
PIE are ones, the IRQ signal is active and will set the
IRQF bit. The PF bit is cleared by a software read of
Register C.
AF
–
A one in the Alarm Interrupt Flag (AF) bit indicates
that the current time has matched the alarm time. If the
AIE bit is also a one, the IRQ pin will go low and a one will
appear in the IRQF bit. A read of Register C will
clear AF.
相關PDF資料
PDF描述
DS17485 3 Volt/5 Volt Real Time Clock(3V/5V實時時鐘)
DS1775 SOT23 Digital Thermometer and Thermostat(SOT23數字溫度計和恒溫控制器)
DS1800 Dual Inverting Log Gain/Attenuator(雙路反相對數放大/衰減器)
DS1801 Dual Audio Taper Potentiometer(雙路音頻抽頭電位器)
DS1802 Dual Audio Taper Potentiometer with Push Button Control(帶按鈕控制的雙路音頻抽頭電位器)
相關代理商/技術參數
參數描述
DS17487-3 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS17487-3+ 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS17487-3IND 功能描述:實時時鐘 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS17487-3IND+ 功能描述:實時時鐘 3V/5V RTC RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
DS174875 制造商:Maxim Integrated Products 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*