- 您現在的位置：買賣IC網 > PDF目錄381284 > APL5901-13KC (Anpec Electronics Corporation) Low IQ, Low Dropout 900mA Fixed Voltage Regulator PDF資料下載
參數資料
| 型號： | APL5901-13KC |
| 廠商： | Anpec Electronics Corporation |
| 英文描述： | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| 中文描述： | 低智商，低壓差穩壓器九〇 〇毫安固定 |
| 文件頁數： | 10/21頁 |
| 文件大?。?/td> | 615K |
| 代理商： | APL5901-13KC |
Copyright
ANPEC Electronics Corp.
Rev. B.2 - May., 2005
APL5901/ 2
www.anpec.com.tw
10
The minimum input-output voltage difference (dropout)
determines the lowest usable supply voltage. In bat-
tery-powered systems, this will determine the useful
end-of-life battery voltage. Because the APL5901/2
use a p-channel MOSFET pass transistor, the drop-
out voltage is a function of drain-to-source on-resis-
tance (R
DS(ON)
) multiplied by the load current.
The APL5901/2 load-transient response graphs in typi-
cal characteristics show the transient response. A
step change in the load current from 10mA to 900mA
at 10
μ
s will cause a 20mV transient spike. Larger
output capacitor and lower ESR can reduce transient
spike.
Application I nformation
Capacitor S election and Regulator
S tability
The APL5901/2 use at least a 1
μ
F capacitor on the
input, and this capacitor can be Aluminum, Tantalum
or Ceramic capacitor. The input capacitor with larger
value and lower ESR provides better PSRR and line-
transient response. The output capacitor also can use
Aluminum, Tantalum or Ceramic capacitor, and a mini-
mum value of 4.7
μ
F and ESR above 0.02
is
recommended. A larger output capacitor can reduce
noise and improve load-transient response, stability,
and PSRR. Note that some ceramic dielectrics ex-
hibit large capacitance and ESR variation with
temperature. When using this capacitor, a minimum
10uF or more may be required to ensure the stability
at low temperature operation. Use a bypass capaci-
tor at BP pin for low output nvise. Increasing the ca-
pacitance will slightly decrease the output noise, but
increase the start-up time.
Load-Transient Considerations
Input-Output (Dropout)Voltage
Reverse Current Protection
The APL5901/2 have an internal reverse protection, it
does not need an external schottky diode to connect
the regulator input and output. If the output voltage is
forced above the input voltage by more than 11mV,
the IC will be shutdown and the ground pin current is
below 0.1uA.
Current Limit
The APL5901/2 have a current limit protection. The
ouptut voltage will drop close to zero volt, when load
current reaches the limit, and then the load current
will be limited at 200mA after output voltage is below
0.7V. When the load current back to the value where
limiting started, the output voltage and current will re-
turn to normal value. When output is shorted to
ground, the APL5901/2 will keep short circuit current
at 200mA .
S hutdow n/E nable
The APL5901/2 have an active high enable function.
Force EN high (>1.6V) enables the regulator, EN low
(<0.4V) disables the regulator and enter the shutdown
mode. In shutdown mode, the quiescent current can
reduce below 1uA. The EN pin cannot be floating, a
floating EN pin may cause an indeterminate state on
the output. If it is no use, connect to V
IN
for normal
operation.
相關PDF資料 |
PDF描述 |
|---|---|
| APL5901-13VC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5901-14DC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5901-14KC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5901-14UC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5901-14VC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| APL6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| APL602B2 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Volts:600V RDS(ON)0.125Ohms ID(cont):49Amps|Linear MOSFETs |
| APL602B2G | 功能描述:MOSFET N-CH 600V 49A T-MAX RoHS:是 類別:分離式半導體產品 >> FET - 單 系列:- 標準包裝:1,000 系列:MESH OVERLAY™ FET 型:MOSFET N 通道，金屬氧化物 FET 特點:邏輯電平門 漏極至源極電壓(Vdss):200V 電流 - 連續漏極(Id) @ 25° C:18A 開態Rds（最大）@ Id, Vgs @ 25° C:180 毫歐 @ 9A，10V Id 時的 Vgs(th)（最大）:4V @ 250µA 閘電荷(Qg) @ Vgs:72nC @ 10V 輸入電容 (Ciss) @ Vds:1560pF @ 25V 功率 - 最大:40W 安裝類型:通孔 封裝/外殼:TO-220-3 整包 供應商設備封裝:TO-220FP 包裝:管件 |
| APL602J | 功能描述:MOSFET N-CH 600V 43A SOT-227 RoHS:是 類別:半導體模塊 >> FET 系列:- 標準包裝:10 系列:* |
| APL602L | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Volts:600V RDS(ON)0.125Ohms ID(cont):49Amps|Linear MOSFETs |
發布緊急采購，3分鐘左右您將得到回復。