- 您現在的位置：買賣IC網 > PDF目錄375238 > AD7711A (Analog Devices, Inc.) Signal Conditioning ADC with RTD Current Source(帶RTD電流源信號調節A/D轉換器) PDF資料下載
參數資料
| 型號： | AD7711A |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Signal Conditioning ADC with RTD Current Source(帶RTD電流源信號調節A/D轉換器) |
| 中文描述： | 信號調理ADC，具有電阻電流源（帶電阻電流源信號調節的A / D轉換器） |
| 文件頁數： | 22/27頁 |
| 文件大?。?/td> | 237K |
| 代理商： | AD7711A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁
REV. C
AD7711A
–22–
Figures 12a and 12b show timing diagrams for reading from the
AD7711A in the external clocking mode. Figure 12a shows a
situation where all the data is read from the AD7711A in one
read operation. Figure 12b shows a situation where the data is
read from the AD7711A over a number of read operations. Both
read operations show a read from the AD7711A’s output data
register. A read from the control register or calibration registers
is similar but in these cases the
DRDY
line is not related to the
read function. Depending on the output update rate, it can go
low at any stage in the control/calibration register read cycle
without affecting the read and its status should be ignored. A
read operation from either the control or calibration registers
must always read 24 bits of data from the respective register.
Figure 12a shows a read operation from the AD7711A where
RFS
remains low for the duration of the data word transmission.
With
DRDY
low, the
RFS
input is brought low. The input
SCLK signal should be low between read and write operations.
RFS
going low places the MSB of the word to be read on the
serial data line. All subsequent data bits are clocked out on a
high to low transition of the serial clock and are valid prior to
the following rising edge of this clock. The penultimate falling
edge of SCLK clocks out the LSB and the final falling edge
resets the
DRDY
line high. This rising edge of
DRDY
turns off
the serial data output.
Figure 12b shows a timing diagram for a read operation where
RFS
returns high during the transmission of the word and re-
turns low again to access the rest of the data word. Timing
parameters and functions are very similar to that outlined for
Figure 12a but Figure 12b has a number of additional times to
show timing relationships when
RFS
returns high in the middle
of transferring a word.
RFS
should return high during a low time of SCLK. On the
rising edge of
RFS
, the SDATA output is turned off.
DRDY
remains low and will remain low until all bits of the data word
are read from the AD7711A, regardless of the number of times
RFS
changes state during the read operation. Depending on the
time between the falling edge of SCLK and the rising edge of
RFS
, the next bit (BIT N+1) may appear on the databus before
RFS
goes high. When
RFS
returns low again, it activates the
SDATA output. When the entire word is transmitted, the
DRDY
line will go high turning off the SDATA output as per
Figure 12a.
t
20
SDATA (O)
SCLK (I)
RFS
(I)
A0 (I)
DRDY
(O)
t
22
t
24
t
25
t
26
t
27
t
29
t
28
t
23
t
21
THREE-STATE
MSB
LSB
Figure 12a. External-Clocking Mode, Output Data Read Operation
t
20
SDATA (O)
SCLK (I)
RFS
(I)
A0 (I)
DRDY
(O)
t
22
t
24
t
25
t
26
t
27
t
24
t
25
THREE-STATE
MSB
t
30
t
31
BIT N
BIT N+1
Figure 12b. External-Clocking Mode, Output Data Read Operation (
RFS
Returns High During Read Operation)
相關PDF資料 |
PDF描述 |
|---|---|
| AD7711 | LC2MOS Signal Conditioning ADC with RTD Excitation Currents(RTD激勵電流LC2MOS信號調節A/D轉換器) |
| AD7714(中文) | Signal Conditioning ADC(信號調節A/D轉換器) |
| AD7715 | 3 V/5 V, 450 mA 16-Bit, Sigma-Delta ADC(16位∑△A/D轉換器) |
| AD7716BP | LC2MOS 22-Bit Data Acquisition System |
| AD7716BS | LC2MOS 22-Bit Data Acquisition System |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7711AAN | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog-to-Digital Converter， 24-Bit |
| AD7711AAR | 功能描述:IC ADC 24BIT RTD I SOURCE 24SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7711AARZ | 功能描述:IC ADC 24BIT RTD I SOURCE 24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7711AN | 功能描述:IC ADC 24BIT RTD I SOURCE 24-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
發布緊急采購，3分鐘左右您將得到回復。