Version 1.17 2011-09
41
7.2 Safety Compliance
In order to fulfill the safety standard EN 60950-1 the unit must be supplied by a limited power
source.
7.3 FCC and IC Compliance
See Table 1 for information about the different product variants.
7.3.1   Compliance for cB-0901-0301
7.3.1.1 FCC Statement for cB-0901-0301
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
"    Reorient or relocate the receiving antenna
"    Increase the separation between the equipment and receiver
"    Connect the equipment into an outlet on a circuit different from that to which the re-
ceiver is connected
Consult the dealer or an experienced radio/TV technician for help
7.3.1.1.1 Antenna
Our module type cB-0901-0301 is for OEM integrations only. The end-user product will be
professionally installed in such a manner that only the authorized antennas are used.
7.3.1.1.2 Caution
Any changes or modifications NOT explicitly APPROVED by connectBlue AB could cause
the module to cease to comply with FCC rules part 15, and thus void the users authority to
operate the equipment.
7.3.1.2 IC Compliance
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This device has been designed to operate with an antenna having a maximum gain of 2.5
dBi.
Having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.