Datasheet Information
5-14
Revision 4
Advance v0.6
(continued)
The "Analog-to-Digital Converter Block" section was updated with the following
statement:
"All results are MSB justified in the ADC."
2-99
The information about the ADCSTART signal was updated in the "ADC Description"
section.
2-102
Table 2-46 Analog Channel Specifications was updated.
2-118
Table 2-47 ADC Characteristics in Direct Input Mode was updated.
2-121
Table 2-51 ACM Address Decode Table for Analog Quad was updated.
2-127
In Table 2-53 Analog Quad ACM Byte Assignment, the Function and Default
Setting for Bit 6 in Byte 3 was updated.
2-130
The "Introduction" section was updated to include information about digital inputs,
outputs, and bibufs.
2-133
In Table 2-69 Fusion Pro I/O Features, the programmable delay descriptions were
updated for the following features:
Single-ended receiver
Voltage-referenced differential receiver
LVDS/LVPECL differential receiver features
2-137
The "User I/O Naming Convention" section was updated to include "V" and "z"
descriptions
2-159
The "VCC33PMP Analog Power Supply (3.3 V)" section was updated to include
information about avoiding high current draw.
2-224
The "VCCNVM Flash Memory Block Power Supply (1.5 V)" section was updated to
include information about avoiding high current draw.
2-224
The "VMVx I/O Supply Voltage (quiet)" section was updated to include this
statement: VMV and VCCI must be connected to the same power supply and VCCI
pins within a given I/O bank.
2-185
The "PUB Push Button" section was updated to include information about leaving
the pin floating if it is not used.
2-228
The "PTBASE Pass Transistor Base" section was updated to include information
about leaving the pin floating if it is not used.
2-228
The "PTEM Pass Transistor Emitter" section was updated to include information
about leaving the pin floating if it is not used.
2-228
The heading was incorrect in the "208-Pin PQFP" table. It should be AFS250 and not
AFS090.
3-8
Revision
Changes
Page