參數資料
型號: AT32UC3A3256AU-ALUT
廠商: Atmel
文件頁數: 75/94頁
文件大?。?/td> 0K
描述: IC MCU 256KB FLASH 144LQFP
產品培訓模塊: AVR® UC3 Introduction
標準包裝: 300
系列: AVR®32 UC3 A3 Audio
核心處理器: AVR
芯體尺寸: 32-位
速度: 66MHz
連通性: EBI/EMI,I²C,IrDA,MMC,SPI,SSC,UART/USART,USB OTG
外圍設備: 欠壓檢測/復位,DMA,POR,WDT
輸入/輸出數: 110
程序存儲器容量: 256KB(256K x 8)
程序存儲器類型: 閃存
RAM 容量: 128K x 8
電壓 - 電源 (Vcc/Vdd): 1.65 V ~ 1.95 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 144-LQFP
包裝: 托盤
77
32072SH–AVR32–10/2012
AT32UC3A3
10.1.10
AES
URAD (Unspecified Register Access Detection Status) does not detect read accesses
to the write-only KEYW[5..8]R registers
Fix/Workaround
None.
10.1.11
HMATRIX
In the PRAS and PRBS registers, the MxPR fields are only two bits
In the PRAS and PRBS registers, the MxPR fields are only two bits wide, instead of four bits.
The unused bits are undefined when reading the registers.
Fix/Workaround
Mask undefined bits when reading PRAS and PRBS.
10.1.12
TWIM
TWIM SR.IDLE goes high immediately when NAK is received
When a NAK is received and there is a non-zero number of bytes to be transmitted,
SR.IDLE goes high immediately and does not wait for the STOP condition to be sent. This
does not cause any problem just by itself, but can cause a problem if software waits for
SR.IDLE to go high and then immediately disables the TWIM by writing a one to CR.MDIS.
Disabling the TWIM causes the TWCK and TWD pins to go high immediately, so the STOP
condition will not be transmitted correctly.
Fix/Workaround
If possible, do not disable the TWIM. If it is absolutely necessary to disable the TWIM, there
must be a software delay of at least two TWCK periods between the detection of
SR.IDLE==1 and the disabling of the TWIM.
TWIM TWALM polarity is wrong
The TWALM signal in the TWIM is active high instead of active low.
Fix/Workaround
Use an external inverter to invert the signal going into the TWIM. When using both TWIM
and TWIS on the same pins, the TWALM cannot be used.
SMBALERT bit may be set after reset
The SMBus Alert (SMBALERT) bit in the Status Register (SR) might be erroneously set after
system reset.
Fix/Workaround
After system reset, clear the SR.SMBALERT bit before commencing any TWI transfer.
10.1.13
TWIS
Clearing the NAK bit before the BTF bit is set locks up the TWI bus
When the TWIS is in transmit mode, clearing the NAK Received (NAK) bit of the Status Reg-
ister (SR) before the end of the Acknowledge/Not Acknowledge cycle will cause the TWIS to
attempt to continue transmitting data, thus locking up the bus.
Fix/Workaround
Clear SR.NAK only after the Byte Transfer Finished (BTF) bit of the same register has been
set.
相關PDF資料
PDF描述
AT91SAM7SE512-AU IC ARM7 MCU FLASH 512K 128-LQFP
AT32AP7002-CTUT IC MCU 32BIT AVR32 196-CBGA
VE-B33-IY-F2 CONVERTER MOD DC/DC 24V 50W
VE-B33-CU-B1 CONVERTER MOD DC/DC 24V 200W
AT32UC3C0512C-ALUT IC MCU AVR32 512K FLASH 144LQFP
相關代理商/技術參數
參數描述
AT32UC3A3256-CTUR 功能描述:32位微控制器 - MCU 256KB, 144FFBGA Ind RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3A3256-CTUT 功能描述:32位微控制器 - MCU 256KB, 144FFBGA Ind RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3A3256-CTUT SL383 制造商:Atmel Corporation 功能描述:
AT32UC3A3256-DDW 功能描述:32位微控制器 - MCU UC3A3 256Kb flash - 256Kflash UC3A - Wafer RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT
AT32UC3A3256S 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:32-bit AVR? Microcontroller