參數資料
型號： AMIS-52100-A
英文描述： Transceiver with Clock and Data Recovery
中文描述： 收發器時鐘和數據恢復
文件頁數： 14/26頁
文件大小： 1040K
代理商： AMIS-52100-A
AMIS-52100
Low-Power Transceiver with Clock and Data Recovery
Data Sheet
Table 22: Transmitter Control Registers
TX/RX Definition Control Registers
Register (HEX)
0x02
0x04
0x0c
Name
TX power
TX XTAL trim
TX enable
Bits
All
All
4
States
0
1
000
001
010
011
100
101
110
111
0
1
Comments
Transmitter is off
Transmitter is on
1.1kHz
2.3kHz
5.2kHz
10.4kHz
1.18kHz
2.57kHz
7.0kHz
20.45kHz
Normal levels
Inverted
0x0f
Data filter
4,5,6
0x1e
TX/RX invert
5
Table 23: Output Impedance Characteristics
Specification
Settings
Output
Impedance
RFPWR 0x00
Output Power
RFPWR 0xff
Harmonics
Range
Modulation
On/Off Ratio
TX output
Conditions
Resistance
Capacitance
Ext circuit
Target
Quick Start
Full range
Min.
11
402
350
300
Typ.
22
3
-26
12
-35
Max.
13
405
448
768
Units
pFarads
dBm
dBm
dBm
MHz
MHz
MHz
dBm
Frequency
ASK/OOK
70
Figure 8: Transmit Waveforms
9.3 Sniff Mode
Very low power applications will want to program the AMIS-52100 to use the Sniff Mode. This mode turns the receiver and crystal
oscillator off for a programmed time. At the end of this time the receiver wakes and “sniffs” for incoming RF energy. If energy is
detected, the receiver wakes the full receive function and starts data recovery from the RF carrier. If energy is not detected, the receiver
returns to the low power or “sleep” state. The operation of the Sniff Mode is very programmable. The time that the receiver is asleep
can be programmed from microsecond to seconds. Once the receiver wakes to detect RF energy, there is a programmable delay
before the receiver checks for energy. There is another delay that accounts for circuit delays. Finally, there is a programmable delay
after energy is detected and before the receiver samples the recovered energy to determine the logical state of the recovered data.
Table 24 lists these registers. Refer to the AMIS application note “Sniff Mode” for more information.
Figure 9 and Figure 10 show waveforms that show the timing of the Sniff Mode.
14
AMI Semiconductor
– Rev 4.0, Mar. 06 – M-20535-004
www.amis.com
相關PDF資料
PDF描述
AMIS-52100-I Transceiver with Clock and Data Recovery
AMIS-52100-M Transceiver with Clock and Data Recovery
AMIS-52150 Low-Power Transceiver with Clock and Data Recovery
AMIS-53000 Frequency Agile Transceiver
AMIS-53000-M Frequency Agile Transceiver
相關代理商/技術參數
參數描述
AMIS-52100-I 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery
AMIS-52100-M 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery
AMIS-52150 制造商:AMI 制造商全稱:AMI 功能描述:Low-Power Transceiver with Clock and Data Recovery
AMIS-52150-XTD 功能描述:射頻收發器 RF TRNSCVR SUB-1GHZ RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
AMIS-52150-XTP 功能描述:射頻接收器 RF TRNSCVR SUB-1GHZ CDR RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*