參數資料
型號： AD7711A
廠商： Analog Devices, Inc.
英文描述： Signal Conditioning ADC with RTD Current Source(帶RTD電流源信號調節A/D轉換器)
中文描述： 信號調理ADC，具有電阻電流源（帶電阻電流源信號調節的A / D轉換器）
文件頁數： 10/27頁
文件大?。?/td> 237K
代理商： AD7711A
REV. C
AD7711A
–10–
PGA GAIN
G2
0
0
0
0
1
1
1
1
Channel Selection
CH
0
1
Power-Down
PD
0
1
Word Length
WL
0
1
RTD Excitation Current
IO
0
1
Burnout Current
BO
0
1
Bipolar/Unipolar Selection (Both Inputs)
B/U
0 Bipolar
(Default Condition After Internal Power-On Reset)
1 Unipolar
Filter Selection (FS11–FS0)
The on-chip digital filter provides a Sinc
3
(or (Sinx/x)
3
) filter response. The 12 bits of data programmed into these bits determine
the filter cutoff frequency, the position of the first notch of the filter and the data rate for the part. In association with the gain selec-
tion, it also determines the output noise (and hence the effective resolution) of the device.
The first notch of the filter occurs at a frequency determined by the relationship: filter first notch frequency = (f
CLK IN
/512)/
code
where
code
is the decimal equivalent of the code in bits FS0 to FS11 and is in the range 19 to 2,000. With the nominal f
CLK IN
of
10 MHz, this results in a first notch frequency range from 9.76 Hz to 1.028 kHz. To ensure correct operation of the AD7711A, the
value of the code loaded to these bits must be within this range. Failure to do this will result in unspecified operation of the device.
Changing the filter notch frequency, as well as the selected gain, impacts resolution. Tables I and II and Figure 2 show the effect of
the filter notch frequency and gain on the effective resolution of the AD7711A. The output data rate (or effective conversion time)
for the device is equal to the frequency selected for the first notch of the filter. For example, if the first notch of the filter is selected
at 50 Hz, then a new word is available at a 50 Hz rate or every 20 ms. If the first notch is at 1 kHz, a new word is available every 1 ms.
The settling time of the filter to a full-scale step input change is worst case 4
×
1/(output data rate). This settling time is to 100% of
the final value. For example, with the first filter notch at 50 Hz, the settling time of the filter to a full-scale step input change is
80 ms max. If the first notch is at 1 kHz, the settling time of the filter to a full-scale input step is 4 ms max. This settling time can be
reduced to 3
×
l/(output data rate) by synchronizing the step input change to a reset of the digital filter. In other words, if the step
input takes place with
SYNC
low, the settling time will be 3
×
l/(output data rate). If a change of channels takes place, the settling
time is 3
×
l/(output data rate) regardless of the
SYNC
input.
The –3 dB frequency is determined by the programmed first notch frequency according to the relationship: filter –3 dB frequency
= 0.262
×
first notch frequency.
Gl
0
0
1
1
0
0
1
1
G0
0
1
0
1
0
1
0
1
Gain
1
2
4
8
16
32
64
128
(Default Condition After the Internal Power-On Reset)
Channel
AIN1
AIN2
(Default Condition After the Internal Power-On Reset)
Normal Operation
Power-Down
(Default Condition After the Internal Power-On Reset)
Output Word Length
16-Bit
24-Bit
(Default Condition After Internal Power-On Reset)
Off
On
(Default Condition After Internal Power-On Reset)
Off
On
(Default Condition After Internal Power-On Reset)
相關PDF資料
PDF描述
AD7711 LC2MOS Signal Conditioning ADC with RTD Excitation Currents(RTD激勵電流LC2MOS信號調節A/D轉換器)
AD7714(中文) Signal Conditioning ADC(信號調節A/D轉換器)
AD7715 3 V/5 V, 450 mA 16-Bit, Sigma-Delta ADC(16位∑△A/D轉換器)
AD7716BP LC2MOS 22-Bit Data Acquisition System
AD7716BS LC2MOS 22-Bit Data Acquisition System
相關代理商/技術參數
參數描述
AD7711AAN 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog-to-Digital Converter， 24-Bit
AD7711AAR 功能描述:IC ADC 24BIT RTD I SOURCE 24SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極
AD7711AARZ 功能描述:IC ADC 24BIT RTD I SOURCE 24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
AD7711AN 功能描述:IC ADC 24BIT RTD I SOURCE 24-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:-
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*