參數資料
型號： CDB5529
廠商： Cirrus Logic Inc
文件頁數： 5/31頁
文件大?。?/td> 0K
描述： EVAL BOARD FOR CS5529
標準包裝： 1
ADC 的數量： 1
位數： 16
采樣率（每秒）： 303
數據接口： 串行
輸入范圍： ±2.5 V
在以下條件下的電源（標準）： 2.6mW @ 2.5V
工作溫度： -40°C ~ 85°C
已用 IC / 零件： CS5529
已供物品： 板，線纜，磁盤
產品目錄頁面： 755 (CN2011-ZH PDF)
相關產品： CS5529-ASZR-ND - IC ADC 16BIT W/6BIT LATCH 20SSOP
598-1110-5-ND - IC ADC 16BIT W/6BIT LATCH 20SSOP
其它名稱： 598-1015
CS5529
DS246F5
13
SYNC1
Part of the serial port re-initialization sequence (see text for use of command).
SYNC0
End of the serial port re-initialization sequence.
Read/Write Registers
These commands are used to perform a write to or a read from a specific register. The register to be accessed is
selected with the RSB2-RSB0 bits of the command word.
R/W
0
Write Register
1
Read Register
RSB[4:0]
Register address binary encoded 0 to 31 as follows. All registers are 24 bits long.
Address
Description
000
Read or Write Offset Register
001
Read or Write Gain Register
010
Read or Write Configuration Register
011
Read Conversion Data Register
100
Read or Write Offset Gain and Configuration Registers in
this sequence (i.e. one 8-bit command is followed by 72-bits of
data to access the Offset, then the Gain, and then the
Configuration register)
Serial Port Interface
The CS5529’s serial interface consists of four con-
trol lines: CS, SDI, SDO, and SCLK.
CS, Chip Select, is the control line which enables
access to the serial port. If the CS pin is tied to logic
0, the port can function as a three wire interface.
SDI, Serial Data In, is the data signal used to trans-
fer data to the converters.
SDO, Serial Data Out, is the data signal used to
transfer output data from the converters. The SDO
output will be held at high impedance any time CS
is at logic 1.
SCLK, Serial Clock, is the serial bit-clock which
controls the shifting of data to or from the ADC’s
serial port. The CS pin must be held at logic 0 be-
fore SCLK transitions can be recognized by the
port logic. To accommodate opto-isolators SCLK
is designed with a Schmitt-trigger input to allow an
opto-isolator with slower rise and fall times to di-
rectly drive the pin. Additionally, SDO is capable
of sinking or sourcing up to 5 mA to directly drive
an opto-isolator LED. SDO will have less than a
400 mV loss in the drive voltage when sinking or
sourcing 5 mA.
Figure 4 illustrates the serial sequence necessary to
write to, or read from the serial port’s registers. A
transfer of data is always initiated by sending the
appropriate 8-bit command (MSB first) to the serial
port (SDI pin). It is important to note that some
commands use information from the configuration
registers to perform the function. For those com-
mands it is important that the correct information is
written to the configuration register first.
7
654
32
10
1
111
11
7
654
32
10
1
111
11
10
7
654
32
10
10
0
R/W
RSB2
RSB1
RSB0
0
相關PDF資料
PDF描述
VE-J1F-EY CONVERTER MOD DC/DC 72V 50W
GCM22DSXH CONN EDGECARD 44POS DIP .156 SLD
CDB5368 BOARD EVAL FOR CS5368 192KHZ ADC
VE-J1B-EY CONVERTER MOD DC/DC 95V 50W
VE-J14-EY CONVERTER MOD DC/DC 48V 50W
相關代理商/技術參數
參數描述
CDB5530U 功能描述:數據轉換 IC 開發工具 Eval Bd 24-Bit 1-Ch Low-Noise ADC RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
CDB5532U 功能描述:數據轉換 IC 開發工具 Eval Bd 24Bit ADC w/ Ultra Low-Noise USB RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
CDB5534U 功能描述:數據轉換 IC 開發工具 Eval Bd 24Bit ADC w/ Ultra Low-Noise USB RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
CDB5534U-Z 功能描述:EVAL BD 24-BIT ADCS W/ULTRALN PG 制造商:cirrus logic inc. 系列:- 零件狀態:在售 A/D 轉換器數:1 位數:24 采樣率（每秒）:3.84k 數據接口:串行 輸入范圍:±2.5 V 不同條件下的功率（典型值）:35mW @ 3.84kSPS 使用的 IC/零件:CS5534 所含物品:板，電纜 標準包裝:1
CDB5540 制造商:Cirrus Logic 功能描述:EVAL BOARD FOR CS5540 - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*