CPHA1 Clock Phase Select Bit. Set by the user" />
參數資料
型號: ADUC814ARU
廠商: Analog Devices Inc
文件頁數: 40/72頁
文件大?。?/td> 0K
描述: IC ADC 12BIT W/FLASH MCU 28TSSOP
標準包裝: 50
系列: MicroConverter® ADuC8xx
核心處理器: 8052
芯體尺寸: 8-位
速度: 16.78MHz
連通性: I²C,SPI,UART/USART
外圍設備: POR,PSM,溫度傳感器,WDT
輸入/輸出數: 17
程序存儲器容量: 8KB(8K x 8)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 640 x 8
RAM 容量: 256 x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
數據轉換器: A/D 6x12b; D/A 2x12b
振蕩器型: 內部
工作溫度: -40°C ~ 125°C
封裝/外殼: 28-TSSOP(0.173",4.40mm 寬)
包裝: 管件
配用: EVAL-ADUC814QSZ-ND - KIT DEV FOR ADUC814 MICROCONVRTR
ADuC814
Rev. A | Page 45 of 72
Bit No.
Name
Description
2
CPHA1
Clock Phase Select Bit.
Set by the user if the leading SCLOCK edge is to transmit data.
Cleared by the user if the trailing SCLOCK edge is to transmit data.
1
SPR1
SPI Bit Rate Select Bits.
0
SPR0
These bits select the SCLOCK rate (bit rate) in master mode as follows:
SPR1
SPR0
Selected Bit Rate
0
fCORE/2
0
1
fCORE/4
1
0
fCORE/8
1
fcore/16
In SPI slave mode,where SPIM = 0, the logic level on the external SS pin (Pin 22), can be read via the SPR0 bit.
1The CPOL and CPHA bits should both contain the same values for master and slave devices.
SPIDAT
SPI Data Register
Function
The SPIDAT SFR is written by the user to transmit data over the SPI interface or read by the user code to read
data just received by the SPI interface.
SFR Address
F7H
Power-On Default
00H
Bit Addressable
No
Using the SPI Interface
Depending on the configuration of the bits in the SPICON SFR
shown in Table 18, the ADuC814 SPI interface transmits or
receives data in a number of possible modes. Figure 44 shows all
possible ADuC814 SPI configurations and the timing relation-
ships and synchronization between the signals involved.
SCLOCK
(CP0L = 0)
SCLOCK
(CP0L = 1)
(CPHA = 1)
(CPHA = 0)
SAMPLE INPUT
ISPI FLAG
DATA OUTPUT
ISPI FLAG
SAMPLE INPUT
DATA OUTPUT
?
MSB BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 LSB
SS
02748-
A
-050
Figure 44. ADuC814, SPI Timing, All Modes
SPI Interface—Master Mode
In master mode, the SCLOCK pin is always an output and
generates a burst of eight clocks whenever user code writes to
the SPIDAT register. The SCLOCK bit rate is determined by
SPR0 and SPR1 in SPICON. It should also be noted that the SS
pin is not used in master mode. If the ADuC814 needs to assert
the SS pin on an external slave device, a port digital output pin
should be used. In master mode, a byte transmission or reception
is initiated by a write to SPIDAT. Eight clock periods are gener-
ated via the SCLOCK pin and the SPIDAT byte being transmitted
via MOSI. With each SCLOCK period, a data bit is also sampled
via MISO. After eight clocks, the byte is completely transmitted,
and the input byte is waiting in the input shift register. The ISPI
flag is set automatically and an interrupt occurs if enabled. The
value in the shift register is latched into SPIDAT.
SPI Interface—Slave Mode
In slave mode, the SCLOCK is an input. The SS pin must also be
driven low externally during the byte communication. Trans-
mission is also initiated by a write to SPIDAT. In slave mode, a
data bit is transmitted via MISO, and a data bit is received via
MOSI on each input SCLOCK. After eight clocks, the byte is
completely transmitted and the input byte is waiting in the
input shift register. The ISPI flag is set automatically and an
interrupt occurs if enabled. The value in the shift register is
latched into SPIDAT only when the transmission/reception of a
byte is complete. The end of transmission occurs after the
eighth clock is received, if CPHA = 1, or when SS returns high if
CPHA = 0.
相關PDF資料
PDF描述
VI-BTK-IX CONVERTER MOD DC/DC 40V 75W
VI-BTK-IW CONVERTER MOD DC/DC 40V 100W
ADUC7128BSTZ126-RL IC DAS MCU ARM7 ADC/DDS 64-LQFP
VI-BTJ-IX CONVERTER MOD DC/DC 36V 75W
VI-BTJ-IW CONVERTER MOD DC/DC 36V 100W
相關代理商/技術參數
參數描述
ADUC814ARU-D2 制造商:Analog Devices 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Bulk
ADUC814ARU-REEL 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 8KB Flash 3V/5V 28-Pin TSSOP T/R 制造商:Analog Devices 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel
ADUC814ARU-REEL7 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 8KB Flash 3V/5V 28-Pin TSSOP T/R 制造商:Analog Devices 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel
ADUC814ARUZ 功能描述:IC ADC 12BIT W/FLASH MCU 28TSSOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC8xx 產品培訓模塊:MCU Product Line Introduction XMEGA Introduction AVR XMEGA USB Connectivity 標準包裝:90 系列:AVR® XMEGA 核心處理器:AVR 芯體尺寸:8/16-位 速度:32MHz 連通性:I²C,IrDA,SPI,UART/USART 外圍設備:欠壓檢測/復位,DMA,POR,PWM,WDT 輸入/輸出數:50 程序存儲器容量:192KB(96K x 16) 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:16K x 8 電壓 - 電源 (Vcc/Vdd):1.6 V ~ 3.6 V 數據轉換器:A/D 16x12b; D/A 2x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:64-TQFP 包裝:托盤 配用:ATSTK600-RC14-ND - STK600 SOCKET/ADAPTER 64TQFPATSTK600-TQFP64-ND - STK600 SOCKET/ADAPTER 64-TQFPATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMRATAVRISP2-ND - PROGRAMMER AVR IN SYSTEM
ADUC814ARUZ-REEL 功能描述:IC MCU FLASH 12BIT ADC 28TSSOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:MicroConverter® ADuC8xx 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND