- 您現在的位置：買賣IC網 > PDF目錄11203 > ADUC848BSZ8-3 (Analog Devices Inc)IC MCU FLASH W/16BIT ADC 52MQFP PDF資料下載
參數資料
| 型號： | ADUC848BSZ8-3 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 96/108頁 |
| 文件大小： | 0K |
| 描述： | IC MCU FLASH W/16BIT ADC 52MQFP |
| 標準包裝： | 96 |
| 系列： | MicroConverter® ADuC8xx |
| 核心處理器： | 8052 |
| 芯體尺寸： | 8-位 |
| 速度： | 12.58MHz |
| 連通性： | I²C，SPI，UART/USART |
| 外圍設備： | POR，PSM，PWM，溫度傳感器，WDT |
| 輸入/輸出數： | 34 |
| 程序存儲器容量： | 8KB（8K x 8） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 4K x 8 |
| RAM 容量： | 2.25K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 3.6 V |
| 數據轉換器： | A/D 10x16b; D/A 1x12b，2x16b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 125°C |
| 封裝/外殼： | 52-QFP |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁當前第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
ADuC845/ADuC847/ADuC848
Data Sheet
Rev. C | Page 88 of 108
as op amps and voltage reference) can be powered from the
AVDD supply line as well.
DVDD
AGND
AVDD
DGND
DIGITAL SUPPLY
–
+
BEAD
1.6
0.1
F
0.1
F
10
F
10
F
ADuC845/
ADuC847/
ADuC848
04741-062
6
5
4
22
36
51
50
38
37
23
Figure 65. External Single-Supply Connections
(56-Lead LFCSP Pin Numbering)
Notice that in both Figure 64 and Figure 65 a large value (10 F)
reservoir capacitor sits on DVDD and a separate 10 F capacitor
sits on AVDD. Also, local decoupling capacitors (0.1 F) are
located at each VDD pin of the chip. As per standard design
practice, be sure to include all of these capacitors and ensure
that the smaller capacitors are closer than the 10 F capacitors
to each VDD pin with lead lengths as short as possible. Connect
the ground terminal of each of these capacitors directly to the
underlying ground plane. Finally, note that, at all times, the
analog and digital ground pins on the part must be referenced
to the same system ground reference point. It is recommended
that the LFCSP paddle be soldered to ensure mechanical
stability but be floated with respect to system VDDs or grounds.
POWER-ON RESET OPERATION
An internal power-on reset (POR) is implemented on the
ADuC845/ADuC847/ADuC848.
3 V Part
For DVDD below 2.63 V, the internal POR holds the part in reset.
As DVDD rises above 2.63 V, an internal timer times out for
typically 128 ms before the part is released from reset. The user
must ensure that the power supply has at least reached a stable
2.7 V minimum level by this time. Likewise on power-down,
the internal POR holds the part in reset until the power supply
drops below 1 V. Figure 66 illustrates the operation of the
internal POR.
128ms TYP
1.0V TYP
128ms TYP
2.63V TYP
1.0V TYP
INTERNAL
CORE RESET
DVDD
04741-063
Figure 66. 3 V Part POR operation
5 V Part
For DVDD below 4.5 V, the internal POR holds the part in reset.
As DVDD rises above 4.5 V, an internal timer times out for
approximately 128 ms before the part is released from reset. The
user must ensure that the power supply has reached a stable
4.75 V minimum level by this time. Likewise on power-down,
the internal POR holds the part in reset until the power supply
drops below 1 V. Figure 67 illustrates this operation.
