- 您現在的位置：買賣IC網 > PDF目錄364674 > AMIS-52150 Low-Power Transceiver with Clock and Data Recovery PDF資料下載
參數資料
| 型號： | AMIS-52150 |
| 英文描述： | Low-Power Transceiver with Clock and Data Recovery |
| 中文描述： | 低功耗收發器時鐘和數據恢復 |
| 文件頁數： | 17/25頁 |
| 文件大?。?/td> | 900K |
| 代理商： | AMIS-52150 |
AMIS-52150
Low-Power Transceiver with Clock and Data Recovery
Data Sheet
A “kicker” circuit stimulates the crystal oscillator circuit with oscillations close to the final frequency. This significantly reduces the time it
takes for the oscillator to reach and lock to the final frequency. The Quick Start function is necessary for operation in Sniff Mode
.
Table 25 lists the Quick Start control registers. For further details, refer to the application note titled “Quick Start Crystal Oscillator
Circuit Operation and Set-up”.
Table 25: Quick Start Control Registers
Quick Start Control Registers
Register (HEX)
Name
Bits
States
Comments
0x03
Kicker Trim
All
Trim the internal RC OSC to form a kick-start to the XTAL oscillator
0
Common mode clamp disabled (startup)
Kick Config1
4
1
Common mode clamp enabled (normal)
0
Normal operation
Kick Config2
5
1
Continuous kick On
0x0e
9.5 Data Detection
The RSSI circuit creates an analog voltage waveform (18mV/dB) that follows the signal strength of the RF signal. The data slice circuit
then samples that waveform to create the digitized data. The slice circuit in the AMIS-52150 can be programmed to operate in one of
three modes; DAC mode, Average mode or Peak mode. The DAC mode compares a fixed slice threshold value to the level in the slice
output. The digital data state is determined by the level of the slice output being above or below that fixed threshold. For further details,
refer to the application note titled “Setting Up the AMIS-52150 Data Slicing Modes”. Figure 12 shows a typical waveform for the DAC
mode, while Table 26 shows the control registers for the auto slice modes.
Figure 12: DAC Slice Mode Waveform
In the Average mode, the threshold value is generated automatically. This threshold value is then compared to the output of the slice
circuit to re-create the digital data. The slice circuit along with an external capacitor are used to generate a charging time constant
which is equal to charging to 95 percent of a bit level in two bit time periods. The data protocol should add a header to the data to allow
the slice circuit to determine the average level. For further details, refer to the application note titled “Setting Up the AMIS-52150 Data
Slicing Modes”. Figure 13 shows a typical waveform for the Average mode. Table 26 shows the control registers for the auto slice
modes.
17
AMI Semiconductor
– Apr. 07 – M-20535-006
www.amis.com
相關PDF資料 |
PDF描述 |
|---|---|
| AMIS-53000 | Frequency Agile Transceiver |
| AMIS-53000-M | Frequency Agile Transceiver |
| AMIS-53050 | Frequency Agile Transceiver |
| AMIS-710650 | Color CIS Module Analog Video Output |
| AMIS-710650-A6 | Color CIS Module Analog Video Output |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS-52150-XTD | 功能描述:射頻收發器 RF TRNSCVR SUB-1GHZ RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| AMIS-52150-XTP | 功能描述:射頻接收器 RF TRNSCVR SUB-1GHZ CDR RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| AMIS-53000 | 制造商:AMI 制造商全稱:AMI 功能描述:Frequency Agile Transceiver |
| AMIS53000/19608-001XT | 制造商:AMI Semiconductor 功能描述: 制造商:NTE Electronics 功能描述: |
| AMIS53000/SAMPLE | 制造商:AMI Semiconductor 功能描述: 制造商:NTE Electronics 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。