- 您現在的位置：買賣IC網 > Datasheet目錄52 > CB-ACC-36 (ConnectBlue)ANTENNA 1/2WV 2.4GHZ 10CM RPSMA Datasheet資料下載
參數資料
| 型號： | CB-ACC-36 |
| 廠商： | ConnectBlue |
| 文件頁數： | 56/58頁 |
| 文件大?。?/td> | 510K |
| 描述： | ANTENNA 1/2WV 2.4GHZ 10CM RPSMA |
| 標準包裝： | 1 |
| 天線類型： | 鞭狀：1/2 波，偶極 |
| 頻帶數目： | 1 |
| 頻率： | 2.4GHz |
| 增益： | 2.5dBi |
| 端子： | RP-SMA |
| 安裝類型： | 連接器 |
| 高度（最大）： | 3.93"（100mm） |
| 包裝： | 散裝 |
| 產品目錄頁面： | 558 (CN2011-ZH PDF) |
| 其它名稱： | 809-1001 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁
Version 1.17 2011-09
56
Figure 25: No restore switch used but a green
LED in a 3.3V host system. The status of the
signal can also be used as input to a host con-
troller.
Figure 26: No restore switch used but a green
LED in a 5V host system. The status of the
signal can also be used as input to a host
controller.
A serial resistor to the restore switch must be used to prevent a short circuit when the
GREEN/Switch-1 pin is in output HIGH state and the switch is pressed (see Figure 27).
Sometimes, over time, switch contacts can get an oxide layer. This may cause the closed
switch resistance to become too high to sink the signal to logic LOW (the signal is internally
pulled-up to 16k&). A design that prevents this can be found in Figure 28.
The GREEN/Switch-1 pin can be left unconnected if none of its functionality is required.
Figure 27: A low resistance restore
switch used. Notice the 1k&
& &
& serial resis-
tor.
Figure 28: If the resistance in the switch is not
guaranteed to be low enough, a safer design can
be used. Notice the 1k&
& &
& serial resistor.
A.2.3.4 Switch-0 Signal
Switch-0 is not multiplexed with other functionality and a switch is easily implemented (see
Figure 29).
Sometimes, over time, switch contacts can get an oxide layer. This may cause the closed
switch resistance to become too high to sink the signal to logic LOW (the signal is internally
pulled-up to 16k&). A design that prevents this can be found in Figure 30.
The Switch-0 pin can be left unconnected if its functionality is not used.
Figure 29: A low resistance function switch
used.
Figure 30: If the resistance in the switch is not
guaranteed to be low enough, a safer design
can be used.
相關PDF資料 |
PDF描述 |
|---|---|
| CC-ANT923842 | ANTENNA 916MHZ 1/2WAVE PCB MT |
| CGGP.1600.25.4.A.02 | GPS GLONASS PATCH 1575.42MHZ |
| CGGP.18.4.C.02 | RF ANTENNA |
| CGGP.35.3.A.02 | RF ANTENNA |
| CGIP.25.4.A.02 | RF ANTENNA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CB-ACC-38 | 功能描述:ANTENNA CABLE 12CM U.FL/RPSMA RoHS:是 類別:電纜組件 >> 同軸，RF 系列:- 標準包裝:1 系列:* |
| CB-ACC-41 | 制造商:connectBlue 功能描述:KIT ACCY BLUETOOTH/WLAN USB SPA |
| CB-ACC-53 | 制造商:connectBlue 功能描述:ANTENNA DUAL-BAND RPSMA |
| CB-ACC-54 | 制造商:connectBlue 功能描述:RF ANT DUAL BAND STUB SMA |
| CB-ACC-55 | 制造商:connectBlue 功能描述:RF ANT DUAL BAND PCB U.FL |
發布緊急采購，3分鐘左右您將得到回復。