參數資料
型號： ADSP-219212MKST160
廠商： ANALOG DEVICES INC
元件分類： 數字信號處理
英文描述： DSP Microcomputer
中文描述： 32-BIT, 24.576 MHz, OTHER DSP, PQFP144
封裝： PLASTIC, LQFP-144
文件頁數： 23/40頁
文件大?。?/td> 1307K
代理商： ADSP-219212MKST160
–23–
REV. 0
ADSP-2192M
FIFO Control Registers
The Transmit FIFO Control Register has the following bit field
definitions:
CE (Bits 1–0): Connection Enable (00 = Disable,
01 = Reserved, 10 = Connect to AC’97, and
11 = Reserved)
DPSel (Bit 2): Reserved (0)
SMSel (Bit 3): Stereo/Mono Select - AC’97 Mode Only
(0 = Mono Stream or 1 = Stereo Stream)
SLOT (Bits 7–4): AC’97 Slot Select - AC’97 Mode Only
FIP (Bits 10–8): FIFO interrupt position. An interrupt is
generated when FIP[2:0] words remain in the FIFO. The
interrupt is level-sensitive.
DME (Bit 11): DMA Enable. (0 = DMA Disabled or
1 = DMA Enabled)
TFF (Bit 13): Transmit FIFO Full - Read Only.
(0 = FIFO Not Full or 1 = FIFO Full)
TFE (Bit 4): Transmit FIFO Empty - Read Only.
(0 = FIFO Not Empty or 1 = FIFO Empty)
TU (Bit 15): Transmit Underflow – Sticky, Write 1 Clear.
(0 = FIFO Underflow has not occurred or 1 = FIFO
Underflow has occurred)
The Receive FIFO Control Register has the following bit field
definitions:
CE (Bits 1–0): Connection Enable. (00 = Disable,
01 = Reserved, 10 = Connect to AC’97, 11 = Reserved)
DPSel (Bit 2): Reserved (0)
SMSel (Bit 3): Stereo/Mono Select - AC’97 Mode Only.
(0 = Mono Stream or 1 = Stereo Stream)
SLOT (Bits 7–4): AC’97 Slot Select - AC’97 Mode Only.
FIP (Bit 10–8): FIFO interrupt position. An interrupt is
generated when FIP[2:0] + 1 words have been received
in the FIFO. The interrupt is level-sensitive.
DME (Bit 11): DMA Enable. (0 = DMA Disabled or
1 = DMA Enabled)
RFF (Bit 13): Receive FIFO Full – Read Only. (0 = FIFO
Not Full or 1 = FIFO Full)
RFE (Bit 14): Receive FIFO Empty – Read Only.
(0 = FIFO Not Empty or 1 = FIFO Empty)
RO (Bit 15): Receive Overflow – Sticky, Write 1 Clear.
(0 = FIFO Overflow has not occurred or 1 = FIFO
Overflow has occurred)
System Reset Description
There are several sources of reset to the ADSP-2192M.
Power-On Reset
PCI Reset
USB Reset
Soft Reset (
RST
in CMSR Register)
Power-On Reset
The DSP has an internal power-on reset circuit that resets the
DSP when power is applied. The DSP also has a Power-On Reset
PORST
signal that can initiate this master reset. Note that
PORST
is not needed when using PCI or USB (and is shown as
a no connect in
Figure 7
); these interfaces reset the DSP under
their control as needed.
DSP Software Reset
The DSP can generate a software reset using the RSTD bit in
DSP Interrupt/Power-down Registers). Generally, reset condi-
tions are handled by forcing the DSPs to execute ROM- or
RAM-based Reset Handler code. The Reset Handler that is
executed can be dictated by the Reset Source as defined by the
CRST[1:0] bits in the Chip Mode/Status Register (CMSR). The
exact Reset Functionality is therefore defined by the ROM and
RAM Reset Handler Code and as such is programmable.
Booting Modes
The ADSP-2192M has two mechanisms for automatically
loading internal program memory after reset. The CRST pins,
sampled during power-on reset, implement these modes:
Boot from PCI Host
Boot from USB Host
Table 25. AC’97 Slot Select Values
Slot
0000–0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101–1111
Mono
Reserved
Slot 3
Slot 4
Slot 5
Slot 6
Slot 7
Slot 8
Slot 9
Slot 10
Slot 11
Slot 12
Reserved
Stereo
Reserved
Slots 3/4
Slots 4/5
Slots 5/6
Slots 6/7
Slots 7/8
Slots 8/9
Slots 9/10
Slots 10/11
Slots 11/12
Not Allowed
Reserved
Table 26. AC’97 Slot Select Values
Slot
Mono
Stereo
0000–0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101–1111
Reserved
Slot 3
Slot 4
Slot 5
Slot 6
Slot 7
Slot 8
Slot 9
Slot 10
Slot 11
Slot 12
Reserved
Reserved
Slots 3/4
Slots 4/5
Slots 5/6
Slots 6/7
Slots 7/8
Slots 8/9
Slots 9/10
Slots 10/11
Slots 11/12
Not Allowed
Reserved
相關PDF資料
PDF描述
ADSP-2192M DSP Microcomputer
ADSP-21992 Mixed Signal DSP Controller With CAN
ADSP-21992YST Mixed Signal DSP Controller With CAN
ADSP-21MOD970-510 Multiport Internet Gateway Processor Data Pump Solution(多端口網關處理器數據泵解決方案)
ADSP-21mod970 Multi-Port Internet Gateway Processor(多口網關處理器)
相關代理商/技術參數
參數描述
ADSP-2195MBCA-140 制造商:Analog Devices 功能描述:DSP Fixed-Point 24-Bit 140MHz 140MIPS 144-Pin CSP-BGA 制造商:Rochester Electronics LLC 功能描述:16-BIT,140 MIPS, 2.5V, 80KBYTES RAM - Bulk
ADSP-2195MBST-140 功能描述:IC DSP CONTROLLER 16BIT 144LQFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA
ADSP-2195MKCA-160 制造商:Analog Devices 功能描述:DSP Fixed-Point 24-Bit 160MHz 160MIPS 144-Pin CSP-BGA 制造商:Rochester Electronics LLC 功能描述:16-BIT,160 MIPS, 2.5V, 80KBYTES RAM - Bulk
ADSP-2195MKST-160 制造商:Analog Devices 功能描述:DSP Fixed-Point 24-Bit 160MHz 160MIPS 144-Pin LQFP 制造商:Analog Devices 功能描述:IC MICROCOMPUTER 16-BIT
adsp-2196mbca-140 制造商:Analog Devices 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*