- 您現在的位置：買賣IC網 > PDF目錄381451 > AT45CS1282 (Atmel Corp.) 128-megabit 2.7-volt Dual-interface Code Shadow DataFlash PDF資料下載
參數資料
| 型號： | AT45CS1282 |
| 廠商： | Atmel Corp. |
| 英文描述： | 128-megabit 2.7-volt Dual-interface Code Shadow DataFlash |
| 中文描述： | 128兆2.7伏的雙界面代碼陰影的DataFlash |
| 文件頁數： | 3/33頁 |
| 文件大?。?/td> | 252K |
| 代理商： | AT45CS1282 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
3
AT45CS1282 [Preliminary]
3447A–DFLSH–2/04
Memory Architecture
Diagram
Device Operation
The device operation is controlled by instructions from the host processor. The list of
instructions and their associated opcodes are contained in Tables 1 through 4. A valid
instruction starts with the falling edge of CS followed by the appropriate 8-bit opcode
and the desired buffer or main memory address location. While the CS pin is low, tog-
gling the SCK/CLK pin controls the loading of the opcode and the desired buffer or main
memory address location through either the SI (serial input) pin or the 8-bit input pins
(I/O7 - I/O0). All instructions, addresses, and data are transferred with the most signifi-
cant bit (MSB) first.
Buffer addressing is referenced in the datasheet using the terminology BFA10 - BFA0 to
denote the 11 address bits required to designate a byte address within a buffer. Main
memory addressing is referenced using the terminology PA13 - PA0 and BA10 - BA0,
where PA13 - PA0 denotes the 14 address bits required to designate a page address
and BA10 - BA0 denotes the 11 address bits required to designate a byte address within
the page.
Read Commands
By specifying the appropriate opcode, data can be read from the main memory or from
either one of the two SRAM data buffers. The DataFlash supports RapidS and Rapid8
protocols for Mode 0 and Mode 3. Please refer to the “Detailed Bit-level Read Timing”
diagrams in this datasheet for details on the clock cycle sequences for each mode.
CONTINUOUS ARRAY READ:
By supplying an initial starting address for the main
memory array, the Continuous Array Read command can be utilized to sequentially
read a continuous stream of data from the device by simply providing a clock signal; no
additional addressing information or control signals need to be provided. The DataFlash
incorporates an internal address counter that will automatically increment on every clock
cycle, allowing one continuous read operation without the need of additional address
sequences. To perform a continuous read, an opcode of E8H must be clocked into the
device followed by four address bytes (which comprises 7 don’t care bits plus the 25-bit
page and byte address sequence) and a series of don’t care clock cycles (24 if using the
serial interface or 19 if using the 8-bit interface). The first 14 bits (PA13 - PA0) of the
SECTOR 0a = 8 Pages
8,448 bytes (8K + 256)
SECTOR 0b = 248 Pages
261,888 bytes (248K + 7,936)
8 Pages
Page = 1,056 bytes
(1K + 32)
PAGE 0
PAGE 1
PAGE 6
PAGE 7
PAGE 8
PAGE 9
PAGE 16,382
PAGE 16,383
PAGE 14
PAGE 15
PAGE 16
PAGE 17
PAGE 18
SECTOR ARCHITECTURE
PAGE ARCHITECTURE
SECTOR 63 = 256 Pages
270,336 bytes (256K + 8K)
SECTOR 1 = 256 Pages
270,336 bytes (256K + 8K)
SECTOR 62 = 256 Pages
270,336 bytes (256K + 8K)
SECTOR 2 = 256 Pages
270,336
bytes (256K + 8K)
相關PDF資料 |
PDF描述 |
|---|---|
| AT45D011 | 1-Megabit 5.0-volt Only Serial DataFlash |
| AT45D011-JC | 1-Megabit 5.0-volt Only Serial DataFlash |
| AT45D011-JI | 1-Megabit 5.0-volt Only Serial DataFlash |
| AT45D011-SC | 1-Megabit 5.0-volt Only Serial DataFlash |
| AT45D011-SI | 1-Megabit 5.0-volt Only Serial DataFlash |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT45CS1282-TC | 功能描述:閃存 128M bit RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| AT45CS1282-TI | 功能描述:IC FLASH 128MBIT 50MHZ 40TSOP RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:96 系列:- 格式 - 存儲器:閃存 存儲器類型:FLASH 存儲容量:16M（2M x 8，1M x 16） 速度:70ns 接口:并聯 電源電壓:2.65 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:48-TFSOP（0.724"，18.40mm 寬） 供應商設備封裝:48-TSOP 包裝:托盤 |
| AT45D011 | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:1-Megabit 5.0-volt Only Serial DataFlash |
| AT45D011-JC | 功能描述:閃存 1M bit RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| AT45D011-JI | 功能描述:閃存 1M bit RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。