- 您現在的位置：買賣IC網 > PDF目錄379099 > CYII4SC1300AA-QSC (CYPRESS SEMICONDUCTOR CORP) 1.3 MPxl Rolling Shutter CMOS Image Sensor PDF資料下載
參數資料
| 型號： | CYII4SC1300AA-QSC |
| 廠商： | CYPRESS SEMICONDUCTOR CORP |
| 元件分類： | 圖像傳感器 |
| 英文描述： | 1.3 MPxl Rolling Shutter CMOS Image Sensor |
| 中文描述： | IMAGE SENSOR-CMOS, 1280(H) X 1024(V) PIXEL, 23fps, SQUARE, SURFACE MOUNT |
| 封裝： | 0.71 MM HEIGHT, 0.04 INCH PITCH, CERAMIC, LCC-84 |
| 文件頁數： | 17/37頁 |
| 文件大小： | 1168K |
| 代理商： | CYII4SC1300AA-QSC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
IBIS4-1300
Document Number: 38-05707 Rev. *B
Page 17 of 37
Figure 11. shows the output characteristic curve in a typical
case for the imager. The offset voltage is adjusted to 2 V, which
corresponds to the low-level voltage of the ADC. Clipping is
off, and the input signal is changed between 0 and 5 V. During
offset adjustment (when calib_s is switched from 1 -> 0 or
when calib_f is on), the input signal is at 1.2 V. This level corre-
sponds to the imager dark reference output. The input signal
is transferred to the output by adding a 2V offset and multipli-
cation with the appropriate gain. The input signal of dark pixels
(at 1.2 V) corresponds with 2 V at the output. Higher input
signals are amplified. The curves for 3 typical gain settings are
shown (unity gain, setting 3, 7 & 11).
Again, as can be seen on the above figure, the applied input
signal during the output amplifier calibration (by 'CALIB_S' or
'CALIB_F') is the reference level to which the signal is
amplified. During this calibration, a stable input is required.
Setting of the VLOW_DAC & VHIGH_DAC reference voltages
Figure 12. suggested circuit for high and low references of DAC
VLOW_DAC & VHIGH_DAC are the reference voltages for the
DAC. They represent the 0000 resp. 1111 code. The internal
series resistance is about 1.3 kOhms. They can be connected
as in Figure 12., and decoupled to ground.
Analog to digital converter
The IBIS4-1300 has a 10 bit flash analog digital converter
running nominally at 10 Msamples/s. The ADC is electrically
separated from the image sensor. The input of the ADC
("IN_ADC") should be tied externally to the OUTPUT of the
output amplifier.
(*) Project partners have demonstrated 20 MHz data rate by
careful timing and by decreasing some or all of the resistors
on NBIAS* and PBIAS*.
VLOW_DAC
About 1 V
VHIGH_DAC
About 2.3 V
o
r
1
Table 6. ADC specifications
Input range
2 - 4 V
Quantization
10 Bits
Nominal data rate
10 Msamples/s (*)
DNL (linear conversion mode)
INL (linear conversion mode)
Input capacitance
< 20 pF
Power dissipation @ 10 MHz
107 mA
535 mW
Delay of digital circuitry (Td, 40 pF load)
< 50 ns after falling edge of clock
Input setup time (Ts) for a stable LSB
< 100 ns before falling edge of clock
Conversion law
Linear / Gamma-corrected
[+] Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| CYII4SD1300AA-QAC | 1.3 MPxl Rolling Shutter CMOS Image Sensor |
| CYII4SM1300AA-HBC | 1.3 MPxl Rolling Shutter CMOS Image Sensor |
| CYII4SM1300AA-QBC | 1.3 MPxl Rolling Shutter CMOS Image Sensor |
| CYII4SM1300AA-QDC | 1.3 MPxl Rolling Shutter CMOS Image Sensor |
| CYIS1SM1000AA-HHC | 1M Pixel Radiation Hard CMOS Image Sensor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CYII4SC6600AB-HDC | 制造商:Cypress Semiconductor 功能描述: |
| CYII4SC6600AB-QDC | 功能描述:SENSOR IMAGE COLOR CMOS 68-LCC RoHS:否 類別:傳感器，轉換器 >> 圖像，相機 系列:- 標準包裝:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素陣列:768H x 488V 每秒幀數:52 電源電壓:3.3V 類型:CMOS 成像 封裝/外殼:48-QFP 供應商設備封裝:48-QFP 包裝:托盤 請注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名稱:4H20954H2095-NDKAC-00401-CBC-LB-A0 |
| CYII4SC6600AB-QWC | 制造商:Cypress Semiconductor 功能描述:DEFAULT CATEGORY |
| CYII4SC6600-EVAL | 功能描述:光學傳感器開發工具 6.6M Pixel Radiation Hard CMOS Img Snsr RoHS:否 制造商:ams 工具用于評估: 接口類型: 最大工作溫度: |
| CYII4SD1300AA-HDC | 制造商:Cypress Semiconductor 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。