- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C971KCW (ADVANCED MICRO DEVICES INC) IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE PDF資料下載
參數資料
| 型號： | AM79C971KCW |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE |
| 中文描述： | 4 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP16 |
| 封裝： | PLASTIC, QFP-160 |
| 文件頁數： | 80/265頁 |
| 文件大?。?/td> | 3190K |
| 代理商： | AM79C971KCW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁當前第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁第259頁第260頁第261頁第262頁第263頁第264頁第265頁
80
Am79C971
configure the network port and the Am79C971 control-
ler will always defer to the software driver. When The
ASEL is set to 0, the software driver should then con-
figure the ports with PORTSEL (CSR15, bits 7-8). The
GPSI does not participate in the automatic selection
process and should be manually configured with the
PORTSEL bits. If FDEN (BCR9, bit 0) is set to 1 or
DLNKST (CSR15, bit 12) is set to 1, the Network Port
Manager will continue to select the active network port,
but the internal T-MAU will not auto-negotiate the net-
work port. Instead, if FDEN (BCR9, bit 0) is set to 1, the
internal T-MAU will come up as a full-duplex T-MAU port
if link beats are found. If DLNKST (CSR15, bit 12) is set
to 1 and the internal T-MAU is active, the T-MAU will be
in a link pass state regardless of link beat.
Note:
It is highly recommended that ASEL and
PORTSEL be used when trying to manually configure
a specific network port.
In order to manually configure the External PHY, the
recommended procedure is to force the PHY configu-
rations when Auto-Negotiation is
not
enabled. Set the
DANAS bit (BCR32, bit 7) to turn off the Network Port
Manager. Then write again to BCR32 with the DANAS
and XPHYANE (BCR32, bit 5) bits cleared, together
with the XPHYFD (BCR32, bit 4) and XPHYSP
(BCR32, bit 3) bits set to the desired configuration. The
Network Port Manager will send a few frames to vali-
date the configuration.
If FCON (BCR32, bit 0) is set to 1, this bit will force the
internal Network Port Manager into Fast Configuration
Mode. During this mode, the Network Port Manager will
not attempt to start Auto-Negotiation on the internal as
well as the external PHY. Instead, it will rely on link in-
tegrity tests for link pass state. This will accelerate the
automatic port selection on the Am79C971 controller.
The Network Port Manager in Fast Configuration Mode
will start with the external PHY if one is detected. If the
link does not come up, the Network Port Manager will
enable the internal 10BASE-T MAU. If the internal port
also does not come up, the Network Port Manager will
continue to search the MII and the internal T-MAU ports
while enabling the internal AUI port. The FCON
(BCR32, bit 0) should only be used if the network is ex-
periencing difficulty and is not stable.
CAUTION:
The Network Port Manager utilizes the
PHYADD (BCR33, bits 9-5) to communicate with the
external PHY during the automatic port selection pro-
cess. The PHYADD is copied into a shadow register
after the Am79C971 controller has read the configura-
tion information from the EEPROM. Extreme care must
be exercised by the host software not to access BCR33
during this time. A read of PVALID (BCR19, bit 15) be-
fore accessing BCR33 will guarantee that the PHYADD
has been shadowed.
Am79C972
’
s Automatic Network Port selection mecha-
nism falls within the following three general categories:
I
External PHY Not Present
I
External PHY Present but
Not
Auto-Negotiable
I
External PHY Present and Auto-Negotiable
Automatic Network Selection: External PHY Not
Present
The first case occurs when the MIIPD (BCR32, bit 14)
bit is 0. This indicates that there is no external PHY at-
tached to Am79C971 controller
’
s MII. The Am79C971
controller
’
s Network Port Manager will start the internal
Auto-Negotiation 10BASE-T MAU. If the Auto-Negotia-
tion 10BASE-T MAU fails to respond within a specific
time frame, then the Am79C971 controller will enable
the AUI. Auto-Negotiation FAST Link Pulses are still
being sent and the Auto-Negotiation 10BASE-T MAU is
still running. At that point, the active link can switch
back to the 10BASE-T MAU when Link Pulses or FAST
Link Pulses are detected. The only way to disable the
Auto-Negotiation process without using FDEN or
DLNKST is to enable the DANAS (BCR32, bit 7) bit or
to write to the internal/external PHYs MII control regis-
ter and disable Auto-Negotiation when the internal Net-
work Port Manager is disabled.
Automatic Network Selection: External PHY
Present but
Not
Auto-Negotiable
The second case occurs when the MIIPD (BCR32, bit
14) bit is 1. This indicates that there is an external PHY
attached to Am79C971 controller
’
s MII. If more than
one external PHY is attached to the MII Management
Interface, then the DANAS (BCR32, bit 7) bit must be
set to 1 and then all configuration control should revert
to software. The Am79C971 controller will read the reg-
ister of the external PHY to determine its status and
network capabilities. See
Appendix E, Auto Negotiation
Registers,
for the bit descriptions of the MII Status reg-
ister. If the external PHY is not Auto-Negotiation capa-
ble and/or the XPHYANE (BCR32, bit 5) bit is set to 0,
then the Network Port Manager will match up the exter-
nal PHY capabilities with the XPHYFD (BCR 32, bit 4)
and the XPHYSP (BCR32, bit 3) bits programmed from
the EEPROM. The Am79C971 controller will then pro-
gram the external PHY with those values. A new read
of the external PHYs MII Status register will be made to
see if the link is up. If the link does not come up as pro-
grammed after a specific time, the Am79C971 control-
ler will fail the external PHY link and start the internal
PHY process as described above. The Am79C971
controller will only start the external PHY link if the in-
ternal link has failed. If both links have failed, the AUI is
enabled but the Network Port Manager will still query
the internal and external PHYs for active links.
Automatic Network Selection: External PHY
Present and Auto-Negotiable
The third case occurs when the MIIPD (BCR32, bit 14)
bit is 1. This indicates that there is an external PHY at-
tached to Am79C971 controller
’
s MII. If more than one
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C972BKCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BKIW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BVCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972 | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BVIW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C971VCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C972 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BKC\\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C972BKC\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C972BKCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
發布緊急采購，3分鐘左右您將得到回復。