參數資料
型號： AT43USB355E-AU
廠商： ATMEL CORP
元件分類： 微控制器/微處理器
英文描述： Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
中文描述： 8-BIT, 12 MHz, RISC MICROCONTROLLER, PQFP64
封裝： 1.40 MM, GREEN, PLASTIC, MS-026ACB, LQFP-64
文件頁數： 17/115頁
文件大?。?/td> 610K
代理商： AT43USB355E-AU
17
AT43USB355
2603G–USB–04/06
All AT43USB355 I/O and peripherals, except for the USB hardware registers, are placed in the
I/O space. The I/O locations are accessed by the IN and OUT instructions transferring data
between the 32 general-purpose working registers and the I/O space. I/O registers within the
address range $00 – $1F are directly bit-accessible using the SBI and CBI instructions. In
these registers, the value of single bits can be checked by using the SBIS and SBIC instruc-
tions. Refer to the instruction set documentations of the AVR for more details. When using the
I/O specific commands, IN and OUT, the I/O address $00 – $3F must be used. When address-
ing I/O registers as SRAM, $20 must be added to this address. All I/O register addresses
throughout this document are shown with the SRAM address in parentheses.
For compatibility with future devices, reserved bits should be written to zero if accessed.
Reserved I/O memory addresses should never be written.
USB Hub
A block diagram of the USB hardware of the AT43USB355 is shown in Figure 6. The USB hub
of the AT43USB355 has 3 downstream ports. The embedded function is permanently
attached to Port 1. Ports 2 and 3 are available as external ports. The actual number of ports
used is strictly defined by the firmware of the AT43USB355 and can vary from 0 to 2. Because
the exact configuration is defined by firmware, ports 2 and 3 may even function as perma-
nently attached ports as long as the Hub Descriptor identifies them as such.
USB Function
The embedded USB function has its own device address and has a default end-point plus 3
other programmable end-points. Two of these end-points contain their own 64-byte FIFO while
the third end-point has an 8-byte FIFO. End-points 1 - 3 can be programmed as interrupt IN or
OUT or bulk IN or OUT end-points.
$07 ($27)
ADCSR
ADC Control and Status Register
$06 ($26)
PORTF
Data Register, Port F
$05 ($25)
DDRF
Data Direction Register, Port F
$04 ($24)
PINF
Input Pins, Port F
$03 ($23)
ADCH
ADC High Byte Data Register
$02 ($22)
ADCL
ADC Low Byte Data Register
Table 5.
I/O Memory Space (Continued)
I/O (SRAM)
Address
Name
Function
相關PDF資料
PDF描述
AT43USB355M-AC Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355M-AU Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB380 On-The-Go Upgrade of the AT43USB370 USB 2.0 Full-Speed Host/Function Processor
AT45BR3214B 32-MEGABIT DATAFLASH + 4-MEGABIT SRAM STACK MEMORY
AT45BR3214B-C1 32-MEGABIT DATAFLASH + 4-MEGABIT SRAM STACK MEMORY
相關代理商/技術參數
參數描述
AT43USB355M-AC 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB355M-AU 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
AT43USB370 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:USB 2.0 Full-Speed Host/Function Processor
AT43USB370E-AC 功能描述:USB 接口集成電路 USB HOST DEVICE CONTROL - COM TEMP RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
AT43USB380 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:On-The-Go Upgrade of the AT43USB370 USB 2.0 Full-Speed Host/Function Processor
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*