參數資料
型號: CYII4SC1300AA-QSC
廠商: CYPRESS SEMICONDUCTOR CORP
元件分類: 圖像傳感器
英文描述: 1.3 MPxl Rolling Shutter CMOS Image Sensor
中文描述: IMAGE SENSOR-CMOS, 1280(H) X 1024(V) PIXEL, 23fps, SQUARE, SURFACE MOUNT
封裝: 0.71 MM HEIGHT, 0.04 INCH PITCH, CERAMIC, LCC-84
文件頁數: 14/37頁
文件大?。?/td> 1168K
代理商: CYII4SC1300AA-QSC
IBIS4-1300
Document Number: 38-05707 Rev. *B
Page 14 of 37
Table 4. Pins involved in output amplifier circuitry
Name
No.
Function
Analog signals
Extin
12
External input of the output amplifier
Active if Sel_extin = 1
Output
13
Analog output signal
To be connected to the input of the ADC (in_adc, pin 73)
Digital Controls
Sel_extin
9
1 = external input pin (extin) is applied at the input of the amplifier
0 = output amplifier is connected to the image sensor array
gc_bit0
17
LSB
Control bits for output amplifier gain setting
Gain adjustment between 1.2 (0000) & 16X (1111)
MSB
gc_bit1
18
gc_bit2
19
gc_bit3
20
unitygain
21
1 = output amplifier in unity feedback mode
0 = output amplifier gain controlled by gc_bit0...3
calib_s
16
Slow (or incremental) output offset level adjustment (calibration of output
amplifier). Offset adjustment converges after about 100 pulses on calib_s
Amplifier input should refer to a 'zero signal' at the moment of the 1->0
transition on calib_s
0 = connect to capacitor (of stage 2) and in- (of stage 1)
1 = connect to DAC output (of stage 2) and out (of stage1)
calib_f
22
Fast (=in 1 cycle) output offset level adjustment (calibration of output
amplifier)
Offset level is adjusted when both calib_f and unitygain are high
Amplifier input should refer to 'zero signal' when calib_f is high
1 = connect DAC output to offset of capacitor
0 = DAC output disconnected
dac_b0
26
LSB
Control bits for output offset level adjustment
Between Vlow_dac (0000) & Vhigh_dac (1111)
MSB
dac_b1
25
dac_b2
24
dac_b3
23
Reference voltages
Vlow_dac
14
Low and high references for offset control DAC of the analog output.
The range of this resistive division DAC should be about 1V to 2.5V. If the
range is not OK, one will notice that it is not possible to adjust the output
voltage to the appropriate level of the ADC. As the internal division resistor is
about 1.3 Kohm, we suggest to tie Vlow_dac with 1K to GND and Vhigh_dac
with 2K7 to VDD.
Vhigh_dac
15
Nbias_oamp
27
Output amplifier speed/power.
Connect with 100 K to VDD and decouple with 100 nF to GND. This setting
yields 10 MHz nominal pixel rate. Lowering the resistance does increasing
this rate.
Clip
83
Voltage that can be used to clip the output signal
Clips output if output signal > 'Vclip - Vth, PMOS' with Vth,PMOS=-1V
Default: 5 V (no clipping)
[+] Feedback
相關PDF資料
PDF描述
CYII4SD1300AA-QAC 1.3 MPxl Rolling Shutter CMOS Image Sensor
CYII4SM1300AA-HBC 1.3 MPxl Rolling Shutter CMOS Image Sensor
CYII4SM1300AA-QBC 1.3 MPxl Rolling Shutter CMOS Image Sensor
CYII4SM1300AA-QDC 1.3 MPxl Rolling Shutter CMOS Image Sensor
CYIS1SM1000AA-HHC 1M Pixel Radiation Hard CMOS Image Sensor
相關代理商/技術參數
參數描述
CYII4SC6600AB-HDC 制造商:Cypress Semiconductor 功能描述:
CYII4SC6600AB-QDC 功能描述:SENSOR IMAGE COLOR CMOS 68-LCC RoHS:否 類別:傳感器,轉換器 >> 圖像,相機 系列:- 標準包裝:480 系列:- 象素大小:6.7µm x 6.7µm 有源象素陣列:768H x 488V 每秒幀數:52 電源電壓:3.3V 類型:CMOS 成像 封裝/外殼:48-QFP 供應商設備封裝:48-QFP 包裝:托盤 請注意:* 配用:4H2105-ND - HEADBOARD FOR KAC-004014H2104-ND - KIT EVAL FOR KAC-00401 其它名稱:4H20954H2095-NDKAC-00401-CBC-LB-A0
CYII4SC6600AB-QWC 制造商:Cypress Semiconductor 功能描述:DEFAULT CATEGORY
CYII4SC6600-EVAL 功能描述:光學傳感器開發工具 6.6M Pixel Radiation Hard CMOS Img Snsr RoHS:否 制造商:ams 工具用于評估: 接口類型: 最大工作溫度:
CYII4SD1300AA-HDC 制造商:Cypress Semiconductor 功能描述: