Version 1.17 2011-09
46
8 Guidelines for Efficient and Safe Use
8.1 General
Read this information before using your OEM Serial Port Adapter.
For any exceptions, due to national requirements or limitations, when using your OEM Serial
Port Adapter, please visit www.bluetooth.org.
Note: Changes or modifications to the product not expressly approved by
connectBlue AB will void the users authority to operate the equipment.
8.2 Product Care
"   Do not expose your product to liquid or moisture.
"   Do not expose you product to extreme hot or cold temperature (see Section 2.3.3 for
further information).
"   Do not expose your product to lit candles, cigarettes, cigars, open flames, etc.
"   Do not drop, throw or try to bend your product since rough treatment could damage your
product.
"   Do not attempt to disassemble your product. Doing so will void warranty. The product
does not contain consumer serviceable or replaceable components. Service should only
be performed by connectBlue AB.
"   Do not paint your product as the paint could prevent normal use.
"   If you will not be using your product for a while, store it in a place that is dry, free from
damp, dust and extreme heat and cold.
"   The clearance and creepage distances required by the end product must be withheld
when the module is installed.
"   The cooling of the end product shall not negatively be influenced by the installation of
the module when the module is installed.
8.3 Radio Frequency Exposure
The OEM Serial Port Adapter contains a small radio transmitter and receiver. During com-
munication with other Bluetooth products the OEM Serial Port Adapter receives and trans-
mits radio frequency (RF) electromagnetic fields (microwaves) in the frequency range 2400
to 2500 MHz. The output power of the radio transmitter is very low.
When using the OEM Serial Port Adapter, you will be exposed to some of the transmitted RF
energy. This exposure is well below the prescribed limits in all national and international RF
safety standards and regulations.