- 您現在的位置：買賣IC網 > PDF目錄8996 > AD5432YRMZ (Analog Devices Inc)IC DAC 10BIT MULTIPLYING 10-MSOP PDF資料下載
參數資料
| 型號： | AD5432YRMZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 10/25頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 10BIT MULTIPLYING 10-MSOP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 設計資源： | Unipolar, Precision DC Digital-to-Analog Conversion Using AD5426/32/43 8-Bit to12-Bit DACs (CN0034) Precision, Bipolar Configuration for the AD5426/32/43 8-Bit to12-Bit DACs (CN0036) AC Signal Processing Using AD5426/32/43 Current Output DACs (CN0037) Programmable Gain Element Using AD5426/32/43 Current Output DACs (CN0038) |
| 標準包裝： | 50 |
| 位數： | 10 |
| 數據接口： | 串行 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 2 電流，單極；2 電流，雙極 |
| 采樣率（每秒）： | 2.5M |
| 產品目錄頁面： | 782 (CN2011-ZH PDF) |
Data Sheet
AD5426/AD5432/AD5443
Rev. G | Page 17 of 24
SINGLE-SUPPLY APPLICATIONS
Current Mode Operation
These DACs are specified and tested to guarantee operation
in single-supply applications. In the current mode circuit of
applied to VBIAS.
VOUT
GND
VIN
IOUT2
IOUT1
RFB
A1
VREF
VDD
VBIAS
VDD
C1
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE
REQUIRED IF A1 IS A HIGH SPEED AMPLIFIER.
A1
03162-044
A2
Figure 43. Single-Supply Current Mode Operation
In this configuration, the output voltage is given by
VOUT = {D × (RFB/RDAC) × (VBIAS VIN)} + VBIAS
(AD5443), the output voltage varies from
VOUT = VBIAS to VOUT = 2 VBIAS VIN
VBIAS should be a low impedance source capable of sinking and
sourcing all possible variations in current at the IOUT2 terminal
without any problems.
It is important to note that VIN is limited to low voltages because
the switches in the DAC ladder no longer have the same source
drain drive voltage. As a result, their on resistance differs, which
degrades the linearity of the DAC. See Figure 15 to Figure 20.
Voltage Switching Mode of Operation
Figure 44 shows these DACs operating in the voltage switching
mode. The reference voltage, VIN, is applied to the IOUT1 pin,
IOUT2 is connected to AGND, and the output voltage is available
at the VREF terminal. In this configuration, a positive reference
voltage results in a positive output voltage, making single-
supply operation possible. The output from the DAC is voltage
at a constant impedance (the DAC ladder resistance), thus an
op amp is necessary to buffer the output voltage. The reference
input no longer sees a constant input impedance, but one that
varies with code. Therefore, the voltage input should be driven
from a low impedance source.
VIN
R2
R1
VOUT
GND
IOUT1
RFB
A1
VREF
VDD
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE REQUIRED
IF A1 IS A HIGH SPEED AMPLIFIER.
03162-045
Figure 44. Single-Supply Voltage Switching Mode Operation
It is important to note that VIN is limited to low voltages because
the switches in the DAC ladder no longer have the same source
drain drive voltage. As a result, their on resistance differs, which
degrades the linearity of the DAC.
Also, VIN must not go negative by more than 0.3 V or an
internal diode turns on, exceeding the maximum ratings of the
device. In this type of application, the full range of multiplying
capability of the DAC is lost.
POSITIVE OUTPUT VOLTAGE
Note that the output voltage polarity is opposite to the VREF
polarity for dc reference voltages. To achieve a positive voltage
output, an applied negative reference to the input of the DAC
is preferred over the output inversion through an inverting
amplifier because of the resistor’s tolerance errors. To generate
a negative reference, the reference can be level shifted by an
op amp such that the VOUT and GND pins of the reference
become the virtual ground and 2.5 V, respectively, as shown
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE REQUIRED IF A1 IS
A HIGH SPEED AMPLIFIER.
VOUT = 0V
TO +2.5V
GND
IOUT2
IOUT1
RFB
A1
VREF
VDD = 5V
VDD
C1
GND
VIN
VOUT
ADR03
–2.5V
–5V
+5V
03162-046
Figure 45. Positive Voltage Output with Minimum of Components
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J42-MZ-F2 | CONVERTER MOD DC/DC 15V 25W |
| ICS87952AYI-147LFT | IC CLK MULT/ZD BUFFER 32-LQFP |
| MC100ES6039EGR2 | IC CLK GENERATION CHIP 20-SOIC |
| MPC961CACR2 | IC BUFFER ZD 1:18 PLL 32-LQFP |
| VE-J41-MZ-F3 | CONVERTER MOD DC/DC 12V 25W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5432YRMZ-REEL | 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型，TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:2.7M |
| AD5432YRMZ-REEL7 | 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5433 | 制造商:AD 制造商全稱:Analog Devices 功能描述:8-/10-/12-Bit, High Bandwidth, Multiplying DACs with Parallel Interface |
| AD5433YCP | 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 10-bit 20-Pin LFCSP EP 制造商:Rochester Electronics LLC 功能描述:10-BIT LOUT DAC PARELLED INT/FACE I.C. - Bulk 制造商:Analog Devices 功能描述:10BIT DAC PARALLEL I/F SMD 5433 制造商:Analog Devices 功能描述:10BIT DAC PARALLEL I/F, SMD, 5433 |
| AD5433YCP-REEL | 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 10-bit 20-Pin LFCSP EP T/R 制造商:Rochester Electronics LLC 功能描述:10-BIT LOUT DAC PARELLED INT/FACE I.C. - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。