3-4 Revision 13 Table 3-1 shows the Flash*Freeze pin location on the available packages. The Flash*Freeze pin locat" />
參數資料
型號： AGLE600V5-FG484
廠商： Microsemi SoC
文件頁數： 33/166頁
文件大?。?/td> 0K
描述： IC FPGA 1KB FLASH 600K 484-FBGA
標準包裝： 60
系列： IGLOOe
邏輯元件/單元數： 13824
RAM 位總計： 110592
輸入/輸出數： 270
門數： 600000
電源電壓： 1.425 V ~ 1.575 V
安裝類型： 表面貼裝
工作溫度： 0°C ~ 70°C
封裝/外殼： 484-BGA
供應商設備封裝： 484-FPBGA（23x23）
Pin Descriptions and Packaging
3-4
Revision 13
Table 3-1 shows the Flash*Freeze pin location on the available packages. The Flash*Freeze pin location
is independent of device (except for a PQ208 package), allowing migration to larger or smaller IGLOO
devices while maintaining the same pin location on the board. Refer to the "Flash*Freeze Technology
and Low Power Modes" chapter of the IGLOOe FPGA Fabric User’s Guide for more information on I/O
states during Flash*Freeze mode.
JTAG Pins
Low power flash devices have a separate bank for the dedicated JTAG pins. The JTAG pins can be run
at any voltage from 1.5 V to 3.3 V (nominal). VCC must also be powered for the JTAG state machine to
operate, even if the device is in bypass mode; VJTAG alone is insufficient. Both VJTAG and VCC to the
part must be supplied to allow JTAG signals to transition the device. Isolating the JTAG power supply in a
separate I/O bank gives greater flexibility in supply selection and simplifies power supply and PCB
design. If the JTAG interface is neither used nor planned for use, the VJTAG pin together with the TRST
pin could be tied to GND.
TCK
Test Clock
Test clock input for JTAG boundary scan, ISP, and UJTAG. The TCK pin does not have an internal pull-
up/-down resistor. If JTAG is not used, Microsemi recommends tying off TCK to GND through a resistor
placed close to the FPGA pin. This prevents JTAG operation in case TMS enters an undesired state.
Note that to operate at all VJTAG voltages, 500
to 1 k will satisfy the requirements. Refer to Table 3-2
for more information.
Table 3-1 Flash*Freeze Pin Locations for IGLOOe Devices
Package
Flash*Freeze Pin
FG256
T3
FG484
W6
FG896
AH4
Table 3-2 Recommended Tie-Off Values for the TCK and TRST Pins
VJTAG
Tie-Off Resistance 1,2
VJTAG at 3.3 V
200
to 1 k
VJTAG at 2.5 V
200
to 1 k
VJTAG at 1.8 V
500
to 1 k
VJTAG at 1.5 V
500
to 1 k
Notes:
1. The TCK pin can be pulled-up or pulled-down.
2. The TRST pin is pulled-down.
3. Equivalent parallel resistance if more than one device is on the JTAG chain
相關PDF資料
PDF描述
AGLE600V5-FGG484 IC FPGA 1KB FLASH 600K 484-FBGA
A42MX24-FTQG176 IC FPGA MX SGL CHIP 36K 176-TQFP
AYM36DRMH CONN EDGECARD 72POS .156 WW
ASM36DRMH CONN EDGECARD 72POS .156 WW
AGM36DRMH CONN EDGECARD 72POS .156 WW
相關代理商/技術參數
參數描述
AGLE600V5-FG484I 功能描述:IC FPGA 1KB FLASH 600K 484-FBGA RoHS:否 類別:集成電路 (IC) >> 嵌入式 - FPGA（現場可編程門陣列） 系列:IGLOOe 產品培訓模塊:Three Reasons to Use FPGA's in Industrial Designs Cyclone IV FPGA Family Overview 特色產品:Cyclone? IV FPGAs 標準包裝:60 系列:CYCLONE® IV GX LAB/CLB數:9360 邏輯元件/單元數:149760 RAM 位總計:6635520 輸入/輸出數:270 門數:- 電源電壓:1.16 V ~ 1.24 V 安裝類型:表面貼裝 工作溫度:0°C ~ 85°C 封裝/外殼:484-BGA 供應商設備封裝:484-FBGA（23x23）
AGLE600V5-FG896 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE600V5-FG896ES 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE600V5-FG896I 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
AGLE600V5-FG896PP 制造商:ACTEL 制造商全稱:Actel Corporation 功能描述:IGLOOe Low-Power Flash FPGAs with Flash Freeze Technology
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*