128ms TYP
1.0V TYP
128ms TYP
4.5V TYP
1.0V TYP
INTERNAL
CORE RESET
DVDD
04741-087
Figure 67. 5 V Part POR Operation
POWER CONSUMPTION
The DVDD power supply current consumption is specified in
normal and power-down modes. The AVDD power supply
current is specified with the analog peripherals disabled. The
normal mode power consumption represents the current drawn
from DVDD by the digital core. The other on-chip peripherals
(such as the watchdog timer and power supply monitor)
consume negligible current and are therefore included with the
normal operating current. The user must add any currents
sourced by the parallel and serial I/O pins, and those sourced by
the DAC to determine the total current needed at the ADuC845/
ADuC847/ADuC848 DVDD and AVDD supply pins. Also, current
drawn from the DVDD supply increases by approximately 5 mA
during Flash/EE erase and program cycles.
POWER-SAVING MODES
Setting the power-down mode bit, PCON.1, in the PCON SFR
described in Table 6, allows the chip to be switched from
normal mode into full power-down mode.
In power-down mode, both the PLL and the clock to the core
are stopped. The on-chip oscillator can be halted or can
continue to oscillate, depending on the state of the oscillator
power-down bit (OSC_PD) in the PLLCON SFR. The TIC,
driven directly from the oscillator, can also be enabled during
power-down. However, all other on-chip peripherals are shut
down. Port pins retain their logic levels in this mode, but the
DAC output goes to a high impedance state (three-state) while
ALE and PSEN outputs are held low. There are five ways to
terminate power-down mode:
Asserting the RESET Pin
Returns to normal mode. All registers are set to their reset
default value and program execution starts at the reset
vector once the RESET pin is de-asserted.
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC7020BCPZ62I-RL | IC MCU 12BIT 1MSPS I2C 40-LFCSP |
| ATXMEGA256A3B-MHR | IC MCU 8BIT 256KB FLASH 64VQFN |
| ATXMEGA256A3B-AUR | IC MCU 8BIT 256KB FLASH 64TQFP |
| VE-B33-IX-F2 | CONVERTER MOD DC/DC 24V 75W |
| VE-B33-IW-F4 | CONVERTER MOD DC/DC 24V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC848BSZ8-5 | 功能描述:IC MCU FLASH W/16BIT ADC 52MQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:250 系列:LPC11Uxx 核心處理器:ARM? Cortex?-M0 芯體尺寸:32-位 速度:50MHz 連通性:I²C，Microwire，SPI，SSI，SSP，UART/USART，USB 外圍設備:欠壓檢測/復位，POR，WDT 輸入/輸出數:40 程序存儲器容量:96KB（96K x 8） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-LQFP 包裝:托盤 其它名稱:568-9587 |
| AD-UCFS-JRN-SPRD | 功能描述:PRD LIC UCFS JOURNAL CCES 1 PRD RoHS:否 類別:編程器，開發系統 >> 軟件 系列:* 標準包裝:1 系列:ISE® 設計套件 類型:訂閱 適用于相關產品:Xilinx FPGAs 其它名稱:Q4986209T1081384 |
| AD-UCFS-MJRN-SP | 功能描述:PRD LIC UCFS JOURNAL MAIN 1 PRD RoHS:否 類別:編程器，開發系統 >> 軟件 系列:* 標準包裝:1 系列:ISE® 設計套件 類型:訂閱 適用于相關產品:Xilinx FPGAs 其它名稱:Q4986209T1081384 |
| AD-UCFS-MNT-SP | 功能描述:PRD LIC UCFS CORE MAIN 1 PRD RoHS:否 類別:編程器，開發系統 >> 軟件 系列:* 標準包裝:1 系列:ISE® 設計套件 類型:訂閱 適用于相關產品:Xilinx FPGAs 其它名稱:Q4986209T1081384 |
| AD-UCFS-SPRD | 功能描述:PRD LIC UCFS CORE CCES 1 PROD RoHS:否 類別:編程器，開發系統 >> 軟件 系列:* 標準包裝:1 系列:ISE® 設計套件 類型:訂閱 適用于相關產品:Xilinx FPGAs 其它名稱:Q4986209T1081384 |
發布緊急采購，3分鐘左右您將得到回復。