參數資料
型號： ADC14061
廠商： National Semiconductor Corporation
英文描述： Low Dropout Linear 2-cell Li-Ion Charge Controller with AutoCompTM, 8.4V 8-SOIC -20 to 70
中文描述： 自校準14位，250 MSPS的，390毫瓦的A / D轉換器
文件頁數： 15/20頁
文件大?。?/td> 471K
代理商： ADC14061
Applications Information
(Continued)
3.1 The reference output voltages
are made available only
for the purpose of bypassing with capacitors. These pins
should not be loaded with more than 10 μADC. These output
voltages are described as
V
REF
+
OUT
= V
CM
+
1
2
V
REF
V
REF
OUT
= V
CM
1
2
V
REF
where V
REF
= (V
REF
+
IN
) (V
REF
+ IN)
V
REF (MID)
= (V
REF
+
OUT
+ V
REF
OUT
) / 2.
To avoid signal clipping and distortion, V
+
should not
exceed 3.3V, V
should not be below 750 mV and
V
CM
should be held in the range of 1.8V to 2.2V.
3.2 The /EOC output
goes low to indicate the presence of
valid data at the output data lines. Valid data is present the
entire time that this signal is low except during reset. Corrupt
or irrelevant data may appear at the data outputs when the
RESET pin or the CAL pin is high.
3.3 The Data Outputs
are TTL/CMOS compatible. The out-
put data format is two’s complement. Valid data is present at
these outputs while the EOC pin is low. While the t
EOCL
time
and the t
DATA_VALID
time provide information about output
timing, a simple way to capture a valid output is to latch the
data on the rising edge of the CLOCK (pin 10).
Also helpful in minimizing noise due to output switching is to
minimize the load currents at the digital outputs. This can be
done by connecting buffers between the ADC outputs and
any other circuitry. Only one input should be connected to
each output pin. Additionally, inserting series resistors of 47
or 56 Ohms at the digital outputs, close to the ADC pins, will
isolate the outputs from other circuitry and limit output cur-
rents. (See Figure 6).
4.0 POWER SUPPLY CONSIDERATIONS
Each power supply pin should be bypassed with a parallel
combination of a 10 μF capacitor and a 0.1 μF ceramic chip
capacitor. The chip capacitors should be within
1
2
centimeter
of the power pins. Leadless chip capacitors are preferred be-
cause they provide low lead inductance.
While a single 5V source is used for the analog and digital
supplies of the ADC14061, these supply pins should be well
isolated from each other to prevent any digital noise from be-
ing coupled to the analog power pins. Supply isolation with
ferrite beads is shown in Figure 6 and Figure 8
As is the case with all high-speed converters, the ADC14061
is sensitive to power supply noise. Accordingly, the noise on
the analog supply pin should be kept below 100 mV
P-P
.
No pin should ever have a voltage on it that is in excess of
the supply voltages, not even at power up.
The V
I/O provides power for the output drivers and may be
operated from a supply in the range of 3.0V to the V
supply
(nominal 5V). This can simplify interfacing to 3.0 Volt devices
and systems. Powering V
I/O from 3 Volts will also reduce
power consumption and noise generation due to output
switching.
DO NOT operate the V
D
I/O at a voltage higher
than V
D
or V
A
.
DS100103-19
FIGURE 6. Simple application circuit with single-ended to differential buffer.
A
www.national.com
15
相關PDF資料
PDF描述
ADC14071CIVBH 14-Bit, 7 MSPS, 380 mW A/D Converter
ADC14071 14-Bit, 7 MSPS, 380 mW A/D Converter
ADC14071EVAL 14-Bit, 7 MSPS, 380 mW A/D Converter
ADC14161 Low Dropout Linear 2-cell Li-Ion Charge Controller with AutoCompTM, 8.4V 8-SOIC -20 to 70
ADC14161CIVT Low-Distortion, Self-Calibrating 14-Bit, 2.5 MSPS, 390 mW A/D Converter
相關代理商/技術參數
參數描述
ADC14061EVAL 功能描述:BOARD EVALUATION FOR ADC14061 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件
ADC14071A WAF 制造商:Texas Instruments 功能描述:
ADC1410S065/DB,598 功能描述:數據轉換 IC 開發工具 ADC DEMO BOARD RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
ADC1410S065F1-DB 功能描述:ADC1410S065 - 14 Bit 65M Samples per Second Analog to Digital Converter (ADC) Evaluation Board 制造商:idt, integrated device technology inc 系列:- 零件狀態:過期 A/D 轉換器數:1 位數:14 采樣率（每秒）:65M 數據接口:SPI 輸入范圍:2 Vpp 不同條件下的功率（典型值）:380mW @ 65MSPS 使用的 IC/零件:ADC1410S065 所含物品:板 標準包裝:1
ADC1410S065F2-DB 功能描述:ADC1410S065 - 14 Bit 65M Samples per Second Analog to Digital Converter (ADC) Evaluation Board 制造商:idt, integrated device technology inc 系列:- 零件狀態:過期 A/D 轉換器數:1 位數:14 采樣率（每秒）:65M 數據接口:SPI 輸入范圍:2 Vpp 不同條件下的功率（典型值）:380mW @ 65MSPS 使用的 IC/零件:ADC1410S065 所含物品:板 標準包裝:1
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*